Resumen del contenido incluido en la página 1
Resumen del contenido incluido en la página 2
Any changes or modifications in construction of this device which is not expressly approved by the party responsible for compliance could void the user s authority to operate the equipment. Warning : Do not watch TV while vehicle in Motion it Can be Hazardous
Resumen del contenido incluido en la página 3
Safety precaution WARNING For your safety, the driver should not watch the TV or operate the controls while driving. Please note that watching and operating the TV while driving are prohibited by law in some countries. Also, while driving, keep the volume to a level at which external sounds can be heard. To prevent injury or fire, take the following precautions: Insert the unit all the way in until it is fully locked in place. Otherwise it may fall out of place when jolted. When extending the i
Resumen del contenido incluido en la página 4
CONTENTS Safety Precaution (p4) About CDs (p5) Introduction (p6) 1. Region Number .......................................... (p6) 2. Control Parts .............................................. (p6) 2-1. With Display Closed ............................ (p7) 2-2. With Display Opened .......................... (p8) 3. Head unit Rear Panel ................................. (p9) 4. Battery ........................................................ (p10) 5. Remote Control key ..........................
Resumen del contenido incluido en la página 5
Safety precaution The marking of products using lasers (Except for some areas) The label is attached to the chassis / case and says that the component uses laser beams that have been classified as Class 1. It CLASS 1 means that the unit is utilizing laser beams LASER PRODUCT that are of a weaker class. There is no danger of hazardous radiation outside the unit. NOTE If you experience problems during installation, consult your PYLE dealer. If the unit fails to operate properly, press the Reset bu
Resumen del contenido incluido en la página 6
Safety precaution Cleaning the Faceplate terminals If the terminals on the unit or faceplate get dirty, wipe them with a dry, soft cloth. Cleaning the Unit If the front panel of this unit is stained, wipe it with a dry soft cloth such as s silicon cloth. If the front panel is stained badly, wipe the stain off with a cloth moistened with neutral cleaner, and then wipe neutral detergent off. Applying spray cleaner directly to the unit may affect its mechanical parts. Wiping the front panel with a
Resumen del contenido incluido en la página 7
About CDs Handling CDs Removing CDs When removing CDs from this unit,pull Don t touch the recording surface of the them out horizontally. CD. CDs that can t be used CDs that aren t round can t be used. CD-R and CD-RW are easier to damage than a normal music CD. Use a CD-R or a CD-RW after reading the caution items on the package etc. CDs with coloring on the recording Don t stick tape etc. on the CD. Also, surface or that are dirty can t be used. don t use a CD with tape stuck on it
Resumen del contenido incluido en la página 8
INTRODUCTION Notice. “DVD Logo” is a trademark of DVD Format/Logo Licensing Corporation 1. Region Number The region number of this Unit is labeled on the rear panel of the unit. Most DVD s are manufactured specifically for sale and use in a specific geographic region. A disc s Region Number must correspond to the Region Number of this Unit. If the Region Number of a disc is different from the Region Number of the this Unit, playback will not be possible. This DVD Player is designed for use in
Resumen del contenido incluido en la página 9
INTRODUCTION WITH THE DISPLAY CLOSED Volume Up/Down Use this button to increase/decrease the volume. Tilt Use this button to adjust the angle of the TFT LCD panel in 3 steps and every time this button is pressed with being held for about 2 second or longer, the TFT LCD panel moves backward with 2 steps & forward with 1 step. Open/Close Use this button to Open/Close the TFT LCD Panel. Press Open button about 2 Seconds or longer and then, the TFT LCD Panel Should be horizontally held for con
Resumen del contenido incluido en la página 10
INTRODUCTION Track/CH Up/Down - Use this button to tune to a station to be stored in the radio/TV mode . 1) Track up key with pressing over 2 seconds should be Radio Frequency or TV Channel memory. 2) Track down key with pressing over 2 seconds should delete Radio Frequency or TV Channel to be momorized. - Use this button to select a track in audio CD, MP3. - Use this button to select a chapter in the DVD video. Seek & Tuning Up/Down -Radio Mode: The unit starts to seek next station. -TV
Resumen del contenido incluido en la página 11
Resumen del contenido incluido en la página 12
INTRODUCTION 4. BATTERY Preparing & Using The Remote Control BATTERY INSTALLATION NOTICE (BATTERY) PLEASE FOLLOW THE INSTRUCTIONS BELOW. INCORRECT BATTERY USEAGE MIGHT CAUSE EARLY DISCHARGE, LEAKAGE OR CORROSION DAMAGE. * Do not insert battery in the wrong direction. Be sure to observe the correct polarity (+/-) as indicated in the battery compartment. * It is dangerous to charge/heat/open or short circuitry the battery. * Please remove the battery in case of not using the remote control fo
Resumen del contenido incluido en la página 13
INTRODUCTION 5. Remote Control Key Power/Mode Mute Open/Close Volume Up/Down AF/TA (RDS Function) PTY/ REG (RDS Function) Track (P.Seek/CH) Up/Down Band (OSD ON/OFF) Menu Enter Set Up DVD Menu Slow Disc (Seek/Manual) Up/Down Tilt/Navi (Navigation Function) Rear Monitor NTSC/PAL(DVD ONLY) P.S/BSM Play/Pause Stop/Eject Numeric Key Pad Repeat A-B Repeat (Random in CD Changer) Display (Intro in CD Changer) Title S-Title Audio Angle Zoom Goto PBC Aspect, Fine Tune Clea
Resumen del contenido incluido en la página 14
Connecting to Power & Multi Channel AV Control Unit System 1. Connecting to Power System The illustration below is showing power system connection. Please also refer to the owner s and installation manuals supplied with the associated equipment. If it doesn t have corrected connection, it may cause unexpected damage. 1-1. HEAD UNIT Notice Make sure the connection of Parking Brake wire. If it has no connection, the unit will not show any picture. Connect the Dimmer wire, otherwise its illumin
Resumen del contenido incluido en la página 15
Connecting to Power & Multi Channel AV Control Unit System 2. RT BOX 16P CONNECTOR WIRING DIAGRAM 13
Resumen del contenido incluido en la página 16
Connecting to Power & Multi Channel AV Control Unit System 3. Connecting to Multi Channel AV Control Unit System The Illustration below is just possible examples with our Multi Channel AV Control Unit System only. The exact connection method will vary depending on the specific components selected for a particular installation. Please also refer to the owner s and installation manuals supplied with the associated equipment. Don’t use both AV2 and DVD/VCD Changer Input at the same time because
Resumen del contenido incluido en la página 17
Connecting to Power & Multi Channel AV Control Unit System 4. Connecting to DVD Changer Control System Don’t use AV2 Audio L/ R input of RT Box when DVD Changer is Connected. You can just use only AV2 Video input of RT Box from DVD Changer Video output. In case of using CD Changer instead of DVD Changer, the AV2 of RT Box can not be availed. 15
Resumen del contenido incluido en la página 18
Connecting to Power & Multi Channel AV Control Unit System 5. Connecting to Multi Channel AV Control Unit System with Additional 6CH Amplifier The Illustration below is just possible examples for our Multi Channel AV Control Unit System with Additional 6CH Amplifier. The exact connection method will vary depending on the specific components selected for a particular installation. Please also refer to the owner s and installation manuals supplied with the associated equipment. NOTE In case of
Resumen del contenido incluido en la página 19
BASIC O OPERATION POWER ON/OFF CLOSING THE MONITOR 1. Hold the left and right upper side of the 1. POWER ON monitor parallel with the front of the 1) Press POWER button to turn the power unit as the picture below. on and the monitor will be automatically positioned vertically when the monitor is opened. 2. You can also turn the power on by pressing the OPEN button. The power will be turned on and the monitor will be opened. 2. Press OPEN button or POWER button, and then the monitor will be clo
Resumen del contenido incluido en la página 20
BASIC OPERATION 3. Use key and place cursor (Yellow 3. Use key and place cursor (Yellow bar) on the item you want to adjust (Ex. bar) on the item you want to adjust (Ex. Tone/ Volume) and press Contrast) and press ENTER key as picture above. ENTER key as picture below. 4. Press key to adjust the level of the selected item as picture below. 4. Use key and place cursor (Yellow bar) on the sub-item you want to adjust 5. Press ENTER key at least for 2 seconds (Ex. Bass) and press ENTER key as to r
