Manual de instrucciones de JL Audio Stealthbox SB-T-SEQ/10W3

Resumen del contenido incluido en la página 1

®
Stealthbox
INSTALLATION GUIDE
START
for the HERE
SB-T-SEQ/10W3
➔ ➔ ➔
(Fits 2001 and Up Toyota Sequoia)
STEP 1: Remove the driver’s side rear STEP 2: Remove the driver’s side rear panel. STEP 3: Grind off the plastic tabs which hold
storage area cover. the pocket to the panel.
This Stealthbox is a product
which requires professional
installation skills and tools.
Please read this installation guide
thoroughly before beginning the
project. It will guide you step by
step through the installation

Resumen del contenido incluido en la página 2

Cont. From Page 1 ➔ ➔➔➔ STEP 7: Insert supplied Socket Set Cup STEP 8: Roll the floor carpet back to expose STEP 9: Place the Stealthbox into place so as STEP 10: Using a 1/2” drill bit, drill a hole Screw into the enclosure so the rod extends the metal floor in the location shown above. to allow the Socket Set Cup Screw to make through the metal floor in the location of the approximately 1/4” out of the enclosure. Place the supplied wax square on the metal an impression in the wax square. impre

Resumen del contenido incluido en la página 3

Cont. From Page 2 ➔➔➔ ➔ STEP 15: Adjusting the Socket Set Cup STEP 17: Fully tighten the bolt on the top of STEP 18: Reinstall the factory side panel. STEP 19: Attach the supplied grill to the Screw so that the proper length is exposed the enclosure and the nut on the threaded factory side panel. (the exposed end of the rod is slotted to rod on the bottom of the enclosure to secure CONGRATULATIONS! accept a flat-blade screw driver to be used the enclosure. INSTALL COMPLETE. when adjusting the ro