Resumen del contenido incluido en la página 1
AUDIO MONITOR SPEAKER SYSTEM
AMS-100
ANALOG MODULE
BKAM-101
AES/EBU MODULE
BKAM-102
SDI MODULE
BKAM-103
INSTALLATION MANUAL
1st Edition
Resumen del contenido incluido en la página 2
! WARNING This manual is intended for qualified service personnel only. To reduce the risk of electric shock, fire or injury, do not perform any servicing other than that contained in the operating instructions unless you are qualified to do so. Refer all servicing to qualified service personnel. ! WARNUNG Die Anleitung ist nur für qualifiziertes Fachpersonal bestimmt. Alle Wartungsarbeiten dürfen nur von qualifiziertem Fachpersonal ausgeführt werden. Um die Gefahr eines elektrischen Schlages, F
Resumen del contenido incluido en la página 3
Table of Contents 1. Installation 1-1. Power Supply ........................................................................................1-1 (E) 1-1-1. Power Specifications ............................................................1-1 (E) 1-1-2. Power Cord...........................................................................1-1 (E) 1-2. Dimensions............................................................................................1-2 (E) 1-3. Installation of Boards .............
Resumen del contenido incluido en la página 4
1-2. Dimensions 1-3. Installation of Boards 1-2. Dimensions 424 465 482 Unit : mm 1-3. Installation of Boards The optional boards (BKAM-101/102/103) can be installed in any slots of the AMS-100. Installation of optional boards 1. Turn off the power of the AMS-100. 2. Remove the blank panel on the rear panel after removing its two retainer screws. n Do not discard the removed blank panel. Blank panel 3. Slide the optional board along the guide rails into the unit. 4. Secure the optional board in
Resumen del contenido incluido en la página 5
1-4. Rack Mounting 1-4. Rack Mounting Procedures The AMS-100 can be mounted in a 19-inch standard rack. 1. Turn off the power. 2. Attach the inner rails to the unit using the six screws n (B4x8) supplied with the RMM-30. . If the AMS-100 or the peripheral equipment is mounted Inner rail in a 19-inch standard rack, it is recommended to install a ventilation fan to prevent a temperature rise in the rack. B 4x8 Make sure that all the units in the rack should be operat- ed within the temperature ran
Resumen del contenido incluido en la página 6
1-4. Rack Mounting 1-5. Pin Assignment of Connectors 4. To mount the unit on the rack, while pressing the 1-5. Pin Assignment of Connectors stoppers of the inner rails, slide the inner rails fully into the outer rails. REMOTE (D-sub 25-pin, Female) 5. After confirming that the unit can be moved smoothly, 13 1 tighten the six screws run in but not tightened in procedure 3. 25 14 n To tighten the front brackets to the rack, slide the unit _External View_ from the rack toward you about 20 mm. Pin N
Resumen del contenido incluido en la página 7
1-6. Matching Connectors and Cables 1-7. Internal Switches 1-6. Matching Connectors and Cables 1-7-2. SDI-43 Board (BKAM-103) When connecting cables to various connectors on the rear panel at the time of installing or servicing, connect the CN101 following connectors/cables or their equivalents. Connector Matching Connector/cable Panel indication Connector/Cable Sony Part No. S101 S102 REMOTE D-sub 25-pin, male 1-566-356-11 AUDIO IN 1 XLR 3-pin, male 1-508-084-00 (*1) XLR 3-pin, female 1-508-083
Resumen del contenido incluido en la página 8
1-8. Adjustment of the Input Level Meter 1-9. Related manuals 1-8. Input Level Meter Adjustment 1-9. Related manuals Besides this Installation Manual, the following manuals are Preparation available for the AMS-100. . Input the reference signal to the unit: When the BKAM-101 is attached : +4 dBm . Operation Manual (Supplied with the AMS-100) When the BKAM-102 is attached : _20 dB FS This manual explains the overview of the AMS-100, and . Turn on the power of the unit and select the slot and the
Resumen del contenido incluido en la página 9
SAFETY CHECK-OUT After correcting the original service problem, perform the following safety checks before releasing the set to the customer : Check the metal trim, “metallized” knobs, screws, The material contained in this manual consists of and all other exposed metal parts for AC information that is the property of Sony Corporation and leakage. Check leakage as described below. is intended solely for use by the purchasers of the equipment described in this manual. LEAKAGE TEST Sony Corporatio
Resumen del contenido incluido en la página 10
AMS-100 (SY) BKAM-101 (SY) BKAM-102 (SY) Printed in Japan BKAM-103 (SY) J, E Sony Corporation 1999. 2 11 3-202-309-01 Broadcasting & Professional Systems Company ©1999
