Resumen del contenido incluido en la página 1
REFRIGERADOR
CONGELADOR
FRIDGE-FREEZER
ZI 428 D
LIBRO DE INSTRUCCIONES INSTRUCTION BOOKLET
2222 126-83
This document was created with FrameMaker 4.0.4
Resumen del contenido incluido en la página 2
CONTENTS Warnings. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .page 12 Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .page 13 Location . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .page 13 Power connection . . . . . . . . . . . . . . . . . . . . . . . . . . . . .page 13 Cleaning the appliance’s interior . . . . . . . . . . . . . . . . . . . . . . . .page 13 Instructions for total built-in . . . . . . . . . . . . . . . . . . . . .
Resumen del contenido incluido en la página 3
WARNINGS It is most important that this instruction book should be ª The inner lining of the appliance consists of retained with the appliance for future reference. Should the channels through which the refrigerant passes. If appliance be sold or transferred to another owner, or should these should be punctured this would damage the you move house and leave the appliance, always ensure that the appliance beyond repair and cause food loss. DO book is supplied with the appliance in order tha
Resumen del contenido incluido en la página 4
INSTALLATION If this refrigerator featuring magnetic door seals is to replace The manufacturer declines to accept any liability if this an older appliance having a spring lock on the door or lid, be accident-prevention procedure is not followed. sure to make that spring lock unusable before you discard the This appliance complies with E.E.C. directive old appliance. no. 87/308 of 2.6.87 relative to radio interference This will prevent it from becoming a death-trap for a chi
Resumen del contenido incluido en la página 5
For appropriate venting, follow indications in Open the door and push the appliance against the Fig. 2. side of kitchen furniture opposite to that of appliance hinges. Fig. 2 2 50-min. cm 200 Fasten the appliance with 4 screws provided in the kit included with the appliance. Snap vent grill (C) and hinge cover (D) into position. Fig. 5 min.
2 cm 200 D D033 Push appliance into housing until stop strip (A) C D502 touches the kitchen unit. Press in the joint covers between the applia
Resumen del contenido incluido en la página 6
20mm Position the runners (H) at the top and bottom of Remove the little plates and make the holes with a the inside of the kitchen unit as shown in Fig. 8 and diam. of 2 mm. Replace the little plates over the mark the position of the external holes. runners and screw in the screws provided After preparing the holes, screw the runners to the (3.5x16 mm). kitchen unit door using 3.5x16 mm screws. For the alignment of the kitchen unit door, if necessary, use the clearance size of the sl
Resumen del contenido incluido en la página 7
USE and do not open the door too often. Starting-up and temperature regulation Freezing is completed after 24 hours from the start. Insert the plug into the wall socket. Open the refrigerator door and turn the thermostat knob, to On the inner door of the compartment you be found on the top right hand side of the inner will find a list of foods followed by a number. These liner, clockwise beyond the «O» position, to start numbers indicate the maximum period of time for the appliance. whi
Resumen del contenido incluido en la página 8
For more thorough cleaning, the top door shelf can Food refrigeration be removed by pulling it in the direction of the To achieve the best results with the refrigerator arrows, then refitting it in position (Fig. 13). compartment, you should follow one or two very Fig. 13 simple rules: Do not put warm foods or evaporating liquids in the refrigerator. Cover or wrap foods (particularly if they have a strong smell). Do not cover the shelves (grids) with paper or plastic sinc
Resumen del contenido incluido en la página 9
To carry out complete defrosting of the ( ) freezer compartment proceed as follows: Unplug the appliance from the power supply or set the thermostat to position «O». Remove the frozen foods and wrap them in several sheets of newspaper, then keep them in a cool place. Leave the door open. Place a basin on the refrigerator compartment shelf underneath the drainage hole and pull the plug downward (Fig. 15); to reinsert it, just push it up. The plug can be removed by pulling it downward
Resumen del contenido incluido en la página 10
MAINTENANCE Unplug the appliance before carrying out any Replacing the interior light bulb maintenance operation. The light inside the refrigerator compartment is Clean the interior periodically with lukewarm easy to get at through the opening in the light water and some sodium bicarbonate; the cabinet holder. exterior with a silicone wax spray; the condenser If the light does not go on when the door is open, and the motor compressor with a brush or a vacuum check that it is screwed