Manual de instrucciones de Monte Carlo Fan Company 3ASR52XXD

Resumen del contenido incluido en la página 1

OWNER’S
MANUAL
Ceiling Fan Installation Instructions
Total fan weight
with light
For 3ASR52XXD Series Fans
READ AND SAVE THESE INSTRUCTIONS
QUALITY CEILING FANS

Resumen del contenido incluido en la página 2

Installation SAFETY TIPS WARNING: TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING: READ AND SAVE THESE INSTRUCTIONS 1. Installation work and electrical wiring must be done by qualified person(s) in accordance with applicable codes ANSI/NFPA 70-1999), including fire-rated construction. 2. Use this unit only in the manner intended by the manufacturer. If you have any questions contact the manufacturer. 3. After making the wire connections, the wires shoul

Resumen del contenido incluido en la página 3

7 8 9 Place canopy, canopy ring and Insert downrod into yoke on top of the Fan Tighten the 2 set screws on the Yoke then yoke cover on downrod. Body. Align the hole in the Downrod with the once the downrod is in place. Thread leadwires and safety hole in the Yoke. Insert the Pin through the cable through downrod. As Yoke and Downrod until the point appears on shown. the other side. Install the keeper to pin. Safety cable installation 11 10 12 Safety Cable Lag Screw safety cable washer lock 3”

Resumen del contenido incluido en la página 4

G Go o t to o s st te ep p 2 24 4 ffo or r L Liig gh ht t k kiit t 20 21 19 Install light plate by twisting plate Replace screw removed and tighten Loosen 2 screws with key slots and with key hole slots into place. the 3 screws securely. remove 1 screw without slot from motor plate and save screw. 22 24 23 Connect white wire from fan to white Install light plate over all thread and Attach blanking plate to fan by twist- wire from light fixture. Then plug use nut provided to secure in place. i

Resumen del contenido incluido en la página 5

31 32 33 Canopy Center Hole Larger holes Smaller holes Place canopy on top of the fan motor allowing the yoke, wires and safety cable to pass through the large hole in the center of the canopy. Align the 3 Install two screws corresponding with the Remove 2 screws in yoke and keeper larger holes around the center hole with the 3 “L” shaped holes in the canopy only part then cross pin (see insert). Remove 3 screws still installed in the fan. Install 3 screws way so that canopy can twist into pla

Resumen del contenido incluido en la página 6

43 44 45 Connect white wire from fan to white Replace screw removed and tighten Install light fixture over all thread wire from light fixture. Then plug the 3 screws securely and use nut provided to secure in black wire from fan to black wire place. from light fixture. 48 46 47 Install 1 x 100 halogen bulb E-11. Attach glass by locating dimples in Attach decorative cap to light fixture Do not touch bulb surface as oily by twisting into place. light fixture with the groves in glass residue from s

Resumen del contenido incluido en la página 7

TROUBLE SHOOTING If you have difficulty operating your new ceiling fan, it may be the result of incorrect assembly, installation, or wiring. In some cases, these installation errors may be mistaken for defects. If you experience any faults, please check this Trouble Shooting Chart. If a problem cannot be remedied, or you are experiencing difficulty in installation, please call our Customer Service Center at the number printed on your parts list insert sheet. Warning: Before servicing or cleani