Resumen del contenido incluido en la página 1
®
240-VOLT ELECTRIC
COMPACT DRYER
Use & Care Guide
For questions about features, operation/performance,
parts accessories or service, call: 1-800-253-1301
or visit our website at www.whirlpool.com
Table of Contents.................................................................2
3406878
Resumen del contenido incluido en la página 2
TABLE OF CONTENTS DRYER SAFETY.......................................................................... 3 INSTALLATION INSTRUCTIONS............................................... 4 Tools and Parts ............................................................................4 Location Requirements ...............................................................4 Electrical Requirements ...............................................................6 Electrical Connection ..........................
Resumen del contenido incluido en la página 3
DRYER SAFETY Your safety and the safety of others are very important. We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety messages. This is the safety alert symbol. This symbol alerts you to potential hazards that can kill or hurt you and others. All safety messages will follow the safety alert symbol and either the word “DANGER” or “WARNING.” These words mean: You can be killed or seriously injured if you don't immediately follow
Resumen del contenido incluido en la página 4
Location Requirements INSTALLATION INSTRUCTIONS Tools and Parts Tools needed Check that you have everything necessary for correct installation. Proper installation is your responsibility. Explosion Hazard Flat-bladed screwdriver Duct tape #2 Phillips head Wood block Keep flammable materials and vapors, such as screwdriver gasoline, away from dryer. Caulking gun and Level compound (for installing Place dryer at least 18 inches (46 cm) above the new exhaust vent) Adjustable wr
Resumen del contenido incluido en la página 5
Dryer Dimensions Recessed or closet installation - Dryer only 3 20 4" * (52.7 cm) † 31" (78.7 cm) 7 23 8" 1. Side view - closet or confined area (60.6 cm) 2. Recessed area *Most installations require a minimum 5½ in. (14.0 cm) clearance Recessed or closet installation - Stacked behind the dryer for the exhaust vent with elbows. See “Venting Requirements.” Minimum installation spacing for recessed area and closet installation The following dimensions shown are for the minimum spacing allowed
Resumen del contenido incluido en la página 6
If your outlet looks like this: Electrical Requirements It is your responsibility To contact a qualified electrical installer. To be sure that the electrical connection is adequate and in 4-wire receptacle (14-30R) conformance with the National Electrical Code, ANSI/NFPA Then choose a 4-wire power supply cord with ring or spade 70-latest edition and all local codes and ordinances. terminals and UL approved strain relief. The 4-wire power supply A copy of the above code standards can be
Resumen del contenido incluido en la página 7
Electrical Connection Power Supply Cord Direct Wire Fire Hazard Fire Hazard Use a new UL approved 30 amp power Use 10 gauge solid copper wire. supply cord. Use a UL approved strain relief. Use a UL approved strain relief. Disconnect power before making electrical Disconnect power before making electrical connections. connections. Connect neutral wire (white or center wire) to Connect neutral wire (white or center wire) to center terminal (silver). center terminal (silver). Ground wire (g
Resumen del contenido incluido en la página 8
Electrical Connection Options 1. Remove center terminal block screw. 2. Remove appliance ground wire (green with yellow stripes) If your home has: And you will be Go to Section from external ground connector screw. Fasten it under center, connecting to: silver colored terminal block screw. 4-wire receptacle A UL listed, 4-wire connection: (NEMA Type 14-30R) 120/240 volt Power supply cord minimum, 30 amp., dryer power supply cord* 4-wire direct A fused 4-wire connection: disconnect or Dire
Resumen del contenido incluido en la página 9
4. Place the hooked end of the neutral wire (white or center wire) 4-wire connection: Direct Wire of power supply cable under the center screw of terminal block (hook facing right). Squeeze hooked end together. IMPORTANT: A 4-wire connection is required for mobile homes Tighten screw. and where local codes do not permit the use of 3-wire connections. Direct wire cable must have 5 ft (1.52 m) of extra length so dryer can be moved if needed. Strip 5 in. (12.7 cm) of outer covering from en
Resumen del contenido incluido en la página 10
3-wire connection: Power supply cord 3-wire connection: Direct Wire Use where local codes permit connecting cabinet-ground Use where local codes permit connecting cabinet-ground conductor to neutral wire. conductor to neutral wire. Direct wire cable must have 5 ft (1.52 m) of extra length so dryer can be moved if needed. 4 5 2 Strip 3¹⁄₂ in. (8.9 cm) of outer covering from end of cable. Strip 1 insulation back 1 in. (2.5 cm). If using 3-wire cable with ground wire, cut bare wire even with o
Resumen del contenido incluido en la página 11
Optional 3-wire connetion Venting Requirements Use for direct wire or power supply cord where local codes do not permit connecting cabinet-ground conductor to neutral wire. 1. Remove center terminal block screw. 2. Remove appliance ground wire (green with yellow stripes) from external ground connector screw. Connect appliance ground wire and the neutral wire (white or center wire) of power supply cord/cable under center, silver colored terminal block screw. Tighten screw. 3. Connect the ot
Resumen del contenido incluido en la página 12
Special provisions for mobile home installations The exhaust vent must be securely fastened to a noncombustible Plan Vent System portion of the mobile home structure. Do not use screws or other Typical installations vent the dryer from the rear of the dryer. fastening devices that extend into the interior of the vent to secure vent. 1 2 3 Terminate the exhaust vent outside. The exhaust vent must not terminate beneath the mobile home and must not be connected 1. Exhaust hood to any other duc
Resumen del contenido incluido en la página 13
The angled hood style (shown following) is acceptable. Install Leveling Legs 4" (10.2 cm) WARNING 2.5" (6.4 cm) Excessive Weight Hazard See the exhaust vent length chart that matches your hood type Use two or more people to move and install for the maximum vent lengths you can use. dryer. Exhaust systems longer than specified will: Shorten the life of the dryer. Failure to do so can result in back or other injury. Reduce performance, resulting in longer drying times and increased energ
Resumen del contenido incluido en la página 14
Level Dryer Complete Installation Check levelness of dryer. Check levelness first side-to-side, then 1. Check to be sure all parts are now installed. If there is an front-to-back. extra part, go back through the steps to see which step was skipped. 2. Check to be sure you have all of your tools. 3. Dispose of all packaging materials. 4. Check the dryer’s final location. Be sure the vent is not crushed or kinked. 5. Check to be sure the dryer is level. (See “Level Dryer.”) 6. Plug into a grou
Resumen del contenido incluido en la página 15
7 0 G 6 N I 0 Y 5 R D 0 D 4 E M I 0 T 3 0 2 0 1 F F O 0 3 R 0 I 2 A DRYER USE - 1. Load clothes loosely into the dryer and close the door. Do not pack the dryer. Allow space for clothes to tumble freely. Starting Your Dryer 2. Turn the Cycle Control knob to the recommended cycle for Explosion Hazard the type of load being dried. Use the Energy Preferred Automatic Setting ( ) to dry most heavyweight and medium Keep flammable materials and vapors, such as * weight loads. See “Drying, Cycle, a
Resumen del contenido incluido en la página 16
7 0 G 6 N I 0 Y 5 R D 0 D 4 E M I 0 T 3 0 2 0 1 F F O 0 3 R 0 I 2 A Loading Cycles Load clothes loosely into the dryer. Do not pack the dryer. Allow space for clothes to tumble freely. The following chart shows the maximum load you can place in your compact dryer. Expect longer drying times. Heavy work 2 pair of pants, 3 work shirts clothes Delicates 1 camisole, 2 slips, 4 undergarments, 1 set of sleepwear, 1 half slip Towels 9 bath towels; or 6 bath towels, 3 hand towels, 6 wash cloths
Resumen del contenido incluido en la página 17
Cleaning the Dryer Interior DRYER CARE Cleaning the Lint Screen Every load cleaning The lint screen is located inside the dryer drum, on the back wall. Clean it before each load. A screen blocked by lint can increase drying time. To clean Explosion Hazard 1. Open the door and pull the lint screen straight out. Use nonflammable cleaner. Failure to do so can result in death, explosion, or fire. To clean dryer drum 1. Make a paste with powdered laundry detergent and very warm water. 2. Apply
Resumen del contenido incluido en la página 18
Is the load too big or too heavy? Dry smaller loads so lint can be carried to the lint screen. TROUBLESHOOTING Was the load overdried? Use correct dryer settings for load type. Overdrying can cause lint-attracting static electricity. See “Drying, Cycle and First try the solutions suggested here and possibly avoid Temperature Tips.” the cost of a service call... Was paper or tissue left in pockets? Clothes are not drying satisfactorily Is pilling being mistaken for lint? Check the f
Resumen del contenido incluido en la página 19
ASSISTANCE OR SERVICE Before calling for assistance or service, please check “Troubleshooting.” It may save you the cost of a service call. If you still need help, follow the instructions below. When calling, please know the purchase date and the complete model and serial number of your appliance. This information will help us to better respond to your request. If you need replacement parts If you need to order replacement parts, we recommend that you ® only use FSP factory specified parts
Resumen del contenido incluido en la página 20
® WHIRLPOOL DRYER WARRANTY ONE-YEAR FULL WARRANTY For one year from the date of purchase, when this dryer is operated and maintained according to instructions attached to or furnished ® with the product, Whirlpool Corporation will pay for FSP replacement parts and repair labor to correct defects in materials or workmanship. Service must be provided by a Whirlpool designated service company. Whirlpool Corporation will not pay for: 1. Service calls to correct the installation of your dryer, i
