Manual de instrucciones de JL Audio Stealthbox SB-POL-RNGR/SYS

Resumen del contenido incluido en la página 1

SB-POL-RNGR/SYS INSTR_SKU# 011278
Installat Ion

d I F F I C u l t Y :

If you choose to perform the installation yourself, it is absolutely vital that the
out
enclosures be properly mounted to the vehicle according to these instructions.
o F
Failure to mount the enclosure properly presents two problems:
I n s t a l l a t I o n G u I d e
1) The sub-bass performance will suffer due to the movement of the enclosure
for the
caused by the force exerted by the woofer(s).
35
SB-POL-RNGR/

Resumen del contenido incluido en la página 2

SB-POL-RNGR/SYS INSTR_SKU# 011278 s t e P 4 S T E P 6 Looking from under the hood take note of the location of Install the included Custom Aluminum Bracket on the drivers the relay that is screwed to the cross channel. inside that side of the subwoofer enclosure as shown using the supplied channel on the bottom there is a hole that should line up 3/8-16x 1” Hex Head Bolt, Split Lock Washer and Flat Washer, with the threaded insert in the top of the Stealthbox®, this these fasteners should b

Resumen del contenido incluido en la página 3

SB-POL-RNGR/SYS INSTR_SKU# 011278 I n C l u d e d H a R d W a R e s t e P 9 Install a piece of the included Self Adhesive Gasket Material 1) Custom Aluminum Bracket 1) 3/8-16x 1 1/2” Hex Head Bolt along the outer edge of each frame rail where the OEM kick 1) 3/8-16x 1” Hex Head Bolt 1) 3/8 x 1 1/4” Fender Washer panels had been attached. 4) 3/8 Split Locking Washer 1) 3/8 Flat Washer 1) Square U-Bolt (with washers and, nuts) 4) 1/4x 1” Button Head Allen Bolt 4) 1/4-20 Lock Nut 1)