Manual de instrucciones de Marshall Amplification DRP-1

Resumen del contenido incluido en la página 1

Direct
Recording
Pre-Amp
DRP-1

Resumen del contenido incluido en la página 2

FROM THE CHAIRMAN I would like to thank you personally for selecting one of our Direct Recording Pre-amps. In our quest to make the sound of Marshall more accessible, we constantly use the knowledge and experience of our Research and Development team to produce new products. Following the success of the SE100 Speaker Emulator and PB100 Power brake, we have now produced the DRP-1 Direct Recording Pre-Amp. A remarkable and compact device which is incredibly versatile and which offers a true simula

Resumen del contenido incluido en la página 3

WARNING! PLEASE READ THE FOLLOWING LIST CAREFULLY A. DO NOT attempt to remove the DRP-1 chassis. There are no user serviceable parts inside. B. ALWAYS have this equipment serviced or repaired by competent, qualified personnel. C. PLEASE READ this instruction manual carefully before switching on. Front Panel. DRP-1 Direct Recording Pre-amp. 1. Pre-Amp Volume. Controls the level of input gain. Lower levels The Marshall Direct Recording Pre-Amp will produce cleaner sounds, whilst higher settings i

Resumen del contenido incluido en la página 4

passed onto other externally connected equipment, 8. Battery Level LED. any channel faders etc. should be down when When activated by the switch (Item 7) the inserting the headphone jack. LED will illuminate when there is sufficient battery power to run the DRP-1. Note! Low battery levels will produce no light from Due to the widely varying nature of the LED, whilst borderline power will produce headphones, undesired clipping of the headphone only a dim output. amplifier may occur and will produ

Resumen del contenido incluido en la página 5

Some Suggested Headphone/ practice amp. Set-ups Remember that pedal type effects can be added between the guitar and input of the DRP-1 as you would with a normal guitar amp. When recording it is recommended that effects are added at the mix stage as is usually the case when recording a standard guitar Live sound pre-amp. amp. FEATURE GUIDE FX IN Stereo input to take the left and right returns from your effects processor (using a stereo jack to 2x mono jack Y lead) when using the DRP-1 as a

Resumen del contenido incluido en la página 6

GUITAR INPUT PREAMP GAIN TONE PASSIVE MASTER PREAMP PREAMP INPUT JACK AMP VOL. AMP DRIVER TONE VOL. OUT OUT BUFFER JACK BASS MID. TREBLE. ON OFF POWER LOUDSPEAKER LINE LINE POWER AMP CABINET LEVEL OUT BATTERY SWITCH SIMULATOR SIMULATOR JACK BOOST TEST SWITCH L.E.D. Front Panel. 7. 8. Preamp Master Bass Middle Treble Line HEADPHONE AMP HEADPHONE AMP HEADPHONE Volume Volume Level INPUT JACK INPUT JACK AMP Gain . . . . . . . . . . . . Rear Panel. 1. 2. 3.