Resumen del contenido incluido en la página 1
To assure optimal radio performance and make sure human exposure to radio
Information on Safe Operation
Information on Safe Operation
frequency electromagnetic energy is within the guidelines set out in the above standards
always adhere to the following procedures.
Read This Information Before Using Your Oricom Radio.
Transmit and Receive Procedure
Transmit and Receive Procedure
Radio Operation and EME Exposure
Radio Operation and EME Exposure
Your two-way radio contains a transmitter and a rec
Resumen del contenido incluido en la página 2
Radiocommunications (Citizen Band Radio Stations) Class Licence 2002 metal powders) and any other area where you would normally be advised to turn off your Radiocommunications (Citizen Band Radio Stations) Class Licence 2002 vehicle engine, such as petrol stations. No licence is required to own or operate this radio in Australia and New Zealand. Note areas with potentially explosive atmospheres are often-but not always-signposted. The Radiocommunications (Citizen Band Radio Stations) Class Licen
Resumen del contenido incluido en la página 3
Safety and General Use While Driving Medical Devices - Pacemakers Safety and General Use While Driving The Advanced Medical Technology Association recommends that a minimum separation of 6 inches (15 cm) be maintained between a handheld wireless radio and a Check the laws regarding the use of handheld radios whilst driving, and always obey pacemaker. These recommendations are consistent with the independent research by them. and recommendations of the U.S. Food and Drug Administration. People
Resumen del contenido incluido en la página 4
Your Oricom PMR3000R radio controls Your Oricom PMR3000R radio display Your Oricom PMR3000R radio controls Your Oricom PMR3000R radio display Headset socket Indicator light RX icon TX icon Baby monitor On/off button VOX Battery level Menu button Key tone Push to talk (PTT) button Scan/dual scan Volume up and CTCSS code menu settings Key lock Channel Stopwatch Call tone Volume down button and menu settings Call tone Squelech Volume Automatic power Charging contacts save mode Scan and monitor Key
Resumen del contenido incluido en la página 5
This pack contains 1. Ensure radio is turned off. Remove the belt clip on the back. This pack contains • 2 UHF radios • 2 belt clips • 2 PTT headsets • 2 Ni-Mh rechargeable battery packs • 1 twin desk top charger 2. Locate the clip on the battery cover. Use your fingernail to gently prise open the • 1 AC adaptor battery cover and remove. Installing the batteries Installing the batteries Each radio uses a Ni-Mh rechargeable battery pack (supplied). Or for added convenience you can choose to u
Resumen del contenido incluido en la página 6
IMPORTANT NOTE Turning your radio on and off Press and hold for three seconds to turn your radio on. The radio chirps and the 1. When moving between hot/cold environments do not charge the battery until the display will show all feature icons for a brief period. Press and hold button for three battery temperature acclimates (usually about 20 minutes). seconds to turn off your radio. 2.Batteries can cause property damage and/or bodily injury such as burns if a conductive material-like
Resumen del contenido incluido en la página 7
Talking and listening 1. Press until the code number begins to flash. It is good radio etiquette to monitor the channel for activity before you transmit, to 2. Use or to select required CTCSS code 0 (off) or 1-38. ensure that you do not interrupt other users already on the channel. 3. Press to set the new code. Press and hold the button to check for channel activity. If you hear static, the You can specify a different code for each channel. channel is clear for use. Y
Resumen del contenido incluido en la página 8
4. While the radio is scanning, the scan icon will display and the radio will scroll through Keypad lock the channels. Press and hold the button for three seconds to lock or unlock the keypad. When 5. When activity is detected on a channel, the radio will stop scanning and you will hear the radio is locked, the icon will show in the display. whatever transmissions are detected. The radio’s display will show the channel and The keypad lock disables the , and buttons. It al
Resumen del contenido incluido en la página 9
Channel busy indicator 1. Select the repeater channel in your area (channel 1 to channel 8). The red LED will flash twice per second to indicate that the channel is in use. 2.Press the button to enter duplex mode, press or to switch between duplex and simplex mode. Time-out timer The time-out timer feature helps extend battery life by preventing accidental transmission. For example, The radio will emit a continuous warning tone if the button is pressed for more than Select channel
Resumen del contenido incluido en la página 10
To disable the dual channel scan Hands-free use (IVOX) Hands-free use (IVOX) Repeat the setup 1 and 2, and then roll-over at ‘ ’ which means the dual scan is disabled. This feature allows you to transmit “hands-free” by talking into the radio microphone without using the headset. Hands free use (VOX) Hands-free use (VOX) How to use the IVOX feature This feature allows you to transmit “hands-free” by talking while using the VOX 1. Press button until VOX appears. headsets connected to t
Resumen del contenido incluido en la página 11
1. Press until and a flashing number appears in the centre of the display. With Baby monitor function Baby monitor function the headset connected you will see in the top right corner of the display. Without the headset you will see I. One of the units can be set as Baby monitor. The radio will transmit a signal when it is 2. Select sensitivity level 1, 2 or 3 by using or . Choose - activated by the crying baby or another sound in the room. 1- If you speak loudly,
Resumen del contenido incluido en la página 12
To disable baby monitor function Automatic energy saving mode 1. Press button until appears. The radios are designed with a power saving mode. If no transmissions take place 2. Press or until OF appears. within a certain time, the unit switches itself off automatically. 3. Press to confirm the setting. 1. Repeatedly press the button until APO appears in the display and the current setting will flash. Setting squelch level 2. Select the required setting of
Resumen del contenido incluido en la página 13
Stopwatch Channel Frequency (MHz) Usage Channel Frequency (MHz) Usage The PMR3000R has a stopwatch function (mm:ss). 1 476.425 Duplex RX/Simplex21 476.925 Simplex 1. Press button until appears. 2 476.450 Duplex RX/Simplex 22 476.950 No Use 2. Press button to start the stopwatch. 3 476.475 Duplex RX/Simplex 23 476.975 No Use 3. When the stopwatch is running, press button to stop counting and display the 4 476.500 Duplex RX/Simplex24 4
Resumen del contenido incluido en la página 14
Attaching the belt clips Warranty information (Australia) Attaching the belt clips Warranty information (Australia) Attaching the belt clips (2 included) (a) Warranty. Oricom International Pty Ltd (Oricom) warrants that the product is free Each radio is supplied with a belt clip. from defects in materials and workmanship for a period of 12 months effective from the date of purchase. This warranty in no way affects your statutory warranty under the To attach, align belt clip post with hole in th
Resumen del contenido incluido en la página 15
(iv) Non adherence by you to the warnings in the User Guide and the User Guide Customer support Customer support generally; and If you feel this product is not working correctly please consult the user guide and ensure (v) Modification to the product or services carried out to the product by anyone other that you are using the product in accordance with the instructions. than Oricom or on Oricom's behalf. To order spare parts additional radio, replacement batteries and in case of any Oricom w
