Manual de instrucciones de Kenwood SIRIUS DT-7000S

Resumen del contenido incluido en la página 1

Resumen del contenido incluido en la página 2

Table of contents Selecting music ............................................................................................................8 Congratulations ............................................................................................................2 Box contents.................................................................................................................2 Setting and using stream presets.......................................................................

Resumen del contenido incluido en la página 3

This plug will fit into the outlet only one way. This is a antenna discharge unit, size of grounding conductors, Safety precautions (continued) safety feature. If you are unable to insert the plug fully into location of antenna discharge unit, connection to ground- FCC Warning the outlet, try reversing the plug. If it should still fail to fit, ing electrodes, and requirements for the grounding elec- This equipment may generate or use radio frequency contact your electrician to replace your obso

Resumen del contenido incluido en la página 4

Connecting the DT-7000S to your audio system Use the cables supplied with the DT-7000S to make these connections. About the RS-232C connection: The RS-232C connection is provided to allow the DT-7000S to be controlled by compatible 3rd-party control systems. Kenwood recom- mends that this connection only be used by experienced professional system installers. DO NOT connect the RS-232C connection to a computer—it is NOT COMPATIBLE with person- al computers. 4 DT-7000S Instruction Manual

Resumen del contenido incluido en la página 5

Resumen del contenido incluido en la página 6

Resumen del contenido incluido en la página 7

Installing batteries in the remote 1. Remove the battery cover as shown in diagram #1 (right). 2. Install two AAA batteries as shown in diagram #2 (right). •Observe the polarity markings on the inside of the battery compartment 3. Replace the battery cover. Using the remote Basic operation • The supplied batteries are for operational checks, and may not last as long as After you have acti- alkaline batteries. vated your SIRIUS subscription, the • If the remote-controllable distance begins to

Resumen del contenido incluido en la página 8

Resumen del contenido incluido en la página 9

Resumen del contenido incluido en la página 10

Resumen del contenido incluido en la página 11

Resumen del contenido incluido en la página 12

Resumen del contenido incluido en la página 13

Troubleshooting guide Problem Possible Cause Solution No power on DT-7000S (display not illuminated) Power cord is not properly connected Make sure the power cord is properly connected Audio and/or digital cable is not properly connected Make sure cable is properly connected No sound Incorrect input selected on receiver/controller Select the receiver/controller input that the DT-7000S is connected to Check the Antenna Signal screen (see page 12); Signal is weak or can’t be found Change the ant

Resumen del contenido incluido en la página 14

14 DT-7000S Instruction Manual

Resumen del contenido incluido en la página 15

15 DT-7000S Instruction Manual

Resumen del contenido incluido en la página 16