Manual de instrucciones de PYLE Audio PSW117ET1

Resumen del contenido incluido en la página 1

2,3
1
Step Step 3: 3: Hanging Hanging display display
Firstly lift the bracket mounted display over the wall mount. And then hook the
brackets over the top of the wall mount. Rotate the display let the bottom of the
brackets hook over the bottom of wall mount, as shown in Fig.3a. Then put safe
bolts into the bottom of the brackets and lock it, as shown in Fig.3b.
W Wa arning: rning: Some TV require two people to lift, as we are not responsible for any
Tilt Flat Panel TV Bracket
personal injury o

Resumen del contenido incluido en la página 2

Har Hard dwar ware e List: List: Actual parts may appear slightly different than After determining the height of stand, follow the installation instructions in below UP illustrated. UP to install wall mount to different kinds of wall -wooden, concrete. 4 W Wooden ooden wall: wall: Using a awl or nail to make where the nails are located, as shown as fig.2b. Distance 1 2 3 between two nails for fixing wall mount must not less than 12”. Pre-drill these holes with a 5mm drill bit to at least 50mm in

Resumen del contenido incluido en la página 3

Step Step 2: 2: Attach Attach mount mount to to wall wall We are not responsible for any personal injury or product damage due to mishandling, incorrect mounting, incorrect assembly or WARNING First, determine the height of stand incorrect use of this product. The best height of stand is parallel to eyelevel of a person who sitting on a couch. Normally, the horizontal distance of eyelevel is about 4’ from ground level. Note: The supplied wall mounting hardware is not for use on steel stud walls

Resumen del contenido incluido en la página 4

Following examples shows how to use bolts, spacers and square washers. 2. Some displays have curved backs with recessed mounting lands(Fig.a). It will 1.Some displays have vertical backs. No spacer is required. Install the bracket directly require the use of spacer. For this display, to the back of display by using bolts and square washers provided. As shown in Fig.1c. install a spacer(M)between display and Fig a thebracket.Asshown in Fig1d. M4 Fig bit M5 Fig bit M5 Fig bit M6 Fig bit I M I I A,