Resumen del contenido incluido en la página 1
Instructions for use
WASHER-DRYER
! This symbol reminds you to read this instruction manual.
GB
Contents
GB
English,1
Installation, 2-3-4-5
Unpacking and levelling
Connecting the electricity and water supplies
The first wash cycle
Technical data
Description of the washer-dryer, 6-7
Control panel
Display
How to run a wash cycle or a drying cycle, 8
Wash cycles and options, 9
Table of programmes and wash cycles
Wash options
Detergents and laundry, 10
WDPG 8640
Detergent dispenser drawer
Preparing
Resumen del contenido incluido en la página 2
Installation 2. If the floor is not perfectly level, compensate for any ! Keep this instruction manual in a safe place for future GB unevenness by tightening or loosening the adjustable reference. Should the appliance be sold, transferred or front feet (see figure); the angle of inclination, measured moved, make sure the instruction manual accompanies the according to the worktop, must not exceed 2°. washer-dryer to inform the new owner as to its operation and features. ! Read these instr
Resumen del contenido incluido en la página 3
65 - 100 cm Connecting the drain hose • the supply voltage is included within the values indica- GB ted on the Technical Data Plate fixed on the machine. Connect the drain hose, without bending it, to a • the socket is compatible with the washer-dryer’s plug. If draining duct or a wall drain this is not the case, replace the socket or the plug. situated between 65 and 100 cm from the floor; Your appliance is now supplied with a 13 amp fused plug it can be plugged into a 13 amp socket
Resumen del contenido incluido en la página 4
As the colours of the wires in the lead may not correspond The first wash cycle GB with the coloured markings identifying the terminals in your plug, proceed as follows: Once the appliance has been installed, and before you use Connect Green & Yellow wire to terminal marked E or it for the first time, run a wash cycle with detergent and no or coloured Green or Green & Yellow. laundry, using the wash cycle 2. Connect Brown wire to terminal marked L or coloured Red. Connect Blue wire to ter
Resumen del contenido incluido en la página 5
GB Technical data Model WDPG 8640 width 59.5 cm Dimensions height 85 cm depth 60,5 cm from 1 to 8 kg for the wash programme Capacity from 1 to 6 kg for the drying programme Electrical please refer to the technical data plate fixed to the machine connections maximum pressure 1 MPa (10 bar) Water connections minimum pressure 0.05 MPa (0.5 bar) drum capacity 62 litres Spin speed up to 1400 rotations per minute Wash: programme 4; temperature 60°C; using a load of 8 kg. Energy rated Drying: the s
Resumen del contenido incluido en la página 6
Description of the washer-dryer Control panel GB TEMPERATURE CLEANING button CHILD ACTION LOCK button button ON/OFF button DISPLAY START/PAUSE button and indicator SPIN light WASH Detergent dispenser drawer button CYCLE OPTION SELECTOR buttons and KNOB indicator lights DRY button Detergent dispenser drawer: used to dispense DRY button : press to decrease or exclude drying; the detergents and washing additives (see “Detergents and selected drying level or time will appear on t
Resumen del contenido incluido en la página 7
Display GB B A C The display is useful when programming the machine and provides a great deal of information. The duration of the available wash cycles and the remaining time of a running cycle appear in section A; if the DELAYED START option has been set, the countdown to the start of the selected wash cycle will appear. Moreover, pressing the relative button allows for visualising the maximum values for the temperature, spin speed or type of drying relative to the selected programme or the m
Resumen del contenido incluido en la página 8
How to run a wash cycle or a drying cycle Selecting the cotton drying cycle through the programme 1. SWITCH THE MACHINE ON. Press the button; the GB selector knob and pressing the “Eco” button activates an START/PAUSE indicator light will flash slowly in a green automatic drying cycle that allows for saving energy, thanks colour. to an optimal combination of air temperature and cycle 2. LOAD THE LAUNDRY. Open the porthole door. Load duration; the display will visualise the “A2” dryness
Resumen del contenido incluido en la página 9
The duration of the wash cycles can be checked on the display. Wash cycles and options Table of programmes and wash cycles GB Detergents Max. Max. Max. Cycle Description of the wash cycle temp. speed Drying load duration (kg) (°C) (rpm) Fabric Wash softener CLEAN Plus 1 Anti Stain 40° 1400 5 2 Whites 60° 1400 5 3 Cottons: extremely soiled whites. 90° 1400 8 4 Cottons (1): heavily soiled whites and resistant colours. 60° 1400 8 5 Cottons (2): lightly soiled
Resumen del contenido incluido en la página 10
Detergents and laundry Whites: use this cycle 2 to wash white clothes. The Detergent dispenser drawer GB programme is designed to maintain the brightness of white Successful washing results also depend on the correct clothes over time. Use powder detergent for best results. dose of detergent: adding too much detergent will not If the drying function is selected, a drying cycle automatically necessarily result in a more efficient wash, and may in activates at the end of the wash cycle that
Resumen del contenido incluido en la página 11
Precautions and tips ! This washer-dryer was designed and constructed in Disposal GB accordance with international safety regulations. The • Disposing of the packaging materials: observe local following information is provided for safety reasons and regulations so that the packaging may be re-used. must therefore be read carefully. • The European Directive 2002/96/EC on Waste Electrical and Electronic Equipment, requires that old household General safety electrical appliances must not be d
Resumen del contenido incluido en la página 12
Care and maintenance Cutting off the water and electricity Caring for the door and drum of your GB supplies appliance • Turn off the water tap after every wash cycle. This will limit • Always leave the porthole door ajar in order to prevent wear on the hydraulic system inside the washer-dryer and unpleasant odours from forming. help to prevent leaks. Cleaning the pump • Unplug the washer-dryer when cleaning it and during all maintenance work. The washer-dryer is fitted with a self-cleaning p
Resumen del contenido incluido en la página 13
Troubleshooting Your washer-dryer could occasionally fail to work. Before contacting the Technical Assistance Service (see “ Service”), make GB sure that the problem cannot be solved easily using the following list. Problem: Possible causes / Solutions: The machine does not switch on. • The appliance is not plugged into the socket fully, or not enough to make contact. • There is no power to the socket, or the fuse has blown in the mains plug. The wash cycle does not start. • The door is not clo
Resumen del contenido incluido en la página 14
The machine is noisy. • There will always be some motor, pump and drum noise during spin. GB The machine wont spin properly. • Out of Balance detected when attempting to go into a spin cycle - If this happens the machine will continue to try to repeat the distribution of the load required before the machine will go into higher spin speeds - This will increase the programme time accordingly. This is a safety feature to prevent damage. Out of Balance can be caused by washing a single heavy it
Resumen del contenido incluido en la página 15
Assistance Guarantee GB 12 Months Parts and Labour Guarantee Your appliance has the benefit of our manufacturer’s guarantee, which covers the cost of breakdown repairs for twelve months from the date of purchase. This gives you the reassurance that if, within that time, your appliance is proven to be defective because of either workmanship or materials, we will, at our discretion, either repair or replace the appliance at no cost to you. This guarantee is subject to the following conditions:
Resumen del contenido incluido en la página 16
195098119.00 11/2011 - Xerox Fabriano After Sales Service GB No one is better placed to care for your Hotpoint appliance during the course of its working life than us - the manufacturer. Essential Contact Information Hotpoint Service We are the largest service team in Europe offering you access to 400 skilled telephone advisors and 1000 fully qualified engineers on call to ensure you receive fast, reliable, local service. UK: 08448 224 224 Republic of Ireland: 0818 313 413 www.hotpointserv
