Manual de instrucciones de NuTone Decorative Series Ceiling Ventilators 741WHNT

Resumen del contenido incluido en la página 1

MODELS 741BRNT • 741SNNT • 741WHNT • 741BRFLNT • 741WHFLNT
Page 1
DECORATIVE SERIES
CEILING VENTILATORS
READ AND SAVE THESE INSTRUCTIONS
WARNING
WARNING
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR IN- 7. NEVER place a switch where it can be reached from a tub or
JURY TO PERSONS, OBSERVE THE FOLLOWING:
shower.
1. Use this unit only in the manner intended by the manufacturer. If
8. Fluorescent models only: Do not use a dimmer switch to con-
you have questions, contact the manufacturer at the

Resumen del contenido incluido en la página 2

MODELS 741BRNT • 741SNNT • 741WHNT • 741BRFLNT • 741WHFLNT Page 2 TYPICAL INSTALLATIONS INSTALL THE HOUSING (continued) (continued) New Construction 4" ROUND DUCT POWER CABLE MOUNTING HOUSING TAB GRILLE SUSPENDED PAN CEILING GLASS MATERIAL LIGHT SHADE SUSPENDED CEILINGS 3. Set housing aside and drive nails partially into joist at the top of both keyhole marks. Housing hung with wires - 3-point mount. INSTALL THE HOUSING New Construction 1. Choose the location for your fan/light in the ceiling.

Resumen del contenido incluido en la página 3

MODELS 741BRNT • 741SNNT • 741WHNT • 741BRFLNT • 741WHFLNT Page 3 INSTALL THE HOUSING CONNECT THE WIRING (continued) SCHEMATIC WIRING DIAGRAM LIGHT RED BLU WHT LIGHT SWITCH (WHITE) Existing Construction VENT BLK BLK VENT WHT SWITCH (BLACK) BLK LINE WHT WHT IN GRD GRD SWITCH BOX UNIT WHITE BLACK RED RECEPTACLE (LIGHT) WHITE GROUND (bare) BLUE BLACK DUAL CONTROL RECEPTACLE (purchase separately) SWITCH BOX (FAN) 4. Place housing in opening so that its bottom edge is flush LIGHT with finished ceil

Resumen del contenido incluido en la página 4

MODELS 741BRNT • 741SNNT • 741WHNT • 741BRFLNT • 741WHFLNT Page 4 USE AND CARE USE AND CARE WARNING: DISCONNECT ELECTRICAL POWER SUPPLY AND CLEANING LOCK OUT SERVICE PANEL BEFORE CLEANING OR SERVIC- ING THIS UNIT. TO CLEAN GLASS SHADE AND GRILLE PAN: BULB REPLACEMENT Remove finial nut and finial cap and remove glass shade. Shade can be wiped clean with a mild detergent solution or glass cleaner Remove finial nut and cap and remove glass shade. Replace bulb or bulbs as required. Replace glass s