Resumen del contenido incluido en la página 1
™
INTEGRATED HUMIDIFIER
SETTING UP THE S8
B D
™
S8 AutoSet Spirit System
Component of 338193/1
ILLUSTRATIONS
SYSTEM COMPONENTS
A
™
HumidAire 3i
Carry
handle
1 2
LCD
Keypad
screen
OTHER ACCESSORIES
C
Air outlet
1
3 m
1 2 3
Air filter
cover
Module
3
Air inlet
DC input
AC input
2
4 5
2 m
34 5
4
Note: Some products not available in all regions
© 2005 ResMed Ltd.
© 2005 ResMed Ltd. © 2005 ResMed Ltd.
© 2005 ResMed Ltd.
Resumen del contenido incluido en la página 2
USING THE DATA CARD HUMIDAIRE 3i AND S8 E H 1 2 HumidAire 3i BLANK MODULE F Data communications port 3 1 2 DATA CARD MODULE G 12 Note: Some products not available in all regions © 2005 ResMed Ltd. © 2005 ResMed Ltd. © 2005 ResMed Ltd. © 2005 ResMed Ltd.
Resumen del contenido incluido en la página 3
™ S8 AutoSet Spirit System Reorder number: 338193/1 05 05 USER’S MANUAL English
Resumen del contenido incluido en la página 4
Manufactured by: ResMed Ltd 1 Elizabeth Macarthur Drive Bella Vista NSW 2153 Australia Tel: +61 (2) 8884 1000 or 1 800 658 189 (toll free) Fax: +61 (2) 8883 3114 Email: reception@resmed.com.au Distributed by: ResMed Corp 14040 Danielson Street Poway CA 92064-6857 USA Tel: +1 (858) 746-2400 or 1-800-424-0737 (toll free) Fax: +1 (858) 746-2900 Email: reception@resmed.com ResMed (UK) Limited 65 Milton Park Abingdon Oxfordshire OX14 4RX UK Tel: +44 (1235) 862 997 Fax: +44 (1235) 831 336 Email:
Resumen del contenido incluido en la página 5
CONTENTS INTRODUCTION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 YOUR RESPONSIBILITY 1 MEDICAL INFORMATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 ABOUT THE S8 AUTOSET SPIRIT 1 CONTRAINDICATIONS 1 WARNINGS 2 CAUTIONS 3 ADVERSE EFFECTS 3 THE S8 AUTOSET SPIRIT SYSTEM . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 S8 AUTOSET SPIRIT 5 MASKS 5 HUMIDIFIER 6 RESSCAN DATA CARD MODUL
Resumen del contenido incluido en la página 6
CLEANING AND MAINTENANCE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 27 DAILY CLEANING 27 WEEKLY CLEANING 27 PERIODIC CLEANING 27 REPLACING THE AIR FILTER 28 SERVICING 28 FREQUENTLY ASKED QUESTIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 29 TROUBLESHOOTING . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 31 SYSTEM SPECIFICATIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 35 S8
Resumen del contenido incluido en la página 7
INTRODUCTION Thank you for choosing the S8 AUTOSET SPIRIT™ flow generator. The S8 AUTOSET SPIRIT is a compact, all-in-one package with an inbuilt power supply and the option of integrated data management and humidification. This user manual contains the information you need for the correct use of your S8 AUTOSET SPIRIT. YOUR RESPONSIBILITY The owner or user of this system shall have sole responsibility and liability for any injury to persons or damage to property resulting from: • operation
Resumen del contenido incluido en la página 8
• cerebrospinal fluid leak, recent cranial surgery, or trauma. WARNINGS • The entire manual should be read before using the S8 AUTOSET SPIRIT. • Advice contained in this manual should not supersede instructions given by the prescribing physician. • A patient should not connect a device to the data communication port unless instructed to do so by their health care provider or physician. Only ResMed products are designed to be connected to the data communication port. Connecting other devices
Resumen del contenido incluido en la página 9
will vary, depending on where the oxygen is introduced, the pressure settings, patient breathing pattern, mask selection, and leak rate. • Do not use the S8 AUTOSET SPIRIT if there are obvious external defects or unexplained changes in performance. • Do not open the S8 AUTOSET SPIRIT case. There are no user serviceable parts inside. Repairs and internal servicing should only be performed by an authorised service agent. • Explosion hazard—do not use in the vicinity of flammable anaesthetics.
Resumen del contenido incluido en la página 10
4
Resumen del contenido incluido en la página 11
THE S8 AUTOSET SPIRIT SYSTEM The S8 AUTOSET SPIRIT device is part of a system that consists of five elements: • S8 AUTOSET SPIRIT self-adjusting flow generator • Mask • Humidifier • Data management products • Accessories. S8 AUTOSET SPIRIT Please refer to the illustrations in section A of the illustration sheet. FRONT VIEW (A-1) Shows the keypad and LCD screen, and the air outlet. REAR VIEW (A-2) Shows where the module attaches, and the location of the air filter and power sockets. POWER CORD (
Resumen del contenido incluido en la página 12
• ULTRA MIRAGE™ FULL FACE MASK. Note: Not all masks are available in all regions. WARNING ! In AutoSet mode, only ResMed mask systems are compatible for use with the S8 AutoSet Spirit. Please refer to “Warnings” on page 2. HUMIDIFIER Please refer to the illustration in section B of the illustration sheet. A humidifier may be required if you are experiencing dryness of the nose, throat, or mouth. The S8 AUTOSET SPIRIT is compatible for use with the HUMIDAIRE 3i™ integrated heated humidifier.
Resumen del contenido incluido en la página 13
HOW TO USE THE S8 AUTOSET SPIRIT Please refer to the illustrations in section D of the illustration sheet. SET UP THE S8 AUTOSET SPIRIT 1 Place the S8 AUTOSET SPIRIT on a table near the head of your bed. CAUTION ! Be careful not to place the device where it can be bumped or where someone is likely to trip over the power cord. Note: You can also place your S8 AutoSet Spirit on the floor beside or underneath your bed. Ensure that the area is free from dust and clear of bedding, clothes or any ot
Resumen del contenido incluido en la página 14
START TREATMENT 1 Make sure the power is on. A welcome message is displayed briefly on the LCD screen, then the standby screen appears. In CPAP mode, the standby screen displays the word “RAMP”. In AutoSet mode, the standby screen displays the word “SETTLING”. The key and LCD backlights also turn on. 2 Lie down and arrange the air tubing so that it is free to move if you turn in your sleep. CAUTION ! • Do not leave long lengths of air tubing around the top of your bed. They could twist aroun
Resumen del contenido incluido en la página 15
STOPPING TREATMENT To stop treatment at any time, remove your mask and press the Start/Stop key or if your clinician has enabled SmartStart, simply remove your mask and treatment will end. USING THE MASK-FITTING FEATURE You can use the S8 AUTOSET SPIRIT mask-fitting feature to help you fit your mask properly. This feature delivers air pressure for a three-minute period, prior to starting treatment, during which you can check and adjust your mask fit to minimise leaks. Note: Make sure that th
Resumen del contenido incluido en la página 16
4 After three minutes, the pressure reverts to the set pressure and treatment will begin. • If you do not wish to wait three minutes, hold down the Start/Stop key for at least three seconds to start treatment immediately. • If you press the Start/Stop key for less than three seconds, the unit will return to standby mode (the RAMP or SETTLING screen is displayed). Table 1: Definitions of Mask-Fit Star Rating Star rating Definition ***** Excellent ****- Very good ***-- Good **--- Adjust mask *--
Resumen del contenido incluido en la página 17
HOW TO ATTACH A HUMIDIFIER ATTACH A HUMIDAIRE 3i HUMIDIFIER Please refer to the illustration in section E of the illustration sheet, and your HumidAire 3i manual. The HUMIDAIRE 3i attaches to the front of the S8 AUTOSET SPIRIT to provide heated humidification. No other accessories are required for its use. Notes: a. Make sure the water chamber of the HumidAire 3i is empty before you attach or detach the humidifier. b. Remove the connector plug on the S8 AutoSet Spirit before you attach the
Resumen del contenido incluido en la página 18
12
Resumen del contenido incluido en la página 19
HOW TO USE THE KEYPAD The control panel of the S8 AUTOSET SPIRIT includes an LCD screen and keypad for navigating through the menus and delivering treatment. LCD screen Up key Right key Left key Start/Stop key Down key LCD SCREEN The LCD screen displays the menus and treatment screens. The LCD backlight turns off after two minutes of inactivity. It turns back on when you press a key. KEYPAD KEYS The S8 AUTOSET SPIRIT keypad has the following keys: Key Function Start/Stop • Starts or stops tre
Resumen del contenido incluido en la página 20
When the S8 device is in standby mode all keys remain lit. During therapy, the keypad backlight turns off after two minutes of inactivity and the Start/Stop key dims. HOW TO CHANGE THE SETTINGS You can change settings on the S8 AUTOSET SPIRIT by using the keypad and LCD. When the S8 AUTOSET SPIRIT is in standby mode you can display a series of screens (a menu) on the LCD screen in order to view and change the settings for a particular function. Your clinician will preset the menu to either
