Manual de instrucciones de Sharp XE-A101

Resumen del contenido incluido en la página 1

WARNING
SHARP ELECTRONIC CASH REGISTER
FCC Regulations state that any unauthorized changes or modifications to this equipment not
MODEL
expressly approved by the manufacturer could void the user’s authority to operate this equipment.
Note: This equipment has been tested and found to comply with the limits for a Class A digital device,
XE-A101
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when this equipment is operat

Resumen del contenido incluido en la página 2

Entries TAX1 SHIFT transactions. Non-add code numbers can be entered To make all entries up to that point non-taxable, press /RA 5 7 in the REG or VOID mode. @/TM 3 @/TM 3 TAX2 #/ SHIFT 1 3 and , then SBTL , and v. Subsequent entries in the /PO Operation Examples #/ transaction remain unaffected and will be taxed normally. CHK SBTL Non-add code number entry procedure: When Paid by Cash Manual Tax a code number of up to 8 digits ➝ s. 1. Set the mode switch to the REG position. Single Item Cash Sa

Resumen del contenido incluido en la página 3

Programming where R, M and Q represent the following: B, C, D and E: Choice of taxable status Before you begin programming, set the mode switch to Tax Programming Enter 0000 for non-taxable, 0001 for taxable 1, R: Tax rate (0.0000% to 99.9999%) x 10000 the Z/PGM position. 0010 for taxable 2, 0100 for taxable 3, 1000 for If the rate is fractional, it should be converted to its VOID OFF X/F Tax Table Programming taxable 4 or 0011 for taxable 1 and 2. decimal equivalent before entering. REG Z/PGM I

Resumen del contenido incluido en la página 4

5. Install three new “AA” batteries into the 5. Remove the used journal paper roll (if used) Maintenance Drawer Handling battery compartment. from the take-up spool. Batteries Locking the Drawer This cash register provides a low battery symbol Develop the habit of locking the drawer when not (l) and a no battery symbol (l) which appears on using the register for any extended period of time. the far left of the display in one of the following situations: To lock: Insert the key into the drawer l