Manual de instrucciones de Graco Inc. Contractor 288477

Resumen del contenido incluido en la página 1

Instructions-Parts
Contractor & FTx Spray Guns
Contractor Models: 288420, 288421, 288425, 288475, 288477, 288478, 826085, 288009
FTx Models: 288427, 288428, 288429, 288430, 288431, 288436, 288438, 288477,
311861G
288478, 826086, 288008,262114, 262116
For the application of architectural paints and coatings.
Maximum Working Pressure: 3600 psi (248 bar, 24.8 MPa)
IMPORTANT SAFETY INSTRUCTIONS. Read all
warnings and instructions in this manual. Refer to your
sprayer instruction manual for Pressu

Resumen del contenido incluido en la página 2

WARNING EQUIPMENT MISUSE HAZARD Misuse can cause death or serious injury. � Do not operate the unit when fatigued or under the influence of drugs or alcohol. � Do not exceed the maximum working pressure or temperature rating of the lowest rated system component. See Technical Data in all equipment manuals. � Use fluids and solvents that are compatible with equipment wetted parts. See Technical Data in all equipment manuals. Read fluid and solvent manufacturer’s warnings. For complete informa

Resumen del contenido incluido en la página 3

Parts Aligning Spray Clearing Clogs 1. Relieve pressure. Set trigger lock (2). Loosen guard 1. Relieve pressure. Set trigger lock (2). retaining nut. 2. Rotate tip (26) 180°. Unlock trigger lock (2). Trigger gun 2. Loosen guard retaining nut. into pail or onto ground to remove clog. 3. Align guard (25) horizontally to spray a horizontal pattern. 3. Set trigger lock (2). Rotate tip (26) 180° back to spray 4. Align guard (25) vertically to spray a vertical pattern. position. (3) Horizontal (4) V

Resumen del contenido incluido en la página 4

Maintenance Failure to clean or replace the filter or damaged handle bore can result in serious injury. 1. Relieve pressure. Set trigger lock (2). Before performing any maintenance on gun, read all warnings 2. Remove tip (26) and guard (25) from gun (1). on front cover of this manual and relieve pressure. 3. Disconnect fluid hose from gun at swivel (8). 4. Remove nut (17) and trigger pin (16). Cleaning/Replacing Filter (5) 5. Unscrew diffuser (15a) from front of gun (1). A plugged filter reduc