Manual de instrucciones de Winegard RS3460B

Resumen del contenido incluido en la página 1

®
WINEGARD
TM
ROADSTAR
RV AND VAN TV ANTENNA
MODELS RS-2000 & RS-3460/RS3460B
Made in U.S.A.
INSTRUCTIONS
PARTS LIST (RS-2000) White Housing
SPECIFICATIONS
Bandpass 1 Amplified Antenna 2120415
VHF/FM.............................. 54 to 216 MHz 6 10-32 Hex Nut, Nylock 2160216
UHF .................................... 470 to 810 MHz 1 Power Supply with Hardware 2120123
Amplifier Gain ...................... 1 30' Coaxial Cable 2753015
VHF* .................................. 15.5 dB avg. 1 6' Coaxial

Resumen del contenido incluido en la página 2

NOTE: Holes for mounting brackets are at corners of ANTENNA MOUNTING INSTRUCTIONS 19-5/8" triangle. We recommend you make a template STEP 1. Assemble mounting brackets onto mounting from 19-5/8" triangular piece of cardboard. Try to plate. Insert 10-32 x 5/8" bolts through mounting plate locate holes on roof rafters on other solid members and mounting brackets. See Figure 1. Attach #10 x 9/16 inside roof. See Figure 5. x 1/6 washers and 10-32 locking nuts. Tighten securely. FIGURE 1 STEP 2. Pla

Resumen del contenido incluido en la página 3

CHECKING POWER SUPPLY OPERATION STEP 7. Install connectors on downlead and set 2 cable (Power Supply not supplied with RS-3460) as shown on page 4. Attach antenna downlead cable to 1. Tune TV receiver to nearest station. jack on power supply marked “ANT”. See Figure 7. 2. Turn off switch on power supply. Picture on TV receiver should be considerably degraded with power off. 3. This unit is equipped with a polyswitch, (current limiting de- vice), which will shut down +12 VDC if there is a direct

Resumen del contenido incluido en la página 4

WHAT TO DO WHEN YOUR RV/TV ANTENNA IS NOT WORKING PROPERLY INSTALLING COAX CABLE ON FC- 5910 CONNECTORS AMPLIFIED HOW YOUR TV SIGNAL SYSTEM WORKS WHITE GND - STEP 1: Strip outer cover back 1/2"* from end of cable. Fray braid back HOOKS INTO +12VDC BATTERY + +12VDC as far as outer cover will allow. RED STEP 2: Trim braid close to outer cover and remove 1/4"* of inner insulation being careful not to nick center conductor. Make sure no foil or braid can touch center conductor. STEP 3: Slide conn