Manual de instrucciones de PYLE Audio PYLE Hydra Series PLMRA1000D

Resumen del contenido incluido en la página 1

Resumen del contenido incluido en la página 2

INTRODUCTION... Thank you for purchasing the Pyle MARINE Class-D amplifier. This is due to the noise introduced into the signal by the switching Rest assured you have purchased a quality product designed speed of the power supply, which must be filtered out of the audio and engineered to give you many years of uncompromised signal. musical service.The Pyle MARINE Class-D amplifier has been The power supply incorporated into Pyle MARINE amplifier is a designed using the latest in electronic tech

Resumen del contenido incluido en la página 3

general featur es PLMRA1000D 2000W Mono Block MOSFET Digital Power Amplifier · Mono Block Subwoofer Amplifier · Phase Control 0-180 degree · 1 Ohm Stable · Remote Bass Control · MOSFET Power Supply · Input Impedance : 10K Ohms 2 · PWM (Pulse-Width-Modulation) System · Soft Turn On/Off · Glass Epoxy PCB · Advanced Protection Circuitry · Gold Plated RCA Inputs for Line Input & Bypass Output. · S/N Ratio:>90dB · Gold Plated Terminals for Speaker Output and Power Input. · Heavy Duty Power Coated Hea

Resumen del contenido incluido en la página 4

featur es and contr ols Class-D MONO BLOCK AMPLIFIER PLMRA1000D PLMRA1000D Mono channel amplifier Class-D design Low-frequency information for subwoofer only.High efficient power output power @14.4v DC,50KHz RMS Power at @4 Ohms 200W MONO power supplies Stiffly regulated PWM power supplies. MOSFET switches maintain RMS Power at @2 Ohms 400W MONO rated power over a wide range of battery voltages. RMS Power at @1.3 Ohms 1000W MONO crossover low pass filter Adjustable from 20Hz to 250Hz with a sl

Resumen del contenido incluido en la página 5

system wiring Class-D MONO BLOCK AMPLIFIER PLMRA1000D POWER INPUT CONNECTION PLMRA1000D 6 amplifier and inst alla tion mounting Find a suitable location in the vehicle to mount the amplifier Make sure there is sufficient air flow around the intended mounting location Bolt the amplifier to the mounting surface. wiring tips Connect the power ground terminal to the nearest point on the chassis of the car. Keep this ground wire less than one meter (39") in length. Use 4 gauge wire. Connect the re

Resumen del contenido incluido en la página 6

tr oubleshooting Protection LED comes on when the amplifier is powered up. Before removing your amplifier, refer to the list below and Check for shorts on speaker leads. follow the suggested procedures. Check that the volume control on the head units is turned down low. Always test the speaker and their wires first. Remove speaker leads, and reset the amplifier. if the protection LED still comes on, then the amplifier is faulty. Amplifier will not power up Check for good ground connection. Ampli