Resumen del contenido incluido en la página 1
REFRIGERATOR USER INSTRUCTIONS
THANK YOU for purchasing this high-quality product. If you should experience a problem not covered in TROUBLESHOOTING,
please visit our website at www.amana.com for additional information. If you still need assistance, call us at 1-800-843-0304. In
Canada, visit our website at www.amanacanada.ca or call us at 1-800-807-6777.
You will need your model and serial number, located on the inside wall of the refrigerator compartment.
Table of Contents / Índice /
Resumen del contenido incluido en la página 2
IMPORTANT SAFETY INSTRUCTIONS WARNING: To reduce the risk of fire, electric shock, or injury when using your refrigerator, follow these basic precautions: ■ Plug into a grounded 3 prong outlet. ■ Use nonflammable cleaner. ■ Do not remove ground prong. ■ Keep flammable materials and vapors, such as gasoline, away from refrigerator. ■ Do not use an adapter. ■ Use two or more people to move and install refrigerator. ■ Do not use an extension cord. ■ Disconnect power before installing ice maker (
Resumen del contenido incluido en la página 3
Location Requirements Electrical Requirements WARNING WARNING Explosion Hazard Electrical Shock Hazard Keep flammable materials and vapors, such as Plug into a grounded 3 prong outlet. gasoline, away from refrigerator. Do not remove ground prong. Failure to do so can result in death, explosion, or fire. Do not use an adapter. Do not use an extension cord. To ensure proper ventilation for your refrigerator, allow for ¹⁄₂" (1.25 cm) space on each side and at the top. When installing your Failure
Resumen del contenido incluido en la página 4
6. Fasten the shutoff valve to the cold water pipe with the pipe Water Pressure clamp. Be sure the outlet end is solidly in the ¹⁄₄" (6.35 mm) drilled hole in the water pipe and that the washer is under the pipe clamp. Tighten the packing nut. Tighten the pipe clamp A cold water supply with water pressure of between 30 and screws slowly and evenly so the washer makes a watertight 120 psi (207 and 827 kPa) is required to operate the water dispenser and ice maker. If you have questions abou
Resumen del contenido incluido en la página 5
REFRIGERATOR USE Using the Controls For your convenience, your refrigerator controls are preset at the A B C D E F G factory. When you first install your refrigerator, make sure that the controls are still preset. The Refrigerator Control and the Freezer A. Refrigerator water tubing E. Ferrule (purchased) Control should both be set to the “mid-settings.” B. Nut (provided) F. Nut (purchased) C. Bulb G. Household water line Style 1: Rotary Controls D. Coupling (purchased) 4. Turn shutoff val
Resumen del contenido incluido en la página 6
If you need to adjust temperatures in the refrigerator or freezer, ■ Slide the door chill control to the left to reduce the flow of cold use the settings listed in the chart below as a guide. Wait at least air to the bin and make it less cold. 24 hours between adjustments. ■ Slide the door chill control to the right to increase the flow of cold air to the bin and make it colder. CONDITION/REASON: ADJUSTMENT: REFRIGERATOR too warm REFRIGERATOR Control Water and Ice Dispensers one setting high
Resumen del contenido incluido en la página 7
To Dispense Ice: 1. Press the button to select the desired type of ice. Ice Maker and Storage Bin (on some models) WARNING Turning the Ice Maker On/Off Style 1 ■ To turn ON the ice maker, simply lower the wire shutoff arm. ■ To manually turn off the ice maker, lift the wire shutoff arm to the OFF (arm up) position and listen for the click. Ice can still be dispensed, but no more can be made. Cut Hazard NOTE: Your ice maker has an automatic shutoff. As ice is made, Use a sturdy glass when disp
Resumen del contenido incluido en la página 8
4. Replace the bin by pushing it in all the way or the dispenser Water Filter Status Light (on some models) will not work. 5. To restart ice production, push the wire shutoff arm down to The water filter status light will help you know when to change the ON position. Make sure the door is closed tightly. your water filter. The light will change from green to yellow. This Style 2 tells you that it is almost time to change the filter. It is 1. Hold the base of the storage bin with both hands
Resumen del contenido incluido en la página 9
5. There is no need for routine condenser cleaning in normal home operating environments. If the environment is Changing the Light Bulbs particularly greasy or dusty, or there is significant pet traffic in NOTE: Not all bulbs will fit your refrigerator. Be sure to replace the the home, the condenser should be cleaned every 2 to bulb with one of the same size, shape and wattage. On some 3 months to ensure maximum efficiency. models, the dispenser light requires a heavy duty 10-watt bulb. Al
Resumen del contenido incluido en la página 10
The doors are difficult to open Ice and Water The ice maker is not producing ice or not enough ice WARNING ■ Refrigerator connected to a water supply and the supply shutoff valve turned on? Connect refrigerator to water supply and turn water shutoff valve fully open. ■ Kink in the water source line? A kink in the line can reduce water flow. Straighten the water source line. ■ Ice maker turned on? Make sure wire shutoff arm or switch Explosion Hazard (depending on model) is in the ON positi
Resumen del contenido incluido en la página 11
The ice dispenser will not operate properly The water dispenser will not operate properly ■ Freezer door closed completely? Close the door firmly. If it ■ Freezer door closed completely? Close the door firmly. If it does not close completely, see “The doors will not close does not close completely, see “The doors will not close completely.” completely.” ■ Ice bin installed correctly? Be sure the ice bin is firmly in ■ Refrigerator connected to a water supply and the supply position. shutoff v
Resumen del contenido incluido en la página 12
WATER FILTER CERTIFICATIONS 12
Resumen del contenido incluido en la página 13
PERFORMANCE DATA SHEETS Base Grille Water Filtration System Model T2WG2L/T2RFWG2 Capacity 200 Gallons (757 Liters) Model T2WG2/T2RFWG2 Capacity 200 Gallons (757 Liters) System tested and certified by NSF International against NSF/ANSI Standard 42 for the reduction of Chlorine Taste and Odor, Particulate Class II*; and against NSF/ANSI Standard 53 for the reduction of Mercury, Benzene, Toxaphene, O-dichlorobenzene, and Carbofuran. This system has been tested according to NSF/ANSI Standards 42
Resumen del contenido incluido en la página 14
Base Grille Water Filtration System Model T1WG2L/T2RFWG2 Capacity 200 Gallons (757 Liters) Model T1WG2/T2RFWG2 Capacity 200 Gallons (757 Liters) System tested and certified by NSF International against NSF/ANSI Standard 42 for the reduction of Chlorine Taste and Odor, Particulate Class II*; and against NSF/ANSI Standard 53 for the reduction of Mercury, Benzene, Toxaphene, O-dichlorobenzene, and Carbofuran. This system has been tested according to NSF/ANSI Standards 42 and 53 for the reductio
Resumen del contenido incluido en la página 15
Base Grille Water Filtration System Model P2WG2L/P2RFWG2 Capacity 200 Gallons (757 Liters) Model P2WG2/P2RFWG2 Capacity 200 Gallons (757 Liters) System tested and certified by NSF International against NSF/ANSI Standard 42 for the reduction of Chlorine Taste and Odor, Particulate Class I*; and against NSF/ANSI Standard 53 for the reduction of Lead, Mercury, Benzene, Toxaphene, and O-dichlorobenzene. This system has been tested according to NSF/ANSI Standards 42 and 53 for the reduction of th
Resumen del contenido incluido en la página 16
Base Grille Water Filtration System Model P1WG2L/P2RFWG2 Capacity 200 Gallons (757 Liters) Model P1WG2/P2RFWG2 Capacity 200 Gallons (757 Liters) System tested and certified by NSF International against NSF/ANSI Standard 42 for the reduction of Chlorine Taste and Odor, Particulate Class I*; and against NSF/ANSI Standard 53 for the reduction of Lead, Mercury, Benzene, Toxaphene, and O-dichlorobenzene. This system has been tested according to NSF/ANSI Standards 42 and 53 for the reduction of th
Resumen del contenido incluido en la página 17
® AMANA MAJOR APPLIANCE WARRANTY LIMITED WARRANTY For one year from the date of purchase, when this major appliance is operated and maintained according to instructions attached to or furnished with the product, Amana brand of Whirlpool Corporation or Whirlpool Canada LP (hereafter “Amana”) will pay for factory specified parts and repair labor to correct defects in materials or workmanship that existed when this major appliance was purchased. Service must be provided by an Amana designated se
Resumen del contenido incluido en la página 18
INSTRUCCIONES PARA EL USUARIO DEL REFRIGERADOR LE AGRADECEMOS la compra de este producto de alta calidad. Si usted experimenta un problema que no se haya cubierto en SOLUCIÓN DE PROBLEMAS, visite nuestro sitio de internet en www.amana.com para obtener información adicional. Si considera que aún necesita ayuda, llámenos al 1-800-843-0304. En Canadá, visite nuestro sitio de internet en www.amanacanada.ca o llámenos al 1-800-807-6777. Necesitará tener a mano su número de modelo y de serie ubic
Resumen del contenido incluido en la página 19
Antes de tirar su viejo refrigerador o congelador: Cómo deshacerse adecuadamente de su ■ Saque las puertas. refrigerador viejo ■ Deje los estantes en su lugar para que los niños no puedan meterse con facilidad. ADVERTENCIA Peligro de Asfixia Remueva las puertas de su refrigerador viejo. No seguir esta instrucción puede ocasionar la muerte o daño al cerebro. IMPORTANTE: El atrapamiento y asfixia de niños no es un problema del pasado. Los refrigeradores tirados y abandonados son un peligro, a
Resumen del contenido incluido en la página 20
NOTAS: IMPORTANTE: ■ No se recomienda instalar el refrigerador cerca de un horno, ■ Todas las instalaciones deben hacerse de acuerdo a los radiador u otra fuente de calor. No instale el refrigerador cerca requerimientos locales de plomería. de una ubicación en la que la temperatura puede bajar de los ■ Use tuberías de cobre y revise si hay fugas. Instale tubería de 55°F (13°C). cobre sólo en áreas donde la temperatura va a permanecer ■ El ancho mínimo normal necesario para el área de corte d
