Resumen del contenido incluido en la página 1
PACKAGE HEAT PUMP
INSTALLATION INSTRUCTIONS
Installer: Affix literature adjacent to the unit.
®
is a trademark of Maytag Corporation and is used under
license to Goodman Company, L.P. All rights reserved.
*NOTE: Please contact your distributor or our website
for the applicable product data book referred to in this
Goodman Company, L.P.
Part No. 10730420
2000-2004 Goodman Company, L.P.
1810 Wilson Parkway • Fayetteville, Tennessee 37334
Printed in USA
Effective: July 2004
www.amana-hac.co
Resumen del contenido incluido en la página 2
SAFETY INSTRUCTIONS RECOGNIZE SAFETY SYMBOLS, WORDS, AND LABELS The following symbols and labels are used throughout this manual to indicate immediate or potential safety hazards. It is the owner’s and installer’s responsibility to read and comply with all safety information and instructions accompanying these symbols. Failure to heed safety information increases the risk of personal injury, property damage, and/or product damage. WARNING WARNING - Hazards or unsafe practices which COULD resu
Resumen del contenido incluido en la página 3
conditioned. The loads should be calculated by an approved method GENERAL INFORMATION or in accordance with A.S.H.R.A.E. Guide or Manual J - Load Cal- culations published by the Air Conditioning Contractors of America. TO THE INSTALLER Obtain from: Before installing this unit please read this manual and the Product American National Standards Institute Data Book applicable to your model* to familiarize yourself on the 1430 Broadway specific items which must be adhered to such as maximum extern
Resumen del contenido incluido en la página 4
blower section, to allow splicing-in of field-installed wiring, or con- nect to terminal strip in unit control box. Fork Lift From See the unit wiring diagram for electrical connections. Back Of Unit ROOM THERMOSTAT C/X G Y R O W1 W2 E OUTDOOR UNIT C/X G Y R O W W1 W2 PH__C02E Wiring shown is for D9945804 (THSMEC1H2BA) thermostat. ROOM THERMOSTAT C/X G Y R O W2 E OUTDOOR UNIT C/X G Y R O W W1 W2 PH__C02E Wiring shown is for 10636701(THSADC1H2BA) or 10636702 (THSMDC1H2BA) thermostat PHD60 TWO
Resumen del contenido incluido en la página 5
ON ON CG Y R W W1 W2 O Low Voltage CAUTION Terminal Strip O AVOID PROPERTY DAMAGE OR PERSONAL INJURY DUE TO FIRE, USE T ONLY COPPER CONDUCTORS. CAUTION O PREVENT IMPROPER AND DANGEROUS OPERATION DUE TO WIRING T ERRORS, LABEL ALL WIRES PRIOR TO DISCONNECTION WHEN SERVICING CONTROLS. VERIFY PROPER OPERATION AFTER SERVICING. The best protection for the wiring is the lowest rated fuse or circuit Low Voltage Connection breaker which will supply power to the unit during normal operation Heater Kit Co
Resumen del contenido incluido en la página 6
require that cover clips (included with the unit) be installed to en- sure a secure fit of the Horizontal Duct Covers. 24, 30, 36, 42 AND PHB48 Models: Remove 1. Remove and set aside the four (4) supply air side screws. 2. Remove and set aside the two (2) return air side screws. REMOVE SCREWS REMOVE SCREWS Loosen Duct Removal 3. Remove the clamp securing the blower assembly to the bottom of the unit. Discard clamp and screws. SUPPLY AIR RETURN AIR Supply Air Side Screws Removal 3. Center flang
Resumen del contenido incluido en la página 7
Even though a return air filter is not supplied with this unit, there CLIPS must be a means of filtering all return air. Refer to the following table or the Product Data Book applicable to your model* for filter size information. RATED DISPOSABLE PERMANENT COOLING MODEL 2 1 2 2 AIRFLOW FILTER (ft ) FILTER (ft ) (CFM) PHB24C02* 3.0 1.5 850 PHB30C02* 3.4 1.7 960 SELF-DRILLING SCREWS PHB36C02* 4.0 2 1170 Cover Clip Installation PHB42C02* 4.5 2.3 1350 3. Attach 16x16 horizontal covers using screws
Resumen del contenido incluido en la página 8
OPERATING INSTRUCTIONS 1. Turn ON the electrical power supply to the unit. 2. Place the room thermostat selector switch in the COOL or HEAT position (or AUTO if available, and if automatic changeover from cooling to heating is desired). 3. Set the room thermostat to the desired temperature. 1-1/2" Minimum drop at outlet MAINTENANCE 90° ELL Condensate WARNING 2-1/2" of Drain Trap 3/4" PVC O AVOID PERSONAL INJURY OR DEATH DUE TO ELECTRICAL SHOCK, T Figure 13 - Condensate Drain Connection DISCONN
Resumen del contenido incluido en la página 9
ACCESSORIES Horizontal Duct Covers (CHK001A) Single Point Power Connections (SPK**A) Roof Curb - Heat Pump (PRC06A1) Roof Curb - Universal (PRC08A1) Over-Under to Side by Side (PDTROU4A) Over-Under to Side by Side (PDTROU6A) Additional accessories, as described above, can be purchased to fit specific application needs. Accessories can be ordered by the part numbers in the table and each accessory includes its own separate instructions. REPLACEMENT PARTS Refer to the description in the Parts Cata
Resumen del contenido incluido en la página 10
Y O O W2 R R DFT C PHB[24-36]C02* DF1 DF2 G W O Y R C XFMR R R XFMR C C G DFT R R W2 O O Y C 10 WARNING TO PREVENT PROPERTY DAMAGE, PERSONAL INJURY OR DEATH, DISCONNECT ELECTRICAL POWER TO THIS FURNACE BEFORE SERVICING OR PERFORMING MAINTENANCE. ELECTRIC GND 208 VOLT INSTALLATION FI E L D CONNEC TI O N HEAT T R AN SF O R M E R FOR PROPER OPERATION ON 208 VOLT THE RELAY 208/2 30 V AC 1Ø FOLLOWING CHANGE MUST BE MADE: COM VT-7 MOVE RD6 WIRE FROM TRANSFORMER GND W2 W1GE C R WO Y LINE ELECTRIC LOAD
Resumen del contenido incluido en la página 11
Y O O W2 R R DFT C PHB[42-48]C02** DF1 DF2 G W O Y R C XFMR R R XFMR C C G DFT R R W2 O O Y C 11 WARNING TO PREVENT PROPERTY DAMAGE, PERSONAL INJURY OR DEATH, DISCONNECT ELECTRICAL POWER TO THIS FURNACE BEFORE SERVICING OR PERFORMING MAINTENANCE. ELECTRIC GND 208 VOLT INSTALLATION FI E L D CONNE CT IO N HEAT T R AN SF O R M E R FOR PROPER OPERATION ON 208 VOLT THE 208/230 VAC 1Ø RELAY FOLLOWING CHANGE MUST BE MADE: COM VT-7 MOVE RD6 WIRE FROM TRANSFORMER GND W2 W1GE C R WO Y LINE ELECTRIC LOAD R
Resumen del contenido incluido en la página 12
O O R R R R D DF FT T C C Y Y O O W W2 2 COOL ADJUST HE AT A A NORM + B B ( ) C C (-) CUT TO TEST D D ENABLE DE HUM IDIFY PHB60 / PHD48C02** DF DF1 1 DF DF2 2 G G W W O O Y Y R R C C DFT R R W2 O O Y C 12 WARNING TO PREVENT PROPERTY DAMAGE, PERSONAL INJURY OR DEATH, DISCONNECT ELECTRICAL POWER TO THIS FURNACE BEFORE SERVICING OR PERFORMING MAINTENANCE. GND 208 VOLT INSTALLATION FI E L D CONNE CT IO N T R AN SF O R M E R 208/230 V A C 1 Ø FOR PROPER OPERATION ON 208 VOLT THE COM FOLLOWING CHANGE
Resumen del contenido incluido en la página 13
Y O O W2 R R DFT C PHD[24-36]C02** DF1 DF2 G W O Y R C XFMR R R XFMR C C G DFT R R W2 O O Y C 13 WARNING TO PREVENT PROPERTY DAMAGE, PERSONAL INJURY OR DEATH, DISCONNECT ELECTRICAL POWER TO THIS FURNACE BEFORE SERVICING OR PERFORMING MAINTENANCE. ELECTRIC GND 208 VOLT INSTALLATION FI E L D CONNE CT IO N HEAT T R AN SF O R M E R FOR PROPER OPERATION ON 208 VOLT THE 208/230 V A C 1 Ø RELAY 208/230 V A C 1 FOLLOWING CHANGE MUST BE MADE: COM VT-7 MOVE RD6 WIRE FROM TRANSFORMER GND W2 W1GE C R WO Y L
Resumen del contenido incluido en la página 14
O O R R R R D DF FT T C C Y Y O O W W2 2 ADJUST COOL HE AT NORM A A ( )+ B B (-) C C CUT TO D TEST D ENABLE DE HUM IDIFY PHD42C02** DF DF1 1 DF DF2 2 G G W W O O Y Y R R C C DFT R R W2 O O Y C 14 WARNING TO PREVENT PROPERTY DAMAGE, PERSONAL INJURY OR DEATH, DISCONNECT ELECTRICAL POWER TO THIS FURNACE BEFORE SERVICING OR PERFORMING MAINTENANCE. GND 208 VOLT INSTALLATION FI E L D CO NNEC TI O N T R AN SF O R M E R 208/230 V AC 1 FOR PROPER OPERATION ON 208 VOLT THE Ø COM FOLLOWING CHANGE MUST BE M
Resumen del contenido incluido en la página 15
O O R R R R D DF FT T C C Y Y O O W W2 2 COOL ADJUST HE AT A A NORM + B B ( ) C C (-) CUT TO TEST D D ENABLE DE HUM IDIFY 3 1 5 2 4 PHD60C02** 3 1 5 2 4 DF DF1 1 DF DF2 2 Y1 G G W W O O Y2 R R C C DFT R R W2 O O Y C 15 WARNING TO PREVENT PROPERTY DAMAGE, PERSONAL INJURY OR DEATH, DISCONNECT ELECTRICAL POWER TO THIS FURNACE BEFORE SERVICING OR PERFORMING MAINTENANCE. VT-14 GND FI E L D CONNE CT IO N 208 VOLT INSTALLATION T R AN SF O R M E R FOR PROPER OPERATION ON 208 VOLT 208/230 V A C 1 Ø THE F
Resumen del contenido incluido en la página 16
R DFT Y O O W2 R C PHB[24-36]CC2** DF1 DF2 G W O Y R C 16 WARNING TO PREVENT PROPERTY DAMAGE, PERSONAL INJURY OR DEATH, DISCONNECT ELECTRICAL POWER TO THIS FURNACE BEFORE SERVICING OR PERFORMING MAINTENANCE. GND 208 VOLT INSTALLATION T R AN SF O R M E R FOR PROPER OPERATION ON 208 VOLT THE FOLLOWING CHANGE MUST BE MADE: COM VT-7 MOVE RD6 WIRE FROM TRANSFORMER LINE LOAD RD-6 230 TERMINAL TO 208 TERMINAL. 230 208 T1 L1 CAPACITOR GY-9 CO N TACT OR (CC ) COMMON (CAP) A IR 1 VT-14(COMMON) T2 L2 BR
Resumen del contenido incluido en la página 17
R DFT Y O O W2 R C PHD[24-36]CC2** DF1 DF2 G W O Y R C 17 GND 208 VOLT INSTALLATION T R AN SF O R M E R FOR PROPER OPERATION ON 208 VOLT THE FOLLOWING CHANGE MUST BE MADE: COM VT-7 MOVE RD6 WIRE FROM TRANSFORMER LINE LOAD RD-6 230 TERMINAL TO 208 TERMINAL. 230 208 T1 L1 CAPACITOR GY-9 CO N TAC TO R (CC ) (CAP) COMMON VT-14(COMMON) A IR 1 T2 L2 HI BR C IRCU LAT IO N 2 RD-24(COOL) VT-14 B LOW ER 3 MED HI RD-11 BR USE COPPER 4 (ACB) BU-23(HEAT) MED LOW GY-9 CONDUCTORS 5 LOW 6 ONLY- BU-23 VT LOW
Resumen del contenido incluido en la página 18
CLEARANCES WARNING TO AVOID PROPERTY DAMAGE, PERSONAL INJURY OR DEATH DUE TO FIRE, CLEARANCES TO COMBUSTIBLE SURFACES LISTED 36" Maximum AS SHOWN MUST BE OBSERVED. Overhang 48" Minimum 36" Side Overhang Clearance for Servicing Recommended Vinyl Coated 24" Clearance Canvas (Condenser End) Connections Insulate Return Duct Insulated Minimum 9" Clearance Supply to Combustibles Duct 36" Clearance for 0" Minimum Service Required Clearance to Combustibles 18
Resumen del contenido incluido en la página 19
19
Resumen del contenido incluido en la página 20
2000-2004 Goodman Company, L.P. Effective: July 2004 20
