Manual de instrucciones de Rockford Fosgate RFB-1122

Resumen del contenido incluido en la página 1

® ®
®
car audio
for
RFB-1082
RFB-1102
RFB-1122
fanatics
punch

Resumen del contenido incluido en la página 2

Dear Customer, Congratulations on your purchase of the world's finest brand of car audio speakers. At Rockford Fosgate we are fanatics about musical reproduction at its best, and we are pleased you chose our product. Through years of engineering expertise, hand craftsman- ship and critical testing procedures, we have created a wide range of products that reproduce music with all the clarity and richness you deserve. For maximum performance we recommend you have your new Rockford Fosgate product

Resumen del contenido incluido en la página 3

TABLE OF CONTENTS Introduction ....................................................................................... 1 Design Features.................................................................................. 1 Installation ......................................................................................... 2 Specifications ..................................................................................... 3 Warranty Information ..................................................

Resumen del contenido incluido en la página 4

INTRODUCTION The Dual RFP Woofer Enclosures are a pair of 4Ω Rockford Fosgate Punch woofers installed in a pre-fabricated enclosure. The RFP woofers are primarily designed to offer great low frequency reproduction in a small, sealed enclosure. The Dual RFP Woofer Enclosures utilize this small, sealed design to offer a “petite” drop-in system that offers outstanding performance. DESIGN FEATURES Woofer Features PVA Cone Increases cone rigidity and lowers distortion Aluminum Voice Coil Former I

Resumen del contenido incluido en la página 5

Charcoal Carpet Cosmetically integrates with almost any trunk interior ® ® I N INSTALLATION S T A L L A T I O N 1. Determine the mounting location. Check the location of the enclosure to prevent interference with daily operation of the vehicle (trunk springs, fold down seats, etc.). Check the clearance of the input terminals to avoid fraying speaker wire. Keep the woofers at least 3" (7.62cm) away from seat backs or other obstructions. 2. Install the Enclosure If the enclosure is to be secure

Resumen del contenido incluido en la página 6

SPECIFICATIONS Enclosure Data RFB-1082 RFB-1102 RFB-1122 Frequency Response 30Hz-400Hz 24Hz-400Hz 23Hz-400Hz 3 3 3 3 Vb (ft ) 0.7 ft 1.6 ft 2.6 ft Vb (liter) 19.82 45.31 73.63 Baffle Thickness 5/8" 5/8" 5/8" Speaker Model RFP-1408 RFP-1410 RFP-1412 Nominal Impedance 4Ω 4Ω 4Ω Fs (Hz) 30 24 23 RE (Ohm) 3.6 3.6 3.6 LE (mH) 2.5 2.5 2.5 QMS 4.89 4.08 5.0 QES 0.32 0.27 0.42 QTS 0.30 0.25 0.38 VAS (cu. ft.) 0.883 2.72 6.28 VAS (Liter) 25 77 178 Power Handling* 200 200 200 (Watts RMS) Power Handling* 40

Resumen del contenido incluido en la página 7

LIMITED WARRANTY INFORMATION Rockford Corporation offers a limited warranty on Rockford Fosgate products on the following terms: • Length of Warranty 1 year on speakers 30 days on speaker B-stock (receipt required) 3 years on electronics 90 days on electronic B-stock (receipt required) 2 years on source units • What is Covered This warranty applies only to Rockford Fosgate products sold to consumers by Authorized Rockford Fosgate Dealers in the United States of America or its possessions. Produc

Resumen del contenido incluido en la página 8

INFORMATION – 5 – INTERNATIONAL

Resumen del contenido incluido en la página 9

ESPAÑOL INSTALACIÓN DEL RECINTO Si el recinto debe estar asegurado al vehículo o sobre abrazaderas de montaje, puede collar un par de tornillos metálicos al recinto. PRECAUCION: Antes de perforar, compruebe que no dañará ni los conductos del líquido de freno ni de la gasolina, etc. EXTENSIÓN DEL CABLE DE ALTAVOZ DESDE EL AMPLIFICADOR Cuando coloque el cable de altavoz desde el amplificador, evite situarlo cerca de cualquier fuente de alta corriente (arneses colocados de fábrica). El terminal neg

Resumen del contenido incluido en la página 10

DEUTSCH INSTALLIEREN DES GEHÄUSES Soll das Gehäuse fest mit dem Fahrzeug oder einem Träger verbunden werden, benutzen Sie am besten ein paar Metallschrauben. Achtung: Bevor Sie Bohren, sollten Sie sich vergewissern, dab Sie keine Bremsoder Kraftsoffleitungen etc. beschädigen. VERLEGEN DES LAUTSPRECHERKABELS VOM VERSTÄRKER ZUM WOOFER Wenn Sie das Lautsprecherkable verlegen, sollten Sie darauf achten, das Kabl nicht neben Stromführende Kabel des Fahrzeugs zu legen. Das schwarze Terminal ist der ne

Resumen del contenido incluido en la página 11

MADE IN THE USA This product is designed, developed and assembled in the USA by a dedicated group of American workers. The majority of the components used in the construction of this product are produced by American companies. However, due to the global nature of their manufacturing facilities and the loudspeaker parts industry in general, some parts may be manufactured in other countries. Rockford Fosgate Rockford Corporation 546 South Rockford Drive Tempe, Arizona 85281 U.S.A. In U.S.A., (602