Resumen del contenido incluido en la página 1
®
3000
O Ow wn ne er r’’s s G Gu uiid de e
Resumen del contenido incluido en la página 2
limited lifetime consumer warranty For a period of one calendar year from the date of purchase of this auto-security device, Directed Electronics promises to the ORIGINAL PURCHASER to repair or replace (with a com- parable reconditioned model), free of cost, any electronic control module which proves to be defective in workmanship or material under normal use, SO LONG AS THE SYSTEM WAS SOLD, INSTALLED, AND SERVICED BY A PROFESSIONAL AUTO INSTALLER, AND REMAINS IN THE CAR IN WHICH THE SYSTEM WAS
Resumen del contenido incluido en la página 3
OF TIME, LOSS OF EARNINGS, COMMERCIAL LOSS, LOSS OF ECONOMIC OPPORTUNITY AND THE LIKE. NOTWITHSTANDING THE ABOVE, MANUFACTURER DOES OFFER A LIMITED WAR- RANTY TO REPLACE OR REPAIR THE CONTROL MODULE AS DESCRIBED ABOVE. Some states do not allow limitations on how long an implied warranty will last or the exclusion or limita- tion of incidental or consequential damages. This warranty gives you specific legal rights, and you may also have other rights which vary from state to state. IMPORTANT NOTE:
Resumen del contenido incluido en la página 4
table of contents limited lifetime consumer diagnostics . . . . . . . . . . . . . . . . . .16 arming diagnostics . . . . . . . . .16 warranty . . . . . . . . . . . . . . . . . . . . .i disarming diagnostics . . . . . . .17 trademarks and copyrights . . . . .ii arm/disarm diagnostic chart . .17 table of contents . . . . . . . . . . . . .1 table of zones . . . . . . . . . . . .18 what is included . . . . . . . . . . . . . .2 high frequency . . . . . . . . . . . . . .19 important information . . .
Resumen del contenido incluido en la página 5
what is included One control module/siren with built-in Tilt sensor and 24 pin main wiring harness (attached) One Mini-Blue status LED One 2-button Valet switch One in-key 2-button remote One 3-button remote Two Merlin decal’s This Owner’s Guide Warranty Card important information Congratulations on the purchase of your state-of-the-art motorcycle security system. It has been designed to provide years of trouble-free operation. This system must be installed by an authorised dealer. Insta
Resumen del contenido incluido en la página 6
n no otte e:: Other than the remote controls, this system has no user-service- able parts. Your authorized dealer can correct any system wiring prob- lems and, if needed, can return any malfunctioning component to Directed Electronics for repair/replacement under the terms of the Limited Lifetime Warranty printed at the beginning of this guide. system maintenance The system requires no specific maintenance. The batteries in your remotes will last approximately one year under normal use. Your 3-
Resumen del contenido incluido en la página 7
remote configurations The 3000 system has an in-key 2-button remote control and a 3-button remote control. Two additional Merlin remote controls can be added. IN-KEY 2-BUTTON REMOTE CONTROL FRONT REAR LED ACCESSORY ARM/DISARM/PANIC 3-BUTTON REMOTE CONTROL LED ACCESSORY ARM/DISARM/PANIC SILENT ARM/DISARM © 2005 directed electronics, all rights reserved 4
Resumen del contenido incluido en la página 8
remote functions This system uses computer-based code learning to learn the remote buttons. This makes it possible to assign any remote button to any sys- tem function. The remotes initially come programmed with standard configuration. The buttons in all of the instructions in this manual cor- respond to a standard configuration remote. standard configuration for in-key 2-button remote Button The arming, disarming, and panic functions are controlled by this button. Button An optional accessory c
Resumen del contenido incluido en la página 9
Button An optional accessory convenience or expansion function that you have added to your system can be activated by pressing this button. Button Silent arm and disarm is controlled by this button. and Buttons When pressed together, these buttons disable the on-board control module tilt sensor and any optionally installed sensors. and Buttons Remotely enters or exits Valet. using your system The buttons used in the instructions in this manual correspond to the standard remote configuration. If
Resumen del contenido incluido en la página 10
While the system is armed, the LED status indicator will flash approxi- mately once per second showing that the system is actively protecting your vehicle. If you hear more than one chirp when arming, refer to the Diagnostics section of this guide. These extra chirps confirm a malfunc- tion autobypass. The security system also can be programmed to arm itself automatically without a remote (called passive arming). If the system is programmed for passive arming, it will automatically arm 30-secon
Resumen del contenido incluido en la página 11
disarming To disarm the system, press . You will hear two chirps and the parking lights will flash twice. If the siren chirps four times when disarm- ing, refer to the Diagnostics section of this guide. This is called Tamper Alert. If the siren is active (sounding) when the system is disarmed you will hear three chirps but the system is not disarmed. (Refer to the Remote Siren Silencing section of this guide.) However, if the alarm com- pletes the full trigger cycle when disarmed you will hear f
Resumen del contenido incluido en la página 12
8. Then once. 9. Then once. This enters the final digit 1. auto-immobilisation Immobiliser circuits automatically activate after 30-seconds. Auto-immobilisation sequence: 1. Turn ignition off or disarm alarm. 2. After 30-seconds the systems Immobilisation circuits activate and engage the starter and engine interrupts. 3. LED flashes at ½ normal speed. Disarm the system when immobilised: Use one of the following methods to turn off auto-immobilisation. Turn ignition on and press the button of t
Resumen del contenido incluido en la página 13
When you remote siren silence, the siren will either chirp 1 or 3 times. 1-chirp indicates that the system is still armed, and that all zones are inactive and being monitored. 3-chirps indicate that the system is still armed, and that at least one zone is still active and being bypassed. N NO OT TE E:: If 3-chirps sound the input that is bypassed will remain bypassed until the activation ceases. remote chirp muting (3-button remote only) To temporarily turn off the arm or disarm chirps, use remo
Resumen del contenido incluido en la página 14
remote sensor disable This can be performed anytime the system is armed. Follow the proce- dure listed below. 1. Arm the system. 2. Using the remote press and simultaneously. ® 3. The indicators will flash four times; all Warn Away zones of optionally installed sensors are now bypassed (zones two and three). 4. Using the remote press and simultaneously again. 5. The lights will flash four more times; All optional sensor Warn away and Full trigger zones and the Tilt Sensor are now bypassed 6. The
Resumen del contenido incluido en la página 15
auxiliary channel bypass All alarm sensor inputs will be bypassed while a pulsed or timed auxil- iary output is active. panic mode If you are threatened near your vehicle, you can attract attention by triggering the system with your remote! Just press for two sec- onds to enter Panic Mode. The siren will sound and the indicator lights will flash for the programmed duration (5-minutes maximum). To stop Panic Mode at any time press on the remote again. valet mode You can prevent your security syst
Resumen del contenido incluido en la página 16
remain on if Valet Mode has been entered. The LED status indicator will light steadily if you are entering Valet Mode. N No otte e:: The LED will turn off when the ignition is ON. To exit Valet Mode: 1. Turn the ignition On. 2. Enter your PIN code as described previously 3. When you enter the last digit the LED will light up, contin- ue to hold the button. 4. The system will exit Valet mode and the status LED indicator will extinguish. N NO OT TE E:: If One-time Valet is programmed On by your
Resumen del contenido incluido en la página 17
instant auto-arming bypass This will bypass the auto arm feature once only. 1. With the key, turn the ignition on, then off within two seconds. 2. The siren will chirp once to confirm auto arming bypass. 3. The system will not auto arm. n no otte e:: The system will revert to normal auto arming when the system sees the ignition on for at least three seconds and then turned off, or the system is armed and disarmed with the remote. During auto arming bypass the system will not auto-activate the a
Resumen del contenido incluido en la página 18
n no otte e:: Arming and disarming the system does not reset this function.The only ways to reset a bypassed zone are for it to not trigger for 60 min- utes, or to turn on the ignition. If testing your system, it is important to ® remember that the NPC programming can cause zones to be bypassed and appear to stop working. If five chirps are heard when ® ® disarming, NPC has been engaged. If you wish to clear the NPC memory, turn the ignition key on. ® NPC is On/Off programmable. See your dealer
Resumen del contenido incluido en la página 19
diagnostics The microprocessor at the heart of your security system is constantly monitoring all of the switches and sensors that are connected to it. It detects any faulty switches and sensors and prevents them from dis- abling the entire system. The microprocessor will also record and report any triggers that occurred during your absence. arming diagnostics If the system is armed while an input is active (sensor triggering, etc.) the unit will chirp once when arming and then once more five sec
Resumen del contenido incluido en la página 20
disarming diagnostics Extra disarm chirps are the Tamper Alert. If four chirps are heard when disarming, the system was triggered in your absence. If four chirps are heard, the LED status indicator will indicate which zone was triggered when the ignition is turned on and will repeat 5-times (refer to the Arm/Disarm Diagnostic Chart and Table of Zones section). The system will retain this information in its memory. Refer to the Multiple Event Total Recall section of this guide. arm/disarm diagnos
