Manual de instrucciones de JL Audio Stealthbox SB-GM-TRLBLZR/10W3v3/GA

Resumen del contenido incluido en la página 1

SB-GM-TRLBLZR/10W3v3_INSTR_SKU#011184

INSTALLATION
If you choose to perform the installation yourself, it is absolutely vital that
DIFFICULTY:
®
the Stealthbox be properly mounted to the vehicle according to these
instructions. Failure to mount the enclosure properly presents two problems: OUT
INSTALLATION GUIDE
OF
for the 1) The sub-bass performance will suffer due to the movement of the enclosure
caused by the force exerted by the woofer(s).
SB-GM-TRLBLZR/10W3v3
25
2) A loose enclosur

Resumen del contenido incluido en la página 2

SB-GM-TRLBLZR/10W3v3_INSTR_SKU#011184 SUVs with the air compressor only. STEP 4 STEP 8 With a 10mm box/open end wrench, remove the bolt that Pop out the panel that hold the air compressor switch and is located in front off the passenger's side rear tire. hose nozzle. With all the mounting hardware removed, remove the Remove the hose nozzle from panel. plastic wheel well liner. Pop the switch out of the panel, from the back side. If your SUV does not have the factory air compressor, pl

Resumen del contenido incluido en la página 3

SB-GM-TRLBLZR/10W3v3_INSTR_SKU#011184 STEP 12 STEP 16 ® Use a hand held rotary tool (Dremel ) with cutting bit, to Run speaker wire from the amplifier location to the ® cut out the side panel for the compressor switch panel. Stealthbox location and check for proper operation of the woofer. Remember the hole for the hose nozzle. STEP 13 STEP 17 Place one of the supplied wax squares, so the side of the Back out the socket cup set screws so 1 1/4-inch of threads wax square is flush against the

Resumen del contenido incluido en la página 4

SB-GM-TRLBLZR/10W3v3_INSTR_SKU#011184 STEP 20 I N C L U D E D HAR DWARE Replace the plastic wheel well liner. Using a 10mm open/ closed combination wrench, re-install the bolt that removed (2) 3/8-inch Split Lock Washer (2) 3 x 3-inch Wax Square in STEP 4. (2) 3/8-inch Flat Washer (2) 3/8-inch Hex Nut (2) 3/8-inch x 1 1/4-inch Fender Washer (2) 3/8-inch 16 x 2 1/4-inch Socket Cup Set Screws S P EC I F ICAT ION S Enclosure Type: Acoustic Suspension (sealed) Driver Type: 10W3v3-4 Nominal Im