Resumen del contenido incluido en la página 1
Contents
Before driving
Introduction 2
Instrumentation 3
Controls and features 26
Seating and safety restraints 71
Starting and driving
Starting 90
Driving 95
Roadside emergencies 109
Servicing
Maintenance and care 126
Capacities and specifications 160
Reporting safety defects 166
Index 167
All rights reserved. Reproduction by any means, electronic or mechanical
including photocopying, recording or by any information storage and retrieval
system or translation in whole or part is not permitted w
Resumen del contenido incluido en la página 2
Introduction ICONS Indicates a warning. Read the following section on Warnings for a full explanation. Indicates vehicle information related to recycling and other environmental concerns will follow. Correct vehicle usage and the authorized disposal of waste cleaning and lubrication materials are significant steps towards protecting the environment. WARNINGS Warnings provide information which may reduce the risk of personal injury and prevent possible damage to others, your vehicle and its equip
Resumen del contenido incluido en la página 3
Instrumentation 3
Resumen del contenido incluido en la página 4
RESUME SET ACCEL COAST SRS OFF ON Instrumentation Headlamp control Instrument cluster (pg. 26) (pg. 6) Turn signal and wiper/washer control (pg. 35) 60 56 4 7 40 80 ABS — + 100 80 120 3 F 60 km/h TURN ON 140 HEAD 100 2 20 40 LAMPS 160 T/C E 20 180 OFF 1 H 200 0 AIR FILL ON RIGHT 120 RPMx1000 0 MPH BAG SERVICE 0 ENGINE ! P SOON C BRAKE HI LO OFF LIGHTS 0FF AUTO P LAMP Instrument panel Auto lamp dimmer switch Driver air bag Speed control (pg. 27) (pg. 27) (pg. 80) (pg. 36) 4 M R O N
Resumen del contenido incluido en la página 5
I T N O C Instrumentation Clock Electronic sound Electronic sound system Message Center control (pg. 12) (pg. 33) system; refer to (pg. 35) Audio Guide (pg. 33) SYSTEM DRIVER ID SELECT MENU VEHICLE HANDLING DISPLAY TRIP RESET 000000.0 DTE ECON BASS BAL SEL VOL TREB FADE PUSH ON CD TAPE EJ RDS SEEK TUNE SCAN AUTO MUTE 3 4 12 56 AM FM REW FF SIDE 1 2 COMP SHUFF FRONT REAR MAX EXT OFF AUTO A/C HI BACK BACK HI 0 0 OFF BOTH BOTH OFF HEATED SEATS Heated seat control* Climate controls* Climate control
Resumen del contenido incluido en la página 6
Instrumentation WARNING LIGHTS AND CHIMES 60 56 4 7 40 80 ABS – + 100 80 120 3 F km/h 60 TURN ON 140 HEAD LAMPS 20 100 2 40 160 T/C E 20 180 OFF 1 H 0 200 AIR FILL ON RIGHT 120 RPMx1000 0 MPH BAG SERVICE 0 000000.0 ENGINE ! P SOON C BRAKE Service engine soon Your vehicle is equipped with a SERVICE computer that monitors the engine’s ENGINE emission control system. This SOON system is commonly known as the On Board Diagnostics System (OBD II). This OBD II system protects the environment by ensur
Resumen del contenido incluido en la página 7
Instrumentation These temporary malfunctions can be corrected by filling the fuel tank with good quality fuel and/or properly installing and securely tightening the gas cap. After three driving cycles without these or any other temporary malfunctions present, the Service Engine Soon light should turn off. (A driving cycle consists of a cold engine startup followed by mixed city/highway driving.) No additional vehicle service is required. If the Service Engine Soon light remains on, have your veh
Resumen del contenido incluido en la página 8
Instrumentation Anti-lock brake system (ABS) Momentarily illuminates when the ignition is turned to the ON position ABS and the engine is off. If the light remains on, continues to flash or fails to illuminate, have the system serviced immediately. Turn signal Illuminates when the left or right turn signal or the hazard lights are turned on. If one or both of the indicators stay on continuously or flash faster, check for a burned-out turn signal bulb. Refer to Exterior bulbs in the Maintenance a
Resumen del contenido incluido en la página 9
Instrumentation Engine oil pressure Illuminates when the oil pressure falls below the normal range. Stop the vehicle as soon as safely possible and switch off the engine immediately. Check the oil level and add oil if needed. Refer to Engine oil in the Maintenance and Care chapter. This lamp also illuminates when the ignition is turned to ON and the engine is off. Traction ControlY off light Illuminates when the Traction Controly system has been disabled T/C (by the driver or as a result of a OF
Resumen del contenido incluido en la página 10
Instrumentation GAUGES 60 56 – + 4 7 40 80 ABS 100 80 120 3 F km/h 60 TURN ON 140 HEAD LAMPS 20 100 2 40 160 T/C E 20 180 OFF 1 H 0 200 AIR FILL ON RIGHT 120 RPMx1000 0 MPH BAG SERVICE 0 000000.0 ENGINE ! P SOON C BRAKE Fuel gauge Displays approximately how much fuel is in the fuel tank (when the F key is in the ON position). The fuel gauge may vary slightly when the vehicle is in motion. The ignition should be in the OFF position while E the vehicle is being refueled. When the gauge first indi
Resumen del contenido incluido en la página 11
Instrumentation Tachometer Indicates the engine speed in 56 revolutions per minute. 4 7 ABS 3 Driving with your tachometer pointer in the red zone may damage 2 the engine. ANTI THEFT 1 AIR RPMx1000 BAG 0 Engine coolant temperature gauge Indicates the temperature of the engine coolant. At normal operating H temperature, the needle remains within the normal area (the area between the “H” and “C”). If it enters the red section, the engine is overheating. Stop the vehicle as C soon as safely possibl
Resumen del contenido incluido en la página 12
Instrumentation ELECTRONIC MESSAGE CENTER The electronic message center only SYSTEM works when the ignition is in the ON position. E/M The message center tells you about the condition of your vehicle by two methods: MENU SELECT ² operator selectable features VEHICLE HANDLING ² continuous warning reporting of monitored systems You can select different features for TRIP DISPLAY the message center to display by DTE ECON using the message center controls RESET located to the right of the instrument
Resumen del contenido incluido en la página 13
Instrumentation System check Pressing this control causes the SYSTEM message center to cycle through a status of each of the systems being monitored. For each of the monitored systems, the message center will indicate either an OK message or a warning message for three seconds. The sequence of the system check report is as follows: ² voltage level ² engine temperature ² oil level ² engine coolant level ² washer fluid level ² doors closed (driver and passenger side). This message can only be rese
Resumen del contenido incluido en la página 14
Instrumentation Door Ajar Cannot be reset Driver’s Door Ajar Check Engine Temp Warning returns after 10 minutes Transmission Overheat Check Transmission Low Oil Level Check Charging System Low Fuel Level Low Engine Coolant Low Tire Pressure (if equipped) Gear Display Data ERR Warning reappears after key is turned from OFF to ON Brake Lamp Out Check Traction Control Check Ride Control Trunk Ajar Check Steering Assist Low Washer Fluid Air Leveling Disabled Tail Lamp Out Check FRT Turn Lamps Turn o
Resumen del contenido incluido en la página 15
Instrumentation DTE/ECON ² Press the DTE/ECON control DTE ECON once to display the approximately how far you can drive before running out of fuel, or the distance to empty (DTE). To ensure accuracy, turn the ignition OFF when you fill the tank. ² Press the DTE/ECON control a second time to display the average fuel economy in liters/100 kilometers or miles/gallon, based on distance traveled and rate of fuel used information. ² To reset this feature, press the RESET RESET control while average fu
Resumen del contenido incluido en la página 16
Instrumentation RESET Press this control to reset: RESET ² warnings ² average fuel economy ² trip odometers The other selectable features are unaffected by pressing RESET. DISPLAY Press this control to turn the DISPLAY message center display off. Press it again to turn the display on. Warnings override an off display and must be reset for the display to be off again. VEHICLE HANDLING Press this control once to adjust VEHICLE HANDLING RIDE CONTROL SETTINGS (if equipped) between NORMAL, PLUSH and
Resumen del contenido incluido en la página 17
Instrumentation Traction control Refer to Traction Controly for more information. Express window ² Standard vehicle setting is saved as vehicle setting only (not the Driver 1 or 2 individualized profiles). ² Standard vehicle with Memory Profile System: setting may be saved to either Driver 1 or 2 personalized profiles or as a vehicle setting. ² Settings: ON or OFF. ² Original setting: ON. ² Setting adjustment is made using the message center MENU/SELECT controls. Auto door locks ² Standard vehic
Resumen del contenido incluido en la página 18
Instrumentation ² Standard vehicle with Memory Profile System: setting may be saved to either the Driver 1 or 2 personalized profiles or as a vehicle setting. ² Settings: ON or OFF. ² Original setting: ON. ² Setting adjustment is made using the message center MENU/SELECT controls. Reverse mirrors ² Standard vehicle: setting is saved as vehicle setting only (not the Driver 1 or 2 individualized profiles). ² Standard vehicle with Memory Profile System: setting may be saved to either the Driver 1 o
Resumen del contenido incluido en la página 19
Instrumentation Autolamp on/delay time Standard vehicle with Memory Profile System: setting may be saved to either the Driver 1 or 2 personalized profiles or as a vehicle setting. Instrument panel dim control setting ² Standard vehicle: setting is saved as vehicle setting only (not the Driver 1 or 2 individualized profiles). ² Standard vehicle with Memory Profile System: setting may be saved to either the Driver 1 or 2 personalized profiles or as a vehicle setting. ² Settings: variable. ² Origin
Resumen del contenido incluido en la página 20
Instrumentation settings (not individualized settings). To change a feature setting see Driver profile features in this section. Associated systems Keyless Entry System Programming personalized codes: With a key and/or Key FOB outside of the vehicle: ² Enter the factory code ² Press the 1/2 control ² Enter the five digit personalized code Press: ² The 1/2 control to save the code as Driver 1. ² The 3/4 control to save the code as Driver 2. ² The 5/6 control to save as a third code that will not
