Resumen del contenido incluido en la página 1
®
Culligan
®
Iron-Cleer
Automatic
Water Filter
Owners Guide
Resumen del contenido incluido en la página 2
Resumen del contenido incluido en la página 3
THANK YOU AND WELCOME TO YOUR NEW WORLD OF BETTER LIVING WITH CULLIGAN WATER. ® ® The Culligan Iron Cleer water filters have been tested and certified by WQA against WQA-200 for the effective reduction of iron up to 1,400 gallons for 10” units and 2,000 gallons for 12” units. Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system. This system and its installation must comply with state and local regulations. The S
Resumen del contenido incluido en la página 4
Specifications. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Table of Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Contents Operating Conditions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Familiarization . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Resumen del contenido incluido en la página 5
® ® Culligan Iron Cleer Filters Specifications 10” Iron Cleer 12” Iron Cleer 1” 5-cycle reinforced 1” 5-cycle reinforced Control Valve thermoplastic thermoplastic Timer Electro-mechanical Electro-mechanical Overall Conditioner Height 67” 65” Media Tank Dimensions (D 2 ea. 10” x 54” tanks 2 ea. 12” x 52” tanks x H) Filter Media Type 1.0 cu. ft. birm 1.5 cu. ft. birm Underbedding G-50 35 lbs. 35 lbs. Cullsan U 25 lbs. 25 lbs. 1 Capacity 1400 gallons 2000 gallons 2 Freeboard 21” 18” Ma
Resumen del contenido incluido en la página 6
Operation Introduction Step 1. Aeration Operation Service Cycle In the service cycle, raw water enters the inlet port of the aeration tank and is directed through the inlet diffuser. The oxidation process begins when the water passes through the inlet diffuser and cascades through a head of air. This air/ water contact oxidizes the iron, manganese, hydrogen sulfide in the water. The water is directed toward the bottom of the tank and travels through the pick- up tube. It then passes through t
Resumen del contenido incluido en la página 7
Shuttle Valve Operation In the service position, water pressure holds the shuttle valve piston in the closed position, trapping the airhead in the aeration tank and closes the air recharge inlet port and drain port. During air recharge cycle, air pressure is greater than the water pressure and forces the shuttle valve piston in the open piston. The shuttle valve has an internal pressure relief valve that will relieve pressure (greater than 100 psi) that may build up in the aeration tank. Thi
Resumen del contenido incluido en la página 8
The concentration limits listed below reflect the maximum individual limit that each contaminant was Operating tested for separately without any interference of other contaminants in the influent water. Conditions In reality, however, we know that these contaminants may be present in combination which may limit the filter’s ability to remove these contaminants in higher concentrations. In some cases, individual sellers of this equipment have had success removing higher concentrations of cont
Resumen del contenido incluido en la página 9
Power Loss Familiarization ® The AccuSoft circuit board is equipped with a Hi-Cap Capacitor and EEPROM memory chip. The capacitor is capable of maintaining the time, for at least two days, in the event of a power outage. The EEPROM ensures that the individual programming parameters of your filter are not lost. If the power outage lasts long enough to drain the Hi-Cap Capacitor, the control will flash “12:00 PM” when power is returned to the control. The unit will continue to keep time from th
Resumen del contenido incluido en la página 10
Make sure either inlet water supply is turned off, then supply power to the timer. The display will power Programming up flashing “12:00 PM” and the motor will energize and cycle the control, without stopping, the home position. This is required to ensure that the control is in the home position. The timer uses four buttons: Button Description Set-up / Enter Key Advance timer through (Status) display options Regeneration Key Initiate a regeneration (REGEN) Toggle Down Key (“-”) Decrease the s
Resumen del contenido incluido en la página 11
Pressing the “Status” key will save the setting and move to the next programming step. Settline Time This setting is used to set the time in minutes for cycle 2. This cycle is usually brine draw / slow rinse for softeners and a settling time for filters. The display will show “br” in the left most digits and the cycle time in the right most digits. Adjust the value with the “+” or “-” keys. Pressing the “Status” key will save the setting and move to the next programming step. Fast Rinse T
Resumen del contenido incluido en la página 12
Normally, all water except outside lines passes through the water filter. There are times when the When and ® water filter should be bypassed, using the Cul-Flo-Valv Bypass, or a 3-way bypass valve. You How to should bypass: Bypass Your 1. If lines to outside faucets do not bypass the water filter, and you do not want to waste soft water on lawn sprinkling or other outside uses. Water Filter 2. If you are going away on vacation and want to save salt by not having the unit recharge while yo
Resumen del contenido incluido en la página 13
Aeration Tank Bypass Valve Aeration Tank – Bypass Valve Operation Bypass Operation Normal Operation “Treated” Water Supply Water Supply Water Supply Water Exits Enters Exits Enters Diagnostic Mode Shut-Off Mode Supply Water Supply Water No Water Supply Water is Shut Exits Enters Exits Off From The House and The Valve 9
Resumen del contenido incluido en la página 14
If you unexpectedly experience problem water, make these simple checks before calling your Things to Culligan dealer. One of the following conditions may be the reason for your interruption of service. Check Before You Call for Important Service If any of the following conditions is found, the water filter should be manually recharged according to instructions on page 5 after you have corrected the problem. Power Supply Check your power supply cord. Is it plugged fully into the electric ou
Resumen del contenido incluido en la página 15
Following these simple precautions will help assure continued trouble-free service and keep your Care and Culligan Water Conditioner looking like new for years. Cleaning of Your Water 1 Use only mild soap and warm water when cleaning the exterior of the conditioner. Never use harsh, abrasive cleaning compounds or those which contain acid, such as vinegar, bleach and Conditioner similar products. 2 Important: Protect your water conditioner and the entire drainline from freezing temperature
Resumen del contenido incluido en la página 16
Recommended Preventative Maintenance Preventative The Culligan Iron Cleer water filter has been designed to provide a good, consistent service life. Maintenance Because of the nature of problem water, we recommend that the local Culligan dealer provide regular maintenance/service contracts for the proper operation of your systems. The water filter service begins with a multi point inspection of your water filter system in an effort to uncover any and all problems that may exist. Listed
Resumen del contenido incluido en la página 17
Troubleshooting Complaint Problem Cause Solution Guide Iron bleed- A. Inadequate backwash 1. Plugged drain line flow 1. Call your Culligan through or of filter control dealer for service. staining. 2. Insufficient water supply 2. Check for minimum from well. specified flow and pressure requirements of filter system. 3. Plugged aeration tank 3. Call your Culligan inlet diffuser or pick-up tube. dealer for service. 4. Media bed fouled. 4. Call your Culligan dealer for service. B. Fails to r
Resumen del contenido incluido en la página 18
Complaint Problem Cause Solution Water leaking A. Dirt lodged 1. Pressure has exceeded 1. Call your Culligan dealer from relief valve. under seat of rating on relief valve and for service. valve. caused valve to open B. Faulty or 1. Call your Culligan dealer defective relief for service. valve Water is A. This can be 1. Water supply has been 1. This natural phenomenon effervescent expected when naturally aerated under will typically dissipate to the water is aerated well system pressure. As
Resumen del contenido incluido en la página 19
Complaint Problem Cause Solution Excessive A. Howling 1. Inadequate drain line 1. Call your Culligan dealer noise during or whistling size. for service. regeneration. noise during regeneration cycle. 2. Drain line is vibrating 2. Call your Culligan dealer against other pipes, for service. conduits, pipe hangers, heat ducts, floor joists,etc. Water is A. Control 1. Electrical service 1. Assure continuous running to drain valve is stuck to control(s) has been electrical service is available.
Resumen del contenido incluido en la página 20
® ® Culligan 10” and 12” Iron-Cleer Water Filters Performance Important Notice — Read this data sheet and compare the capabilities of the unit to your actual Data Sheet water treatment needs. Culligan recommends that you have your water supply tested to determine these needs before purchasing a water treatment unit. Culligan knows the more informed you are about your water treatment system, the more confident you will be about its performance. It’s because of this more than sixty five yea
