Manual de instrucciones de Orion Car Audio P6.2

Resumen del contenido incluido en la página 1

P5.2
P6.2

Resumen del contenido incluido en la página 2

INTRODUCTION Thank you for your purchase of the Orion P-Series Component Loudspeaker system. These speakers represent a combination of incredible performance and value. The P- series die-cast components feature aluminum-treated polypropylene cones and vapor- deposit titanium dome tweeters. Capable of maintaining their balance and clarity at exceptionally high output levels, they are the perfect complement to the P-series or H2 subwoofers. The crossovers feature tweeter level adjustment, switcha

Resumen del contenido incluido en la página 3

INSTALLATION The performance of the P-Series Component Loudspeaker is directly proportional to the quality of installation. Care taken during the installation process will be rewarded with years of satisfying performance. If you are unsure about your installation capabilities, please refer to your local Authorized Orion Dealer for technical assistance. Orion dealers are trained professionals dedicated to extracting the maximum performance out of your Orion system. If you decide to install this s

Resumen del contenido incluido en la página 4

REAR DECK MOUNTING In rear deck installations, check the operation of the trunk suspension springs or tension bars. These tension bars move in the opening and closing of the trunk. You cannot be too cautious during this part of the installation, In addition, do not locate the speakers too close to the back of the rear deck. Installing the far screws will only be possible with the removal of the rear window. INSTALLING THE MIDRANGE Step 1: Determine where the speaker will be mounted. Make sure th

Resumen del contenido incluido en la página 5

Step 9: Mount the speaker- The speaker is placed in the grille ring from the front. Place the speaker and the grille ring in the installa- tion hole. Align the mounting screw holes and drive in the four mounting screws. Push the perforated metal grille back into the grille ring. INSTALLING THE TWEETER SURFACE MOUNTING Step 1: Determine the tweeter mounting location, then route the wires from the crossover to the tweeter location. Step 2: Place the surface mount housing against the panel an

Resumen del contenido incluido en la página 6

FLUSH MOUNTING INTO REMOVED PANELS (diagram A) Step 1:. Determine the tweeter mounting location, then route the wires from the crossover to the tweeter location. Step 2: Mark the center point of the tweeter location. Step 3: If using a hole saw, first drill a pilot hole, then cut out the hole using a standard 2-1/8" hole saw. Step 4: If not using a hole saw, use either the cardboard packaging for the tweeters or the surface mount trim ring as a template to mark the proper size hole. Cut out

Resumen del contenido incluido en la página 7

INSTALLING THE CROSSOVER Step 1: Find a location for the crossover away from any factory or after market electrical wires. It is recommended to mount the passive crossover close to the amplifier. In the event you decide to upgrade and bi- amplify the system, mounting the passive crossover close to the amplifier would simplify the installation upgrade. Step 2: Remove top cover of crossover housing. Don’t lose it. Step 3: Mark with a marking pen the two mounting holes. Step 4: Remove crossove

Resumen del contenido incluido en la página 8

Warranty LIMITED TWO YEAR CONSUMER WARRANTY: Directed Electronics, Inc. promises to the original purchaser, to replace this product should it prove to be defective in workmanship or material under normal use, for a period of two years from the date of purchase from the dealer as indicated by the date code marking of the product PROVIDED the product was installed by an authorized Directed dealer. During this two-year period, there will be no charge for this replacement PROVIDED the unit is return