Resumen del contenido incluido en la página 1
REFRIGERATOR
USER INSTRUCTIONS
THANK YOU for purchasing this high-quality product. If you should experience a problem not covered in TROUBLESHOOTING,
please visit our website at www.maytag.com for additional information. If you still need assistance, call us at 1-800-688-9900.
In Canada, visit our website at www.maytag.ca or call us at 1-800-807-6777.
You will need your model and serial number, located on the inside wall of the refrigerator compartment.
Para obtener acceso a “Instrucciones p
Resumen del contenido incluido en la página 2
IMPORTANT SAFETY INSTRUCTIONS WARNING: To reduce the risk of fire, electric shock, or injury when using your refrigerator, follow these basic precautions: ■ Plug into a grounded 3 prong outlet. ■ Use nonflammable cleaner. ■ Do not remove ground prong. ■ Keep flammable materials and vapors, such as gasoline, away from refrigerator. ■ Do not use an adapter. ■ Use two or more people to move and install refrigerator. ■ Do not use an extension cord. ■ Disconnect power before installing ice maker (
Resumen del contenido incluido en la página 3
Location Requirements Electrical Requirements WARNING WARNING Explosion Hazard Electrical Shock Hazard Keep flammable materials and vapors, such as Plug into a grounded 3 prong outlet. gasoline, away from refrigerator. Do not remove ground prong. Failure to do so can result in death, explosion, or fire. Do not use an adapter. Do not use an extension cord. To ensure proper ventilation for your refrigerator, allow for ¹⁄₂" (1.25 cm) of space on each side and at the top. Allow for 1" Failure to f
Resumen del contenido incluido en la página 4
6. Fasten the shutoff valve to the cold water pipe with the pipe Water Pressure clamp. Be sure the outlet end is solidly in the ¹⁄₄" (6.35 mm) drilled hole in the water pipe and that the washer is under the A cold water supply with water pressure of between 30 and pipe clamp. Tighten the packing nut. Tighten the pipe clamp screws slowly and evenly so the washer makes a watertight 120 psi (207 and 827 kPa) is required to operate the water dispenser and ice maker. If you have questions about
Resumen del contenido incluido en la página 5
NOTE: Tighten the nut by hand. Then tighten it with a wrench two more turns. Do not overtighten. REFRIGERATOR USE Using the Controls For your convenience, your refrigerator controls are preset at the factory. When you first install your refrigerator, make sure that the controls are still preset. The Refrigerator Control and the Freezer A B C D E F G Control should both be set to the “mid-settings.” A. Refrigerator water tubing E. Ferrule (purchased) Refrigerator B. Nut (provided) F. Nut (p
Resumen del contenido incluido en la página 6
■ Slide the door chill control to the left or down to reduce the Disabling Sounds flow of cold air to the bin and make it less cold. ■ Slide the door chill control to the right or up to increase the ■ To turn off all dispenser and control sounds, press and hold flow of cold air to the bin and make it colder. LIGHT and LOCK at the same time for 3 seconds. ■ To turn all sounds back on, press and hold LIGHT and LOCK Water and Ice Dispensers at the same time for 3 seconds again. (on some models
Resumen del contenido incluido en la página 7
The Ice Dispenser The Dispenser Light (on some models) Ice dispenses from the ice maker storage bin in the freezer when When you use the dispenser, the light will automatically turn on. the dispenser pad is pressed. The dispensing system will not If you want the light to be on continuously, you may choose either operate when the freezer door is open. To turn off the ice maker, ON or DIM. The display screen indicates which mode is selected. see “Ice Maker and Storage Bin.” ON: Press LIGHT to t
Resumen del contenido incluido en la página 8
6. Push the filter into the base grille. The eject button will pop Removing and Replacing Ice Storage Bin back out when the filter is fully engaged. 7. Flush the water system. See “Water and Ice Dispensers.” 1. Lift and hold open the translucent ice maker door. 2. Lift the wire shutoff arm so it clicks into the OFF (up) position. Release the ice maker door. REFRIGERATOR CARE 3. Lift up the front of the storage bin and pull it out. Cleaning WARNING 4. Replace the bin by pushing it in all the w
Resumen del contenido incluido en la página 9
5. There is no need for routine condenser cleaning in normal home operating environments. If the environment is Changing the Light Bulbs particularly greasy or dusty, or there is significant pet traffic in NOTE: Not all bulbs will fit your refrigerator. Be sure to replace the home, the condenser should be cleaned every 2 to the bulb with one of the same size, shape and wattage. On some 3 months to ensure maximum efficiency. models, the dispenser light requires a heavy duty 10-watt bulb. I
Resumen del contenido incluido en la página 10
The doors are difficult to open There is interior moisture buildup NOTE: Some moisture buildup is normal. WARNING ■ Humid room? Contributes to moisture buildup. ■ Door(s) opened often or left open? Allows humid air to enter refrigerator. Minimize door openings and keep doors fully closed. Ice and Water Explosion Hazard The ice maker is not producing ice or not enough ice Use nonflammable cleaner. Failure to do so can result in death, explosion, or fire. ■ Refrigerator connected to a water supp
Resumen del contenido incluido en la página 11
The ice dispenser will not operate properly The water dispenser will not operate properly ■ Freezer door closed completely? Close the door firmly. If it ■ Freezer door closed completely? Close the door firmly. If it does not close completely, see “The doors will not close does not close completely, see “The doors will not close completely.” completely.” ■ Ice bin installed correctly? Be sure the ice bin is firmly in ■ Refrigerator connected to a water supply and the supply position. shutoff v
Resumen del contenido incluido en la página 12
WATER FILTER CERTIFICATIONS 12
Resumen del contenido incluido en la página 13
PERFORMANCE DATA SHEETS Base Grille Water Filtration System Model T2WG2L/T2RFWG2 Capacity 200 Gallons (757 Liters) Model T2WG2/T2RFWG2 Capacity 200 Gallons (757 Liters) System tested and certified by NSF International against NSF/ANSI Standard 42 for the reduction of Chlorine Taste and Odor, Particulate Class II*; and against NSF/ANSI Standard 53 for the reduction of Mercury, Benzene, Toxaphene, O-dichlorobenzene, and Carbofuran. This system has been tested according to NSF/ANSI Standards 42
Resumen del contenido incluido en la página 14
Base Grille Water Filtration System Model T1WG2L/T2RFWG2 Capacity 200 Gallons (757 Liters) Model T1WG2/T2RFWG2 Capacity 200 Gallons (757 Liters) System tested and certified by NSF International against NSF/ANSI Standard 42 for the reduction of Chlorine Taste and Odor, Particulate Class II*; and against NSF/ANSI Standard 53 for the reduction of Mercury, Benzene, Toxaphene, O-dichlorobenzene, and Carbofuran. This system has been tested according to NSF/ANSI Standards 42 and 53 for the reductio
Resumen del contenido incluido en la página 15
Base Grille Water Filtration System Model P2WG2L/P2RFWG2 Capacity 200 Gallons (757 Liters) Model P2WG2/P2RFWG2 Capacity 200 Gallons (757 Liters) System tested and certified by NSF International against NSF/ANSI Standard 42 for the reduction of Chlorine Taste and Odor, Particulate Class I*; and against NSF/ANSI Standard 53 for the reduction of Lead, Mercury, Benzene, Toxaphene, and O-dichlorobenzene. This system has been tested according to NSF/ANSI Standards 42 and 53 for the reduction of th
Resumen del contenido incluido en la página 16
Base Grille Water Filtration System Model P1WG2L/P2RFWG2 Capacity 200 Gallons (757 Liters) Model P1WG2/P2RFWG2 Capacity 200 Gallons (757 Liters) System tested and certified by NSF International against NSF/ANSI Standard 42 for the reduction of Chlorine Taste and Odor, Particulate Class I*; and against NSF/ANSI Standard 53 for the reduction of Lead, Mercury, Benzene, Toxaphene, and O-dichlorobenzene. This system has been tested according to NSF/ANSI Standards 42 and 53 for the reduction of th
Resumen del contenido incluido en la página 17
® MAYTAG MAJOR APPLIANCE WARRANTY LIMITED WARRANTY For one year from the date of purchase, when this major appliance is operated and maintained according to instructions attached to or furnished with the product, Maytag brand of Whirlpool Corporation or Whirlpool Canada LP (hereafter “Maytag”) will pay for factory specified parts and repair labor to correct defects in materials or workmanship that existed when this major appliance was purchased. Service must be provided by a Maytag designated
Resumen del contenido incluido en la página 18
INSTRUCTIONS D'UTILISATION DU RÉFRIGÉRATEUR Nous vous REMERCIONS d'avoir acheté ce produit de haute qualité. Si vous rencontrez un problème non mentionné dans la section DÉPANNAGE, veuillez visiter notre site Web www.maytag.com pour des informations supplémentaires. Si vous avez toujours besoin d'assistance, veuillez nous téléphoner au 1-800-688-9900. Au Canada, visitez notre site Web www.maytag.ca ou téléphonez-nous au 1-800-807-6777. Vous aurez besoin de vos numéros de modèle et de série
Resumen del contenido incluido en la página 19
Avant de jeter votre vieux réfrigérateur ou congélateur : Mise au rebut de votre vieux réfrigérateur ■ Enlever les portes. ■ Laisser les tablettes en place de sorte que les enfants ne AVERTISSEMENT puissent pas y pénétrer facilement. Risque de suffoquer Enlever les portes de votre vieux réfrigérateur. Le non-respect de cette instruction peut causer un décès ou des lésions cérébrales. IMPORTANT : L'emprisonnement et l'étouffement des enfants ne sont pas un problème du passé. Les réfrigérateurs
Resumen del contenido incluido en la página 20
REMARQUES : ■ Il est recommandé de ne pas installer le réfrigérateur près Spécifications de l’alimentation en eau d'un four, d'un radiateur ou de toute autre source de chaleur. Rassembler les outils et pièces nécessaires avant de commencer Ne pas installer le réfrigérateur dans un endroit où la l'installation. Lire et suivre les instructions fournies avec les outils température baissera au-dessous de 55°F (13°C). indiqués ici. ■ La largeur de la cavité d’encastrement doit être d’au moins
