Manual de instrucciones de Xantech CC62

Resumen del contenido incluido en la página 1

Remote Control Switchers
INSTALLATION INSTRUCTIONS
CC62
REMOTE RELAY MODULE
The CC62 Remote Relay Module consists of six double-pole double-throw relays which are controlled by
way of IR commands from a Xantech RC68+ (or RC68) Programmer. The RC68+ commands are "taught"
to learning devices and passed to the CC62 IR IN (S) and G input terminals via Xantech IR receivers,
keypads, etc. The six relays give "dry contact" closures for a multitude of uses where simple contact
closures are needed. Any

Resumen del contenido incluido en la página 2

• NOTE: The RC68+ codes operate several other Xantech models as well, such as the RS41AV, CC12, ZPR68, etc. Therefore, only the button descriptions that apply to the operation of the CC62 are listed below. All others should be ignored. CAUTION: While the RC68+ can be used as a handheld remote control, it is highly recommended it not be given to the final user for the following reasons: • Since it includes adjustable code groups, the user may inadvertently alter the installed configurations. •

Resumen del contenido incluido en la página 3

Remote Control Switchers The CC62 should normally be plugged into an unswitched AC outlet. However, if the power to the CC62 is interrupted by a power failure or other reason, the internal memory will retain the last selected switched condition for each of the relays. IR RCVR INPUT CONNECTOR Jumper ON Position. Metal Chassis This 4-terminal input has electrical connections for +12V, GND (Common ground between GND and GND (chassis ground), GND (IR signal ground) and IR IN (IR signal). terminals

Resumen del contenido incluido en la página 4

MAIN ROOM SOURCE COMPONENTS SOURCE AV RECEIVERS Satellite Receiver (with built-in power amps) To Multiroom input jack or emitter on AV receivers. (depends on brand) AV Receiver "A" AV Receiver "B" VCR 282M or Common (or Gnd) bus for speaker 283M signals. Use the CB18 (or other terminal strip) to make connections. Laser Disc R+ R– L– L+ R+ R– L– L+ Mouse Emitters To 120 V AC (unswitched) CD Changer 782-00 Power Supply R- L- CC62 Remote Relay Module Cassette DecK L+ ("A") RELAY RELAY RELAY RELAY

Resumen del contenido incluido en la página 5

Remote Control Switchers VGGS VGGS VGGS VGGS VGGS VGGS VGGS VGGS VGGS CONTROLLED COMPONENTS +12V DC CC62 782-00 Remote Relay Module Power Satellite Receiver Supply CC62 RELAY RELAY RELAY RELAY RELAY RELAY REMOTE RELAY MODULE 1 2 3 4 5 6 282M NO NO NO NO NO NO To 120 V AC VCR or NC (unswitched) NC NC NC NC NC IR CONFIRM NO NO NO NO NO NO 283M NC NC NC NC NC NC Laser Disc Mouse 12 VDC Emitters 1A CD Changer Wire size typically AWG 20-24 Model 590 (rear panel) AV Receiver 2-conductor lead carries