Manual de instrucciones de Clam Corp Fish Trap Scout 8244

Resumen del contenido incluido en la página 1

Mo de l No.
- 8244 -
p/ n 1 0 83 2 1

Specifications
Height: 58” (20” packed)
▪
Width: 36”
▪
▪ Depth: 80” (48” packed)
Weight: 47 lbs.
▪
Instruction p/n 102475
▪
















- Clam Customer Servi ce Information -

NOTICE!! Once used, this shelter cannot be returned to the store. If you have a
warranty claim, have your sales receipt ready and contact Clam Corporation
Customer Service by email inquiry or direct by calling:
Customer Service Hrs: - 9am to 4p

Resumen del contenido incluido en la página 2

- Parts Li st - ITEM NO. PART NUMBER DESCRIPTION QTY. 1 101080 SCREW, 1/4-20 X 1.25 8 2 101081 WASHER, 1/4 FLAT 16 3 101082 NUT, 1/4-20 THIN NYLOCK 26 4 101083 TUBE SPACER CAP 8 5 101088 SCREW, 1/4-20 X 0.75 14 6 101140 SCOUT PORCH HOOP 1 7 101043 LH CANOPY BRACKET 1 8 101609 SEAT RAIL SUPPORT BRACKET 2 9 101042 RH CANOPY BRACKET 1 10 101141 SCOUT CANOPY HOOP 3 11 102494 BASE, SCOUT 08-09 1 12 101095 TOW ROPE, 3/8 DIA X 9 FT 1 13 101096 U-CHANNEL MOLDING, SCOUT 1 14 101148 SC

Resumen del contenido incluido en la página 3

- Parts Di agram - 3

Resumen del contenido incluido en la página 4

- Step One - 4

Resumen del contenido incluido en la página 5

- Step Two - 5

Resumen del contenido incluido en la página 6

- Step Three - Scout Base (p/n 102494) 6

Resumen del contenido incluido en la página 7

- Step Four - 7

Resumen del contenido incluido en la página 8

- St ep Five - 8

Resumen del contenido incluido en la página 9

- Step Si x - 9

Resumen del contenido incluido en la página 10

- Step Seven - 10

Resumen del contenido incluido en la página 11

- Step Ei ght - Scout Tent (p/n 102432) 11

Resumen del contenido incluido en la página 12

- Step Nine - 12

Resumen del contenido incluido en la página 13

- Step Ten - If everything still looks good, secure the Molding with the #6 Phillips Screws. Evenly space them about every ten to twelve inches, and also put a screw in the center of both corners. Since there aren’ t any predrilled holes, it's advisable to use a powered driver for this operation. 13

Resumen del contenido incluido en la página 14

- Set -up & Take Down - Set-Up - Rotate the hoop poles forward, then position and expand the adjustable spreader pole in the rear of the unit to take the slack out of the tent. Tighten the tension knob on the rear adjustable spreader pole to hold its position. Take-Down - Go around the shelter and tuck the tent material in between the rested hoops to keep the tent from spilling out of the base and contacting the ground. Also make sure that the tent is clear of the canopy brackets edges