Manual de instrucciones de PYLE Audio 10" SUPER SLIM ACTIVE SUBWOOFER PLBASS10

Resumen del contenido incluido en la página 1

Mounting the subwoofer
1. Find a suitable location in the vehicle in which to mount the amplifier.
A typical location is shown below:
2. Make sure there is sufficient air circulation around the intended mounting location.
3. Mark. the location for mounting hole screws by positioning the cabinet where you
wish to inst all it. Make a small mark to identify the position and remove the unit.
PLBASS10
Thoroughly dean the area you plan to attach the subwoofer, using a vacuum cleaner.
Then atta

Resumen del contenido incluido en la página 2

10 PLBASS10 1000 Watts Max 10” Super Slim Active Subwoofer 10” Slim woofer RCA low level input High level input Green & red LED power status indicator Remote level control Phase shift switch: 0 or 180° Adjustable input sensitivity: 0.2V-3V 0 to +12dB variable Bass Boost (@45Hz) Low pass filter (50-150 Hz) Soft delay remote turn-on Thermal, short and overload protection circuits Fuse: 2x20A Max power: 1000 Watts RMS Power: Amplifier: 100 Watts Slim

Resumen del contenido incluido en la página 3

Introduction Low Level Input Wiring Low-level (RCA) input wiring is preferred for best audio performance. Most trunk or hatchback installations will require a 15-20 foot RCA cable, while With the PLBASS10, we are introducing a low-profile amplified pickup trucks and under-seat installations will require a 6-12 foot RCA cable. subwoofer. Low enough to easily fit below the seat of your car, This Always use a high-quality cable. system offers you a quick and easy way to add a high-powered

Resumen del contenido incluido en la página 4

Rear panel controls and features Front panel controls and features CD POWER ON LED INDICATOR ® PHASE SHIFT Use this switch to help compensate for time alignment problems in the system. Such problems usually result from having the subwoofer at a different distance from the listener than the other speakers in the system. CD LOW LEVEL RCA INPUTS Low level inputs are the recommended way to introduce the audio signal @ INPUT GAIN CONTROL to the subwoofer if RCA outputs are present on your h