Resumen del contenido incluido en la página 1
OWNER S MANUAL
PAV-9
MOTORIZED 7 IN-DASH
LCD COLOR MONITOR
WITH AM/FM STEREO RADIO
Resumen del contenido incluido en la página 2
Any changes or modifications in construction of this device that is not expressly approved by the party responsible for compliance could void the user s warranty.
Resumen del contenido incluido en la página 3
WARNING The exclamation point within an equilateral triangle and WARNING are intended to alert the user to the presence of important operating instructions. Failure to heed the instruction will result in severe injury or death DO NOT WATCH VIDEO WHILE DRIVING Watching the video may distract the driver from looking ahead of the vehicle and cause and accident. DO NOT OPERATE ANY FUNCTION THAT TAKES YOUR ATTENTION AWAY FROM SAFELY DRIVING YOUR VEHICLE Any function that requires your prolonged at
Resumen del contenido incluido en la página 4
CAUTION The exclamation point within an equilateral triangle and CAUTION are intended to alert the user to the presence of important operating instructions. Failure to heed the instruction can result in injury or material damage. DO NOT RAISE THE VOLUME EXCESSIVELY Keep the volume at a level where you can still hear outside noises while driving. Driving while unable to hear outside could cause an accident. DO NOT USE THIS EQUIPMENT OUTSIDE THE VEHICLE Do not use this equipment for purposes
Resumen del contenido incluido en la página 5
CAUTION The exclamation point within an equilateral triangle and CAUTION are intended to alert the user to the presence of important operating instructions. Failure to heed the instruction can result in injury or material damage. Operation of some of the functions of this unit is very complex. Because of this, it was deemed necessary to place these functions into a special SETUP screen. This will restrict operation of these functions to times when the vehicle is parked. This ensures the f
Resumen del contenido incluido en la página 6
INTRODUCTION MONITOR POWER ON/ OFF BUTTON MODE SELECTION BUTTON AS/ATM BUTTON SOUND MUTE BUTTON VOLUME UP/DOWN ADJUST BUTTON SEARCH UP/DOWN BUTTON OPEN/CLOSE BUTTON TILT UP/DOWN BUTTON BAND SELECTION BUTTON 4
Resumen del contenido incluido en la página 7
REMOTE CONTROL POWER ON/ OFF BUTTON MODE SELECTION BUTTON AS/ATM BUTTON SOUND MUTE BUTTON VOLUME UP/DOWN ADJUST BUTTON SEARCH UP/DOWN BUTTON OPEN/CLOSE BUTTON MANUAL MEMORY BUTTON ( MENU IN TV MODE) CHANNEL UP/DOWN BUTTON NAVIGATION BUTTON ASPECT BUTTON MENU SELECTION BUTTON 5
Resumen del contenido incluido en la página 8
REMOTE CONTROL UNIT Replacing battery Applicable battery : Use two AAA sized dry batteries. 1. Opening the battery cover. Push and slide the cover in the arrow direction, and the cover will be removed. 2. Replacing the battery. Remove the old batteries. Insert new ones matching the (+) and (-) polarities as shown in the diagram inside the unit. 3. Closing the cover. Push the cover in the arrow direction until a click is heard. 6
Resumen del contenido incluido en la página 9
BASIC OPERATION POWER ON / OFF PASSWORD 1. POWER ON 1) Press the POWER button to turn the power on and the monitor will open. When the monitor is opened, it requires a password as pictured above. Press the number button of the remote control to input 0000 and then the last mode will be displayed. 2) You can also turn the power on by pressing the OPEN/CLOSE button. The power will turn on and the monitor will open. 2. POWER OFF 1) Press the POWER button again to turn the power off. 2) If y
Resumen del contenido incluido en la página 10
TO CHANGE PASSWORD 1. Press the menu button repeatedly while in radio mode or AV mode until the volume menu is selected. The monitor displays following picture. 1. Press the search up/down button to select “password” to change the password. 2. Press the number buttons of the remote control to enter a new 4 digit password. NOTE If you forgot password, contact the dealer from whom you purchased the equipment. 8
Resumen del contenido incluido en la página 11
CLOSING THE MONITOR 1. Hold the left and right upper side of the monitor and set the left and right angle of the monitor parallel with the front of the unit as the picture above. 2. Press OPEN/CLOSE button or power button then the monitor will be closed. NOTE 1. If the left and right angle of the monitor is not parallel to the front of the unit, the monitor cannot be closed. 2. If the OPEN/CLOSE button is pressed while radio or video is on, the monitor will be closed. But the sound will stay on
Resumen del contenido incluido en la página 12
ADJUSTING THE SLIDE POSITION 1. Press the MENU button repeatedly on the radio or remote until the USER SELECT menu is displayed. 2. Press the SEARCH UP/DOWN button to select MOVE 3. Press the VOLUME button to select FORWARD. The monitor will slide one step (.6 to the left. 4. Press the VOLUME button to select BACKWARD. The monitor will slide one step (.6 ) to the back. For more information, see page 21 of owner s manual. NOTE : The screen must be in tilt position 1 or 2 to allow the b
Resumen del contenido incluido en la página 13
SELECTING MODE Press the MODE button to select the desired mode. Each time you press the button, the mode changes as follows. RADIO -> AV1 -> AV2 -> AV3 (CD/DVD CHANGER) -> AV4 (TV) NOTE 1. AV3 has only a video input. 2. The CD/DVD changer must be connected to the 8 pin DIN socket on the rear of the unit with 8 pin DIN cable in our CD or DVD changer gift box. 3. The video output of CD or DVD changer must be connected to the AV3 video input. If the video output of changer is not connected to
Resumen del contenido incluido en la página 14
ADJUSTING THE TV/VIDEO PICTURE MODE (ASPECT) Each time you press A (ASPECT) button, the picture mode switches between Normal, Full, Zoom and Wide. NORMAL MODE The monitor displays normal picture at the center of the screen with the proportion of 4 to 3. The screen shows a vertical black belt at each side. FULL MODE The monitor displays normal picture wider by stretching out horizontally with the proportion of 16 to 18. ZOOM MODE The monitor displays normal picture wider by stretch8ng out horizo
Resumen del contenido incluido en la página 15
RADIO CONTROL Press the OPEN/CLOSE button to turn the power on and open the monitor. The monitor shows following picture NOTE 1. Each time you press the MENU button on RADIO MAIN MENU screen, the menu on the screen changes as follows. RADIO SUB -> VOLUME -> USER SELECT -> PICTURE -> RADIO MAIN 2. You can select the items on each menu by pressing the SEARCH UP/DOWN button. 3. You can adjust the level of the selected items by pressing the VOLUME UP/DOWN button. MANUAL TUNING Press the CH UP/
Resumen del contenido incluido en la página 16
AUTO MEMORY OF STATION 1. Press the AS/ATM button for at least 2 seconds. The frequency on the display continues to change while the auto memory is in progress. The tuner will automatically seek and can store up to 30 stations in each band in order of frequency signal. They can be stored in FM 1 : 30, FM 2 : 30, AM 1 : 30 and AM 2 : 30 stations (total 120 stations). 2. When the auto memory has been completed, the tuner goes to the station stored in the CH no. 1. NOTE In DISC CHANGER mode, you
Resumen del contenido incluido en la página 17
RADIO BAND 1. Press the SEARCH UP/DOWN button to select RADIO BAND. 2. When RADIO BAND is selected, press the VOLUME or button, the band switches as follows. FM 1 -> FM 2 -> AM 1 -> AM 2 3. You can also select the band by pushing the BAND button on the unit. Each time you press the BAND button, the band switches as follows. FM 1 -> FM 2 -> AM 1 -> AM 2 TREBLE 1. Press the SEARCH UP/DOWN button to select TREBLE. 2. Press the VOLUME or button to adjust treble level. BASS 1. Press the SEARCH U
Resumen del contenido incluido en la página 18
NAVIGATION SETTING THE NAVIGATION 1. Connect a NAVIGATION system to the AV1 or AV2 input terminals on the rear of the unit. 2. Press the MODE button to select radio mode. 3. Press the MENU button to select following picture. 4. Press the SEARCH UP/DOWN button to select NAVIGATION. 5. Press the VOLUME or button to select AV1 or AV2 that NAVIGATION system is connected to. Each time you press this button, AV input changes as follows. AV1 -> AV2 -> OFF WATCHING THE NAVIGATION PICTURE Press the NA
Resumen del contenido incluido en la página 19
CAMERA IN SETTING THE CAMERA IN 1. Connect a back up camera video output to the AV1,2 or 3 video input terminals on the rear of the unit. * When the DVD changer is connected to AV3 video input, the rear view camera can be connected only to AV1 or AV2 video input. 2. Press the MODE button to select radio mode. 3. Press the MENU button to select following picture. 4. Press the SEARCH UP/DOWN button to select CAMERA IN. 5. Press the VOLUME or button to select AV1,2 or 3 mode that rear view c
Resumen del contenido incluido en la página 20
CD/DVD CHANGER CONTROL When a CD or DVD changer is connected to this unit with the 8 pin DIN cable, AV3 mode will change to DISC CHANGER mode and the DISC CHANGER control menu is displayed on the screen. 1. Press the MODE button to select DISC CHANGER (AV3) mode. Each time you press this button, the display changes as follows. RADIO -> AV1 -> AV2 -> AV3 (CD or DVD CHANGER) -> AV4 (TV) 2. When DISC CHANGER (AV3) mode is selected, the monitor displays the following picture. 3. Press the SEARC
