Resumen del contenido incluido en la página 1
PRODUCT GUIDE
MODEL 463722312
C-33G3CB
IMPORTANT: Fill out the product record information below.
Serial Number
See rating label on grill for serial number.
Date Purchased
For support and to register your
grill, please visit us at
www.charbroil.com
If you have questions or need
assistance during assembly,
please call 1-800-241-7548.
07/25/10 • G312-001-080801
Assembly instructions © 2011
© 2011 Char-Broil, LLC Columbus, GA 31902
Printed in China
Resumen del contenido incluido en la página 2
TABLE OF CONTENTS DANGER For Your Safety . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-3 If you smell gas: Grilling Guide. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-7 1. Shut off gas to the appliance. Use and Care . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8-13 2. Extinguish any open flame. Limited Warranty. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14 3. Open lid. Parts List. .
Resumen del contenido incluido en la página 3
WARNING CAUTION CALIFORNIA PROPOSITION 65 Using pots larger than 6 quarts in capacity could 1. Combustion by-products produced when using exceed weight limit of the this product contain chemicals known to the State of side burner shelf or side shelf, California to cause cancer, birth defects, and other reproductive harm. resulting in failure 2. This product contains chemicals, including lead of grill cart components. and lead compounds, known to the State of California to cause cancer, birth
Resumen del contenido incluido en la página 4
GRILLING GUIDE – Getting Started Temperature - Convective Grills ONLY. The temperature gauge in the hood of your new grill measures air temperature. The air temperature inside your grill will never First Time Use be as hot as the temperature at the cooking surface. Read your Assembly Manual and ensure the grill is put together properly. Remove all Point-of-Purchase advertising material from Note: Since 1995, all regulators (the part that attaches to the gas all grill surfaces before fir
Resumen del contenido incluido en la página 5
Rotisserie Cooking GRILLING GUIDE – Grilling 101 Rotisserie cooking is best for 'round' meat, such as large roasts, whole poultry, and pork. It generally requires an accessory motor Outdoor grilling is really quite simple. You'll succeed with and spit rod that allows the meat to be turned at a constant burgers, dogs, or steaks usually on your very first try. With speed. Rotisserie cooking is best done in front of a special experience, you will learn how to work with your grill, creati
Resumen del contenido incluido en la página 6
Wood Chips GRILLING GUIDE – Tips & Tricks For extra smoke flavor when grilling, try adding wood chips. Cooking on your new grill is a hands-on experience, and it is Soak the chips in water for approximately 30 minutes before recommended to remain outside with your grill while cooking. adding to a smoke box or pan. Place smoke box or pan on top of Grilling can be affected by many external conditions. In cold the cooking grate above the flame. Turn grill on high until the weather, you wi
Resumen del contenido incluido en la página 7
Cooking surfaces: If a bristle brush is used to clean any of the GRILLING GUIDE – Cleaning Your Grill grill cooking surfaces, ensure no loose bristles remain on cooking Why Clean? surfaces prior to grilling. It is not recommended to clean cooking We've all heard the saying 'An ounce of prevention is worth a surfaces while grill is hot. pound of cure'. This is great advice when it comes to keeping your grill clean. Storing Your Grill • Clean cooking grates. Routine Care • Store grill in dry
Resumen del contenido incluido en la página 8
LP Cylinder USE AND CARE •The LP cylinder used with your grill must meet the following requirements: •Use LP cylinders only with these required measurements: 12" DANGER (30.5cm) (diameter) x 18" (45.7 cm) (tall) with 20 lb. (9 kg.) capacity maximum. • NEVER store a spare LP cylinder under or near •LP cylinders must be constructed and marked in accordance the appliance or in an enclosed area. with specifications for LP cylinders of the U.S. Department of Transportation (DOT) or for Cana
Resumen del contenido incluido en la página 9
e s i w k LP Cylinder Exchange Connecting Regulator to the LP Cylinder •Many retailers that sell grills offer you the option of replacing 1.LP cylinder must be properly secured onto grill. (Refer to your empty LP cylinder through an exchange service. Use only assembly section.) those reputable exchange companies that inspect, precision fill, 2.Turn all control knobs to the OFF position. test and certify their cylinders. Exchange your cylinder only for an OPD safety feature-equipped cylinde
Resumen del contenido incluido en la página 10
Straight Leak Testing Valves, Hose and Regulator 1.Turn all grill control knobs to OFF. 2.Be sure regulator is tightly connected to LP cylinder. 3.Completely open LP cylinder valve by turning hand wheel counterclockwise. If you hear a rushing sound, turn gas off immediately. There is a major leak at the connection. Correct before proceeding. 4.Brush soapy solution onto areas circled below, or other similar Hold coupling nut and regulator fittings on your grill. as shown for proper connection
Resumen del contenido incluido en la página 11
Safety Tips s Before opening LP cylinder valve, check the coupling nut for WARNING tightness. s When grill is not in use, turn off all control knobs and LP cylinder valve. For Safe Use of Your Grill and to Avoid Serious s Never move grill while in operation or still hot. Injury: s Use long-handled barbecue utensils and oven mitts to avoid • Do not let children operate or play near grill. burns and splatters. s Maximum load for sideburner and side shelf is 10 lbs. • Keep grill area clear an
Resumen del contenido incluido en la página 12
Burner Flame Check • Remove cooking grates and flame tamers. Light burners, rotate WARNING knobs from HI to LOW. You should see a smaller flame in LOW position than seen on HI. Perform burner flame check Turn controls and gas source or tank OFF when not on sideburner, also. Always check flame prior to each use. If in use. only low flame is seen refer to "Sudden drop or low flame" in the Troubleshooting Section. HI CAUTION LOW If ignition does NOT occur in 5 seconds, turn the burner contro
Resumen del contenido incluido en la página 13
3. Remove carryover tubes and burners. 4. Detach electrode from burner. CAUTION NOTE: Removal/Detachment method will depend on the burner configuration. See different configurations in SPIDER ALERT! illustrations below. 5. Carefully lift each burner up and away from valve openings. We suggest three ways to clean the burner tubes. Use the one SPIDER AND WEBS INSIDE BURNER TUBE easiest for you. (A) Bend a stiff wire (a light weight coat hanger works well) into a small hook. Run the hook throug
Resumen del contenido incluido en la página 14
LIMITED WARRANTY This warranty only applies to units purchased from an authorized retailer. Manufacturer warrants to the original consumer-purchaser only that this product shall be free from defects in workmanship and materials after correct assembly and under normal and reasonable home use for the periods indicated below beginning on the date of purchase*. The manufacturer reserves the right to require that defective parts be returned, postage and or freight pre-paid by the consumer for re
Resumen del contenido incluido en la página 15
PARTS LIST Key Qty Description Key Qty Description A 1 TOP LID OO 1 RIGHT SHELF ASSEMBLY B 2 UPPER HINGE PP 1 HEAT SHIELD, SIDEBURNER C 1 LOGO PLATE QQ 1 TEMPERATURE GAUGE D 1 HANDLE RR 1 BEZEL, TEMPERATURE GAUGE E 1 FIREBOX SS 2 SPRING PIN, F/ CART F 2 LOWER HINGE NOT Pictured G 3 BURNER H 3 HEAT TENT … 1 HARDWARE PACK I 2 FLAME CARRYOVER TUBE … 1 ASSY INSTRUCTION, ENGLISH J 1 ELECTRODE … 1 ASSY INSTRUCTION, FRENCH K 1 GREASE CUP CLIP L 1 GREASE CUP M 2 COOKING GRATE N 1 SWINGAWAY GRID O 1 LEFT
Resumen del contenido incluido en la página 16
PARTS DIAGRAM A QQ RR B C N D OO M H F H M H G I J G G E NN K U L R II S Q PP JJ AA CC BB KK MM P SS W T LL SS GG V O CC GG BB Y HH FF Z X DD EE 16
Resumen del contenido incluido en la página 17
AS ASSEMBL SEMBLY Y Lay the cart frames down. 1 Place front panel between cart frames. Hook the holes to the preassembled #10-24x1/2’’ machine screws. Tighten the screws. Lower Back Brace, Upper Back Brace and Rear Tank Exclusion Wire 2 Attach back braces to back of cart by inserting the ribs on back braces into the slots on rear legs, and hooking the upper holes of back braces to the preassembled #10-24x1/2’’ machine screws. Tighten the screws. Hook rear tank exclusion wi
Resumen del contenido incluido en la página 18
Wheel assembly and Leg extender 3 Remove the wheel spacer and hitch pin from axle bolt. Insert axle bolt through wheels, secure with the wheel spacer and hitch pin removed previously (A). Push wheel assembly down until the axle bolt is locked securely by the clips on bottom of left legs (B). Install leg extenders by lining up the locator tab correctly into the opening in the leg (B). Left Cart Axle Bolt Wheel Wheel Spacer Frame Hitch Pin A Axle Bolt Right Cart Frame Wheel Assemb
Resumen del contenido incluido en la página 19
Firebox Assembly 5 Press down the pins on upper side braces. Slide firebox assembly along upper side brace from front to rear of cart assembly, until the pins snap into the holes on firebox support braces. Make sure the brackets on firebox support brace are fitted into the opening of the brackets on upper side brace. Right Side Shelf 6 Hook right side shelf assembly to the preassembled #10-24x1/2’’ machine screws on cart. Attach fascia to control panel with #10-24x3/8’’ win
Resumen del contenido incluido en la página 20
Sideburner 7 Feed the screws preassembled on sideburner valve brackets into keyhole slots on the fascia, turn it to lock in place, then tighten the screws (A). Place sideburner into sideburner drip pan. Make sure sideburner valve is inside sideburner tube. Secure sideburner with 5x9 fiber washer and #8-32 wing nut (B). Attach sideburner ignitor wire to sideburner electrode (C). Push control knob onto valve stem. Place sideburner grate onto sideburner shelf (D). A #8-32 W
