Manual de instrucciones de Extron electronic sRS-232

Resumen del contenido incluido en la página 1

Product Category
MTP 15HD RS Series • Setup Guide
This guide provides instructions for setting up and operating any of the Extron MTP 15HD RS transmitters and receivers.
4
RS-232
MTP T 15HD RS MTP RL 15HD RS
OUTPUTS
PRE-PEAK
Tx Rx BUFFERED
POWER
POWER
INPUT OUTPUT
12V
ON 12V
.5A MAX RS-232
.5A MAX
Tx Rx
OFF
INPUT MONITOR OUTPUT OUTPUT
1 2 3 5 6 10
1 7 8 9
Figure 1. Transmitter and Receiver Rear Panels
Connected RS-232 MTP
Pre-Installation — RS-232 DIP Switch
Device Pins Pins
Tx

Resumen del contenido incluido en la página 2

MTP 15HD RS • Setup Guide (Continued) Grounding guidelines: Extron MTP 15HD RS products can be adversely affected by electrostatic discharge (ESD) if they are not grounded correctly. To prevent malfunctions or product damage, an installer can correctly ground an Extron MTP 15HD RS series product by grounding the power input port. Insert one end of the grounding wire to the negative or ground pin on the power input connector (see figure 5). Tie the other end of the wire to and earth ground.