Resumen del contenido incluido en la página 1
Initial Setup Basic Operation TV Operation Timer Operation Advanced Operation For Your Information
LSQT0521A
TV / DVD / VCR Combination
Operating Instructions
Models No. PV-DF2002/PV-DF2702
• Initial Setup and Connection Procedures are on pages 14 to 17.
®
As an ENERGY STAR Partner, Matsushita Electric Corporation of America has
®
determined that this product or product model meets the ENERGY STAR
guidelines for energy efficiency.
Please read these instructions carefully before attempting to c
Resumen del contenido incluido en la página 2
Important Safeguards and Precautions READ AND RETAIN ALL SAFETY AND OUTDOOR ANTENNA INSTALLATION OPERATING INSTRUCTIONS. HEED ALL 1 SAFE ANTENNA AND CABLE CONNECTION WARNINGS IN THE MANUAL AND ON UNIT An outside antenna or cable system must be properly grounded to provide some protection ANTENNA INSTALLATION LEAD IN against built up static charges WIRE GROUND and voltage. Section 810 CLAMP 1 POWER SOURCE CAUTION ANTENNA of the National Electrical DISCHARGE UNIT Operate only from power source in
Resumen del contenido incluido en la página 3
Safety Precautions/Mesures de sécurité Warning : To prevent fire or shock hazard, do not expose this equipment to rain or moisture. Caution : To prevent electric shock, match wide blade of plug to wide slot, fully insert. Avertissement : Afin de prévenir tout risque d'incendie ou de chocs électriques, ne pas exposer cet appareil à la pluie ou à une humidité excessive. Attention : Pour éviter les chocs électriques, introduire la lame la plus large de la fiche dans la borne correspondante de
Resumen del contenido incluido en la página 4
Before Using Congratulations Loading the Batteries on your purchase of one of the most sophisticated and reliable products on the market today. Used properly, it will bring you 1) Open the cover. and your family years of enjoyment. Please fill in the information below. The serial number is on the tag located on the back of your unit. Date of Purchase Dealer Purchased From 2) Insert batteries as Dealer Address marked. Dealer Phone No. Model No. Serial No. 3) Close the cover. Accessories
Resumen del contenido incluido en la página 5
Initial Setup TV Operation Basic Operation Timer Operation Advanced Operation For Your Information Table of Contents Initial Setup Important Safeguards and Precautions / Safety Precautions ........ 2 - 3 TV / VCR Before Using ........................................................................................ 4 Information (Unit, Cassette, Disc) .................................................. 6 - 7 Location of Controls......................................................................
Resumen del contenido incluido en la página 6
Information (Unit, Cassette, Disc) Head Cleaning Specifications 27 inch diagonal pure Display Playing older or damaged tapes may eventually flat Picture Tube (PV-DF2702) Picture Tube: cause video heads to become clogged. 20 inch diagonal pure flat Picture Tube (PV-DF2002) Head Clog Sensor VCR V I DEO HEADS MAY During playback this NEED CLEAN I NG Video Recording 4 rotary heads helical PL EASE I NSERT HEAD screen appears if clogging System: scanning system CLEAN I NG CASSETTE OR REFER
Resumen del contenido incluido en la página 7
Initial Setup Disc formats supported by this unit Disc Handling The unit can play back discs bearing any of the following marks: Handling precautions DVD • Only hold disc by edges as shown. Fingerprints, dirt, and scratches 3” (8 cm) disc / 5” (12 cm) disc can cause skipping and distortion. Video CD • Do not write on label 3” (8 cm) disc / 5” (12 cm) disc side of disc. • Never use record CD, CD-R/W cleaning sprays, benzine, 3” (8 cm) disc / 5” (12 cm) disc thinner, static electricity prevention
Resumen del contenido incluido en la página 8
Location of Controls Remote Control Buttons EJECT/OPEN/CLOSE DVD See next page. Sets to DVD mode. POWER LIGHT Turn the unit on or off. See next page. TV/VCR DSS/CABLE Sets to TV or VCR mode. Sets the remote to control some basic DDS or Cable box functions. MUTE FM Mutes the sound instantly. Receives FM radio signal. CHANNEL UP/DOWN Selects a channel. VOLUME UP/DOWN Adjusts volume. SURROUND Hears a deeper, 3-D sound effect. RAPID TUNE Displays the last channel NUMBER Keys you were watching. Sele
Resumen del contenido incluido en la página 9
Initial Setup Location of Controls (continued) ® Universal Light Tower Illuminated Remote Control LIGHT button: When LIGHT is pressed, (DVD, , DSS/CABLE, CH UP/DOWN, VOL UP/DOWN) buttons will light for 5 seconds for easy button location. If no button is pressed in 5 seconds, the light goes out to conserve the battery. EJECT/OPEN/CLOSE button: When this button is pressed in TV-VCR mode, the tape is ejected. This button is inoperative if pressed during recording. If pressed in DVD mode, the disc
Resumen del contenido incluido en la página 10
Initial Setup Front View of the unit Built-In SpeakerX2 If the disc cannot be removed... First, unplug unit. Then, prepare a rigid wire (e.g. an extended paper clip) and, applying moderate force, insert it straight into the hole at the base of the tray. The tray will eject a little. Now, pull the tray all the way out and remove the disc. Cassette Disc Tray Compartment REC PHONES (See page 8.) Connect an earphone or headphones. FAST FORWARD/ SEARCH AUDIO/VIDEO IN (See page 8.) Connector C
Resumen del contenido incluido en la página 11
Initial Setup VHF/UHF VHF/UHF Location of Controls (continued) Rear View of the unit Audio Output Connector (L/R) Pg. 12 VHF/UHF Antenna Input Terminal See below. Optical digital audio output connector Pg. 13 AC Power Plug When plugged into an AC outlet, this unit consumes 3.5 W of electric power in OFF condition. Connections For ANT./Cable Connect the cable from IN from ANT./CABLE Antenna/Cable to the VHF/UHF terminal on the unit. VHF/UHF For DSS/Cable Box UNIT Connect the OUT jack on your cabl
Resumen del contenido incluido en la página 12
Connections (continued) Ready Checklist Audio connections Turn down the volume, then turn this unit, as well as other equipment to be connected, off before proceeding with connection. Unit ➔ Amplifier ➔ Speaker Do not block ventilation holes of any of the equipment and arrange them so that air can circulate freely. Read through the instructions before connecting Unit other equipment. Ensure that you observe the color coding when connecting audio and video cables. Enjoying digital audio output
Resumen del contenido incluido en la página 13
Initial Setup Unit ➔ Decoder with Dolby Digital ➔ Amplifier ➔ Speaker or dts (digital theater systems) When DVDs recorded in Dolby Digital or dts are played, Dolby Digital bitstream or dts bitstream is output from the unit Optical digital audio output connector. When the unit is connected to a Dolby Digital decoder or dts decoder, you can enjoy theater-quality audio in your home. [An optical digital audio cable (optional) is required when an optional Dolby Digital decoder or dts decoder is use
Resumen del contenido incluido en la página 14
Initial Setup (Ready to Play) Please make all cable or antenna connections before powering on. Initial Setup (Ready to Play) Press on the remote for TV-VCR mode. Plug the unit power cord into an AC wall outlet. 1 Press Power* on the remote or unit. The unit comes on and auto channel and clock set starts. 2 CH AUTO SET PROCEEDING POWER TV-VCR • If you use a cable box, turn it on and set it to the Public Broadcasting Service (PBS) channel in your time zone. If you use a DSS receiver, it
Resumen del contenido incluido en la página 15
Initial Setup *Important: If a remote control button does not work when pressed, press the button on the remote and try the button again. Manual Clock Set Reset all unit Memory Functions If AUTO CLOCK SET was incomplete, manually When moving unit to a new location, or if a set the clock as follows. mistake was made in the Initial Setup section. • Make sure a tape is not inserted in the unit. Press ACTION on the Remote to display SET CLOCK Menu screen. 1 SET CLOCK : 1 / / 1 / / DST
Resumen del contenido incluido en la página 16
Reset Language, Channels, Clock, M A I N MENU Press ACTION* to display MAIN MENU. 1 DVD LOCK LANGUAGE 1 3 5 CH TV CLOCK SELECT : SET : SET END : ACT I ON Language Channels Clock 2 1) Press to 1) Press to 1) Press to select “CH.” select “CLOCK.” select language icon. M A I N MENU M A I N MENU M A I N MENU DVD LOCK LANGUAGE DVD LOCK LANGUAGE 1 1 3 3 5 5 DVD LOCK LANGUAGE TV CLOCK CH TV CLOCK CH 1 3 5 SELECT : SET : SET SEL
Resumen del contenido incluido en la página 17
Initial Setup Important: If a remote control button does not work * when pressed, press the button on Time Zone Adjust the remote and try the button again. Time Zone Adjust (Only when Auto Clock is set.) 4)Press and NUMBER press SET to select 1) Press to keys and set the month, select “CLOCK.” date, year, time, and M A I N MENU ADD/DLT DST (Daylight Saving SELECT Time). LANGUAGE DVD LOCK 1 3 5 To Make Corrections, SET TV CLOCK CH repeatedly press SELECT : SE
Resumen del contenido incluido en la página 18
Playback a Tape Record On a Tape Insert a tape with record tab. Ready Checklist • The unit power comes on automatically. All connections are made. 1 Your unit is plugged in. Press CH or number keys to Insert a tape. Select Channel. 2 • The unit power comes • For “LINE” input, see bottom of next page. 1 on automatically. Press SPEED to select recording Record tab speed (see page 4). 3 SP = Standard Play To prevent tape jam, LP = Long Play remove loose or peeling SLP = Super Long Play labels from
Resumen del contenido incluido en la página 19
Basic Operation Important: If a remote control button does not work * when pressed, press the button on Copy Your Tapes (Dubbing) the remote and try the button again. Connections you’ll need to make Recording (Editing) unit Playing (Source) VCR R-AUDIO-L VIDEO IN FROM OUT ANT. VIDEO IN L-AUDIO IN-R MONO OUT TO IN TV Playback (Source) Recording (Editing) unit Insert pre- Insert blank tape recorded tape. with record tab. 1 • Dubbing tapes protected with Copy Guard will have poor quality results.
Resumen del contenido incluido en la página 20
Basic DVD Operation Press POWER* on the remote or unit. Ready Checklist 1 All connections are made. (See page 11.) Your unit is plugged in. Press DVD to select DVD mode. If unit is connected to an audio amplifier, • If a disc is already inserted, go to step 4. 2 turn the stereo system’s power on. (Depending on the disc, playback may start automatically.) Insert a disc. 1) Press OPEN/CLOSE. 3 2) Place disc into disc tray. • Hold disc by its edges only (page 7) with printed side up use guides to
