Manual de instrucciones de JBL CS2165C

Resumen del contenido incluido en la página 1

CS SERIES
CS2165C
component system
owner’s manual
THANK YOU
®
for purchasing a JBL CS Series automotive
loudspeaker component system. We’ve organized
this manual to make your installation as simple
and trouble-free as possible. Please read it
thoroughly before proceeding. Remember to
keep your sales receipt and this manual in a safe
place so both are available for future reference.

Resumen del contenido incluido en la página 2

INSTALLATION WARNINGS AND TIPS ABOUT THESE INSTRUCTIONS LOUD MUSIC AND HEARING INSTALLATION TIPS • Before drilling or cutting holes, use a Installation of automotive stereo components Playing loud music in an automobile can • Always wear protective eyewear when utility knife to remove unwanted fabric can require extensive experience with hinder your ability to hear traffic, as well using any tools. or vinyl to keep material from snagging a variety of mechanical and electrical as permanently da

Resumen del contenido incluido en la página 3

INSTALLATION ™ Figure 1. Mounting the woofer in a factory I-MOUNT FLUSH-MOUNT TWEETER ANGLE location without the grille. Figure 3A. Mounting the tweeter using the Figure 4. Aim the tweeter at the listening I-Mount flush-mounting kit. position by sliding the screw in the groove on the back of the tweeter cup and lock the 3 tweeter in place using the small retaining screw. Rotate the entire assembly in the mounting surface and tighten the large hand nut. 1 3 ROTATE ENTIRE ASSEMBLY 2 TO AIM ANGLED

Resumen del contenido incluido en la página 4

CONNECTIONS SPECIFICATIONS CS2165C Connect the tweeter using the supplied Figure 5. Wiring connections wire with inline crossover to the terminals Type 165mm Two-way component system on the woofer. Note that there are two Power Handling 45W RMS, positive and two negative terminals on 135W Peak the woofer. Connect the unused positive Sensitivity (2.83V/1m) 91dB and negative terminals to your amplifier‘s output leads, observing proper polarity. Frequency 55Hz – 20kHz Response You must use the s