Manual de instrucciones de Omega Vehicle Security SSHB

Resumen del contenido incluido en la página 1

SSHB, SRMU, SEPHB SERIES
Silicone Rubber Heating Blankets

Resumen del contenido incluido en la página 2

TABLE OF CONTENTS IMPORTANT SAFETY INSTRUCTIONS Agency Approvals 2 Introduction................................................................... SSHB series Safety Alert Symbol....................................................... 2 A person who has not read and understood all installation instructions Important Safety Instructions……………...................... 3 up to 358ºF (181ºC) 73/23/EC is not qualifi ed to install this product. (Low Voltage Directive) 4 Prior to Installation.............

Resumen del contenido incluido en la página 3

PRIOR TO INSTALLATION PRIOR TO INSTALLATION Hardware: junction box wire ties mounting hardware Read and understand this entire manual before operating this electric heater. plug if connecting heater to a receptacle rather than hard wiring to a 1. Check for suspected damage to the heating blanket like rips, punctures, etc. temperature controller or junction box. 2. Verify surface to be heated is free from all sharp edges, weld splatter, rust, oil, temperature controller and silicone RTV insulat

Resumen del contenido incluido en la página 4

MOUNTING YOUR HEATING BLANKET CONNECTING YOUR HEATING BLANKET Installation of heater using factory supplied Pressure Sensitive Adhesive TO A POWER SOURCE (PSA): 2. Most heating blankets are available with an optional high-limit safety thermostat to protect both the heater and the product being heated from 3. Peel off the release fi lm [Figure A] and then press the heater onto the surface damage if the main controlling device fails. This option is especially of the item being heated using a m

Resumen del contenido incluido en la página 5

M-4281/06 PN: 11661-01 Rev 0