Manual de instrucciones de Metra Electronics 99-7318

Resumen del contenido incluido en la página 1

INSTALLATION INSTRUCTIONS FOR PART 99-7318
APPLICATIONS
2005-2006 Kia Spectra 5
99-7318
KIT FEATURES
• DIN Head Unit Provision
• ISO DIN Head Unit Provision
KIT COMPONENTS
A) Radio Housing l B) ISO Brackets l C) ISO Trim plate
B
A C
TOOLS REQUIRED:
Phillips Screwdriver • Small Flat Blade Screwdriver
1-800-221-0932 www.metraonline.com
© COPYRIGHT 2004-07 METRA ELECTRONICS CORPORATION

Resumen del contenido incluido en la página 2

99-7318 TABLE OF CONTENTS Dash Disassembly . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Kit Assembly . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2, 3 Final Assembly . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4

Resumen del contenido incluido en la página 3

DASH DISASSEMBLY 99-7318 2005-2006 KIA SPECTRA 5 A 1 Disconnect the negative battery terminal to prevent an accidental short circuit. 2 Unclip and remove entire panel sur- rounding radio and including A/C controls. (Figure A) 3 Remove (4) Phillips screws to extract radio from dash. (Figure B) B 1

Resumen del contenido incluido en la página 4

KIT ASSEMBLY 99-7318 2005-2006 KIA SPECTRA 5 DIN HEAD UNIT PROVISION A 1 Slide the DIN cage into the Radio Housing and secure by bending the metal locking tabs down. (Figure A) 2 Slide the aftermarket head unit into the cage and secure. (Figure B) B 2

Resumen del contenido incluido en la página 5

KIT ASSEMBLY 99-7318 2005-2006 KIA SPECTRA 5 ISO DIN HEAD UNIT PROVISION A 1 Mount the ISO bracket to the head unit with screws supplied with the unit. (Figure A) 2 Slide the head unit into the radio opening until the side clips engage. (Figure B) 3 Snap the trim plate into the radio housing. (Figure B) B 3

Resumen del contenido incluido en la página 6

FINAL ASSEMBLY 99-7318 FINAL ASSEMBLY A A) Strip wire ends back 1/2" B B) Twist ends together C) Solder C D) Tape D Locate the factory wiring harness in the dash. Metra recommends using the 1 proper mating adapter and making connections as shown. (Isolate and individually tape off the ends of any unused wires to prevent electrical short circuit.) 2 Re-connect the negative battery terminal and test the unit for proper operation. Reassemble radio and dash assemblies in reverse order of disassem

Resumen del contenido incluido en la página 7

FINAL ASSEMBLY 99-7318 NOTES 5

Resumen del contenido incluido en la página 8

99-7318 INSTRUCTIONS 1-800-221-0932 www.metraonline.com REV. 08/24/07 © COPYRIGHT 2004-07 METRA ELECTRONICS CORPORATION INST99-7318