Manual de instrucciones de ADTX ZRW113

Resumen del contenido incluido en la página 1

ZRW113
HomePro
Z-Wave Radio Frequency (RF) Controlled, 120 VAC,
RF Home Automation
Isolated Contact Wall Mounted 3-Way Switch,
Series 200, Release 2.2
Shown with supplied
TM
Decora trim plate
Note: This module must be “Included in the Network” only
where it will be permanently installed. The proper operation
of this node in the mesh network is dependent on it knowing its
location with respect to other nodes. You cannot “test bench”
configure this module, then install.
ZRW113 WALL MOUNTED SWI

Resumen del contenido incluido en la página 2

INCLUDING ZRW113 TO THE NETWORK STEP 1.. Prepare the Controller to include a unit to the network by adding it to a group (method of adding a node to the network). Refer to controller instructions. STEP 2. The ZRW113 must be in its permanently installed location. Tap either the top or bottom of the ZRW113 once. STEP 3. You should see an indication on your Controller that the “DEVICE WAS INCLUDED” in the network. NOTE: If you have trouble adding the ZRW113 to a group it may be that the

Resumen del contenido incluido en la página 3

Association The ZRW113 supports the Association command. The ZRW113 can be set to control other Z-Wave devices. You can turn on and off, and even dim other Z-Wave devices once they are “associated” into either of 2 groups of the ZRW113. Each group is turned on, off or dimmed by tapping or holding the switch a differing amount of times. If you associate Z-Wave devices into Group 2, you can turn those devices on and off by tapping the switch on or off twice. You can brighten or dim devices by tap

Resumen del contenido incluido en la página 4

SUC Support There must be a Static Update Controller in your Z-Wave system for this feature to work. The Static Controller can act as a gateway in the system, since other nodes always know its position (not moved after addition to the network. The “always listening” advantage of the Static Controller is that other nodes can transmit information frames to it whenever needed. You can assign an “SUC Route” to the ZRW113. Refer to your controller’s instructions on how to do this (if it supports it)