Resumen del contenido incluido en la página 1
Operating and Installation
Instructions
Ventilation System
DA 279-4
To prevent accidents
UV
and machine damage,
read these instructions
before
installation or use. M.-Nr. 06 713 420
Resumen del contenido incluido en la página 2
Contents IMPORTANT SAFETY INSTRUCTIONS Functional description Guide to the appliance Operation Turning on the fan . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10 Selecting the power level. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10 Delayed Shut Down . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12 Turning off the fan . . . . . . . . . . . . . . . .
Resumen del contenido incluido en la página 3
IMPORTANT SAFETY INSTRUCTIONS Read these Operating Instructions carefully before installing or using the Ventilation System. This appliance is designed to vent This appliance is intended for cooking smoke and odors only. residential use only. Use the Be certain your appliance is appliance only for its intended properly installed and grounded by purpose. The manufacturer cannot a qualified technician. be held responsible for damages To guarantee the electrical safety of this caused by improper us
Resumen del contenido incluido en la página 4
IMPORTANT SAFETY INSTRUCTIONS This equipment is not designed for Use maritime use or for use in mobile Do not allow children to play with installations such as recreational or operate the appliance or its vehicles or aircraft. However, under controls. Supervise its use by the certain conditions it may be possible for elderly or infirm. installation in these applications. Please contact the nearest Miele dealer or the Be careful when preparing a Technical Service Department with flambé beneath th
Resumen del contenido incluido en la página 5
IMPORTANT SAFETY INSTRUCTIONS , WARNING - TO REDUCE , WARNING TO REDUCE THE RISK OF INJURY THE RISK OF A COOKTOP TO PERSONS IN THE EVENT OF A GREASE FIRE: COOKTOP GREASE FIRE, OBSERVE Never leave surface units THE FOLLOWING: unattended at high settings. SMOTHER FLAMES with a close Boilovers cause smoking and greasy fitting lid, cookie sheet, or metal spillovers may ignite. Heat oils slowly tray then turn off the burner. on low or medium settings. BE CAREFUL TO PREVENT BURNS. Always turn the hood
Resumen del contenido incluido en la página 6
IMPORTANT SAFETY INSTRUCTIONS Installation Any fittings, sealant, or materials used to install the ductwork must , WARNING be made of approved non-flammable To reduce the risk of fire only materials. use metal ductwork. Never connect an exhaust hood to When installing the hood, follow the an active chimney, dryer vent, vent recommended minimum safety flue, or room ventilating ductwork. Seek distances between a Miele cooktop and professional advice before connecting the hood: an exhaust hood vent
Resumen del contenido incluido en la página 7
Functional description The hood offers two modes of operation: Air extraction Recirculation mode The air is drawn in and cleaned by the Air is drawn through the grease filters grease filters and directed outside. and an active charcoal filter. The filtered air is then recirculated back into The hood comes equipped with a the kitchen through a vent at the top of non-return flap. This flap automatically the hood’s chimney. closes when the hood is turned off so that no exchange of outside air and T
Resumen del contenido incluido en la página 8
Guide to the appliance 8
Resumen del contenido incluido en la página 9
Guide to the appliance a Chimney extension o Grease filter button The indicator next to the grease filter b Chimney button lights when the grease filters need to be cleaned. This button is also c Canopy used: – to reset the grease filter timer after d Control panel cleaning the grease filters (see "Cleaning and Care"). e Grease filter – to show how long the grease filters have been in use (see "Operation/ f Recirculation vent Filter timers"). – to change the number of hours g Indirect lighting c
Resumen del contenido incluido en la página 10
Operation Turning on the fan Automatically switching back the Intensive power level The intensive level "4" can be programmed to automatically switch back to level "3" after 10 minutes. ^ Press the On/Off button. ^ Turn the fan and the lights off. Selecting the power level ^ Press and hold the Delay Shut Down button for 10 secs. The first indicator ^ Use the "–/+" controls to select the of the fan power levels lights. desired power level. ^ Press the following buttons one after + = increases the
Resumen del contenido incluido en la página 11
Operation Fan performance The maximum air flow capacity is 625 cfm. Factors such as narrow duct diameter and bends will affect this If the power level indicators "1" and "4" value. flash the automatic switch back is not Level 1 operates at 40% capacity activated. Level 2 operates at 60% capacity ^ To activate the automatic switch back Level 3 operates at 80% capacity press the "+" button. Level 4 operates at 100% capacity The power level indicators "1" and "4" There will also be a slight decreas
Resumen del contenido incluido en la página 12
Operation Delayed Shut Down Turning off the fan If odors or smoke remain in the kitchen after cooking has been completed, the Delayed Shut Down feature can be selected to allow the hood to continue running for either 5 or 15 minutes. ^ Press the On/Off button to turn the fan off. The indicator will go out. Automatic Safety Shut Off ^ Press the Delayed Shut Down button The fan will turn off automatically while the fan is still running. 10 hours after the last button was Press once = 5 minute dela
Resumen del contenido incluido en la página 13
Operation Turning the lighting on/off Indirect lighting The overhead lighting can be turned on and off independently from the fan. ^ Turn the indirect lighting on and off with the left light button. ^ Press the right light button briefly to ^ The indirect lighting can be operated turn on the lighting. independently from the fan. The light button indicator illuminates. ^ Press the right light button briefly again to turn off the lighting. The light button indicator will go out. Dimming the lighti
Resumen del contenido incluido en la página 14
Operation Filter timers Checking the filter timers To check the percentage of time Grease filters already used: A timer monitors the hours of fan operation. The indicator for the grease filter will light after 30 hours of operation. The grease filters must then be cleaned. ^ Press the On/Off button to turn the fan on. After the grease filters have been cleaned and put in place, the grease filter timer must be reset. ^ To do this, press the grease filter button for about 3 seconds. ^ Press and ho
Resumen del contenido incluido en la página 15
Operation Reprogramming the timers The grease filter timer is preset to 30 hours. This time can be lengthened or shortened to 20, 30, 40, or 50 hours. The indicator for the grease filter and – A time of 20 hours should be one of the "–/+" indicators will flash. programmed in kitchens with The lit indicator shows the programmed frequent pan or deep frying. time: – A time of 20 hours should also be 1st indicator from the left = 20 hours programmed if the kitchen is only 2nd indicator from the left
Resumen del contenido incluido en la página 16
Operation Reprogramming the charcoal filter timer The active charcoal filter can only be used in recirculation mode and cannot The indicator for the charcoal filter and be used to exhaust fumes. one of the "–/+" indicators will flash. The charcoal filter timer is not preset. The lit indicator shows the programmed Before using the hood in recirculation time: mode, the charcoal filter timer must be 1st indicator from the left = 120 hours programmed. 2nd indicator from the left = 180 hours 3rd indi
Resumen del contenido incluido en la página 17
Cleaning and Care Stainless steel Before cleaning or servicing the hood, disconnect it from the power Stainless steel surfaces can be cleaned supply by either removing the fuse, using a non-abrasive stainless steel unplugging it from the outlet, or cleaner. manually "tripping" the circuit To help prevent resoiling, a conditioner breaker. for stainless steel can be applied. Cleaning the casing Stainless steel colored controls Warning: Never use abrasive These controls may become dis- cleaners, sc
Resumen del contenido incluido en la página 18
Cleaning and Care Grease filters ^ In a dishwasher: place the filters vertically in the lower basket, making The reusable metal grease filters sure that the spray arm is not remove solid particles from the vented blocked. kitchen air (grease, dust, etc). Use a hot temperature program, e.g. "Heavy Soil" or "Pots and pans". Use the recommended amount of dishwasher detergent. Overuse could destroy the filter. The grease filters should be cleaned every 3 - 4 weeks or when the grease Depending on the
Resumen del contenido incluido en la página 19
Cleaning and Care Active charcoal filter In recirculation mode an active charcoal filter must be used in addition to the grease filters. It is designed to absorb cooking odors. The active charcoal filter will be replaced in the canopy above the grease filters. ^ Insert the charcoal filter. Replacement active charcoal filters can be ordered from Miele. Before using: ^ Program the charcoal filter timer, see ^ Remove the grease filters to access "Operation / Reprogramming the the charcoal filter. S
Resumen del contenido incluido en la página 20
Cleaning and Care Changing the light bulb Before changing the light bulbs, disconnect the hood from the power supply by either removing the fuse, unplugging it, or manually "tripping" the circuit breaker. When in use halogen bulbs become extremely hot, use caution. Do not ^ To change the halogen bulb first attempt to change the bulbs until remove the lamp cover, a. they have had sufficient time to cool. ^ Pull the bulb, b, out of its socket and Do not touch the bulb surface. replace with a new o
