Manual de instrucciones de Extron electronic TP Receiver

Resumen del contenido incluido en la página 1

L R
L R
Setup Guide — TP Receivers
This card provides instructions for an experienced
installer to set up and operate the TP Receiver Series
products.
Refer to www.extron.com for the complete user’s
manual.
Pre-installation — Jumper settings
J3 RGB
The TP R BNC A and TP R BNC AV are factory configured to receive 3
2
RGB video. They can receive component, S-video or composite video
1
by changing jumper J3 located on the main board.
J3
If using the TP R BNC AV with an older TPX 88X transm

Resumen del contenido incluido en la página 2

AUDIO COMPUTER BUFFERED H-SHIFT INPUT LOCAL MONITOR TP T 15HD A Setup Guide — TP Receivers, cont’d Step 4 — Power TP R 15HD A TP R BNC A Plug the included external power supply into the 2-pole (TP R 15HD A) or 3-pole Smooth Ridges (TP R BNC A) captive screw connector. Wire the connector as shown and plug it into the (5 mm) SECTION A–A 3/16” receiver. The front panel Power LED is amber Max. Power Supply when power is present and green when signal Output Cord and power are present. Step