Resumen del contenido incluido en la página 1
Traulsen & Co., Inc.
Quality Refrigeration
Quality Refrigeration
OWNER’S MANUAL
Instructions for the installation, operation,
and maintenance of all Compact Undercounter
and Prep Table Models:
UHT27 ULT27 UPT276 UPT488 UPT6012
UHT48 ULT48 UPT279 UPT4812 UPT6018
UHT60 ULT60 UPT4818 UPT6024
This Traulsen unit is built to our highest quality standards. We build our refrigerators, freezers and heated
cabinets this way as a matter of pride. This philosophy has made Traulsen the leader in commercia
Resumen del contenido incluido en la página 2
TABLE OF CONTENTS I. THE SERIAL TAG Page 1 V. CARE & MAINTENANCE II. RECEIPT INSPECTION Page 2 a-Cleaning The Exterior Page 7 III. INSTALLATION b-Cleaning The Interior Page 7 a-Location Page 2 c-Cleaning The Condenser Coil Page 7 b-Packaging Page 2 d-Condensate Removal System Care Page 7 c-Installing Legs or Casters Page 2/3 e-Cleaning The Interior Page 7 d-Installing Shelf Clips Page 3 VI. MISC. OPERATIONS e-Cord & Plug Page 3 a-Rehinging The Door Page 8 f-Power Supply Page 3 b-Preparing For E
Resumen del contenido incluido en la página 3
II. RECEIPT INSPECTION III. INSTALLATION (continued) All Traulsen products are factory tested for perfor- III. c - INSTALLING LEGS OR CASTERS (cont'd): mance and are free from defects when shipped. The the factory inside a cardboard box which is secured utmost care has been taken in crating this product to inside the cabinet. Casters in lieu of legs are supplied protect against damage in transit. All interior fittings as an optional accessory for all compact undercounter have been carefully s
Resumen del contenido incluido en la página 4
III. INSTALLATION (continued) III. c - INSTALLING LEGS OR CASTERS (cont'd): III. h - CLEARANCE: It is important for the proper operation and longevity Please note that Traulsen units are not designed to of your Traulsen unit that it have adequate provisions be moved while on legs. If the unit requires moving, underneath for air supply to the compressor. There a pallet jack or forklift should be used to prevent are no clearance requirements for the sides, rear or damage. top. III. d - SHELF CLI
Resumen del contenido incluido en la página 5
III. INSTALLATION (continued) III. i - OPTIONAL UTILITY BASE (cont'd): III. j - OPTIONAL STACKING KIT (cont'd): 3. Assemble four 1/2 –13 bolts and lockwashers 8. Install front grill on front of stacking base with through holes in utility base and into threaded eight 8 – 18 self-tapping screws. holes in bottom of unit where legs or casters would be installed. 4. Place rear cover on back of utility base so D-slot captures the groove of the strain relief. Attach rear cover with six 8 – 18 self-tap
Resumen del contenido incluido en la página 6
III. INSTALLATION (continued) III. k - SANDWICH PREP TOP ASSEMBLY: On sandwich prep tables (see figure8), the top shelf, cutting board, and cover may require assembly at the site. 1. Place the shelf on top of the rear of the unit. Secure by screwing 4 threaded pins through base of shelf and top of unit (see figure 9). 2.Install cutting board support. Secure with 2 threaded pins and 2 bolts per flange(see figure 9) (wider units may be equipped with an additional third pin in the center). 3. Asse
Resumen del contenido incluido en la página 7
III. INSTALLATION (continued) IV. OPERATION III. l - INSTALLING THE STAINLESS STEEL TOP: IV. a - PRESTART CHECKS: All 27", 48" and 60" wide compact undercounter The compressor must float freely before connecting models can be supplied with an optional stainless to electrical power. The compressor motor is steel top. This must be installed on-site, to do so provided with rubber vibration isolator mounts (no please follow the directions below (see figure 10): springs). No bolts need to be loos
Resumen del contenido incluido en la página 8
IV. OPERATION V. CARE AND MAINTENANCE: IV. c - DEFROST CONTROL (CONT'D): V. a - CLEANING THE EXTERIOR: compressor restarts. The next defrost cycle will Exterior stainless steel should be cleaned with warm start in about 5 hours 40 minutes. On models water, mild soap and a soft cloth. Apply with a damp- ULT27, ULT48 and ULT60, the defrost time control is ened cloth and wipe in the direction of the metal grain. located on the right side of the evaporator housing, behind the temperature control
Resumen del contenido incluido en la página 9
○○○○○○ ○○○○○○ VI. MISC. OPERATIONS VI. a - REHINGING THE DOOR (cont'd): VI. a - REHINGING THE DOOR: To reinstall the door, position the lower hinge plate The door(s) on all UHT, ULT & UPT models can be eas- into the position of being open 90° to the cabinet. ily rehinged in the field. To begin, open the door to its Place the top hinge plate pin in the hole in the top of maximum position. Support the non-hinged end of the door and support the other end of the door for the door so minimum moveme
Resumen del contenido incluido en la página 10
VII. OTHER VII. a - SERVICE INFORMATION: Before calling for service, please check the following: Is the electrical cord plugged in? Is the fuse OK or circuit breaker on? Is the power switch “ON”? If after checking the above items and the unit is still not operating properly, please contact an authorized Traulsen service agent. A complete list of authorized service agents was provided along with your Traulsen unit. If you cannot locate this, you may also obtain the name of a service agent from
Resumen del contenido incluido en la página 11
VIII. TROUBLESHOOTING GUIDE FIND YOUR PROBLEM HERE REMEDY 1. Condensing unit fails to start. a. Check if cord & plug has been disconnected. b. Check thermostat temperature setting. 2. Condensing unit operates for a. Are doors closing properly? prolonged periods or continuously. b. Dirty condenser or filter. Clean properly. c. Evaporator coil iced. Needs to defrost. d. Shortage of refrigerant, call service. 3. Food compartment is too warm. a. Check door(s) and gasket
Resumen del contenido incluido en la página 12
IX. PARTS LIST PART NAME PART # DESCRIPTION Back, Finished SER-60310-00 Optional Stainless Steel Finished Back For 27" Wide Models Only Casters, 6" High SER-60275-00 Optional Set of Four (4) 6" High Casters For All 27" Wide Models Casters, 6"" High SER-60276-00 Optional Set of Six (6) 6" High Casters For All 48" & 60" Wide Models Casters, 3-1/2" High SER-60277-00 Optional Set of Four (4) 3-1/2" High Caster For All 27" Models Casters, 4" High SER-60308-00 Optional Set of Four (4) 4" High Ca
Resumen del contenido incluido en la página 13
X. WARRANTY INFORMATION STANDARD DOMESTIC WARRANTY TRAULSEN & CO., INC. warrants new equipment to the original purchaser, when installed within the United States against defective material and workmanship for one (1) year from the date of original installation. Under this warranty, TRAULSEN & CO., INC. will repair or replace, at its option, including service and labor, all parts found to be defective and subject to this warranty. The compressor part is warranted for an additional four (4) years.
Resumen del contenido incluido en la página 14
-13-
Resumen del contenido incluido en la página 15
XI. INDEX A R Rehinging The Door 8 B Return Authorization 2 C S Cleaning, The Exterior 7 Sealant, Silicone 4 Cleaning, The Interior 7 Serial Tag 1 Casters 2, 3 Shelf Clips 3 Condensate Evaporator 7 Shelves 3 Cord & Plug 3 Stacking Kit, Installing 4 Condenser Coil, Cleaning 7 Stainless Steel Top, Installing 6 Condenser, Performance 2 Clearance 2, 3 T Condensate Loop 7 Thermostat 7 Cutting Board 5 U D Utility Base 4 Defrost Control 6 Divider Bars 7 V E W Evaporator Coil 7 Warranty 9 Extended Shutd
Resumen del contenido incluido en la página 16
HOURS OF OPERATION: Monday thru Friday 7:30 am - 4:30 pm CST Traulsen & Co., Inc. Traulsen & Co., Inc. 4401 Blue Mound Rd. - Fort Worth, TX 76106 4401 Blue Mound Road Fort Worth, TX 76106 (800) 825-8220 or (817) 625-9671 Fax - Mktg. (817) 624-4302 Phone: (800) 825-8220 Fax-Svce: (817) 740-6757 Visit our on-line repair service directory at www.traulsen.com Website: www.traulsen.com Quality Refrigeration
