Resumen del contenido incluido en la página 1
SR Series Equalizers
• SR 231QX
• SR 430QX
• SR 431QX
• SR 830QX
• SR 831QX
A Harman International Company
Owner’s Manual
Resumen del contenido incluido en la página 2
Warning For your protection, please read the following: Water and Moisture: Appliances should not be used near water (e.g. near a bathtub, washbowl, kitchen sink, laundry tub, in a wet basement, or near a swimming pool, etc.) Care should be taken so that objects do not fall and liquids are not spilled into the enclosure through openings. These symbols are internationally accepted symbols that warn of potential Power Sources: The appliance should be connected to a power hazards with electrical pr
Resumen del contenido incluido en la página 3
SR Series EQ’s 1 The symbols shown above are internationally accepted symbols that warn of potential hazards with electrical products. The lightning flash with arrowpoint in an equilateral triangle means that there are dangerous voltages present with- in the unit. The exclamation point in an equilateral triangle indicates that it is necessary for the user to refer to the owner’s manual. These symbols warn that there are no user serviceable parts inside the unit. Do not open the unit. Do not atte
Resumen del contenido incluido en la página 4
SR Series EQ’s • The core which is colored blue must be connected to the terminal 2 marked N or colored black. • The core which is colored brown must be connected to the terminal marked L or colored red. These units comply with the European “EMC Directive” for emissions and sus- ceptibility. The power cord is terminated in a CEE7/7 plug (Continental Europe). The green/yellow wire is connected directly to the unit's chassis. If you need to change the plug, and if you are qualified to do so, refer
Resumen del contenido incluido en la página 5
SR Series EQ’s INTRODUCTION 3 Congratulations, and thank you for your purchase of DOD equalization compo- nents. DOD equalizers are versatile, cost-effective equalization tools for the musician, performer, studio engineer, and sound contractor. Each equalizer allows the user to see a graphic representation of the equalization applied to the audio spectrum, and offers the flexibility to provide solutions to many EQ problems. The units offer up to 12 dB of cut or boost per band with a switchable l
Resumen del contenido incluido en la página 6
SR Series EQ’s DOD graphic equalizers offer both 1/3rd and 2/3rds octave models in stereo and 4 1/3 octave models in mono to meet any need. INSTALLATION Install the equalizer in a rack with the provided rack screws. Route the AC power cord to a convenient power outlet away from audio lines. The unit may be turned on and off using the front panel power switch. Since the units draw a relatively small amount of current during idle, they can be left on continuously. DOD equalizers generate very litt
Resumen del contenido incluido en la página 7
SR Series EQ’s APPLICATIONS 5 DOD graphic equalizers can be used wherever modification of the frequency contour of a sound or sound system is needed. A graphic equalizer offers a solution to many common sound problems, both large and small. Also, creative experimentation on the part of the user can produce some nice results. SOUND REINFORCEMENT APPLICATIONS By routing the signal from the mixer to the SR Equalizer, and then to the main power amplifiers (or crossover), the overall frequency of the
Resumen del contenido incluido en la página 8
SR Series EQ’s MUSICAL INSTRUMENT APPLICATIONS 6 A. Putting an equalizer in line with a musical instrument allows you to modify the sound of the instrument. You can brighten the sound, add body to a thin sounding instrument, or you can give the sound a totally different character. B. An equalizer allows you to eliminate unwanted sounds, such as the 60 cycle hum from a badly grounded sound source. STUDIO APPLICATIONS A graphic equalizer is one of the most useful tools in the sound engineer's bag.
Resumen del contenido incluido en la página 9
SR Series EQ’s OPERATION 7 FRONT PANEL FUNCTIONS DESCRIPTION POWER SWITCH: Turns the power to the equalizer on or off. EQUALIZER SLIDERS: Each one of these linear potentiometers will boost or cut its noted frequency by +/- 12 dB. When all the sliders are in the center detented position, the output of the equalizer is said to be flat. The numbers marked over the top of each slider represent the center frequency that each band will control. INPUT LEVEL CONTROL: This control sets the signal level t
Resumen del contenido incluido en la página 10
SR Series EQ’s ATTENTION: DO NOT USE BOTH THE BALANCED AND UNBALANCED 8 INPUT/OUTPUT JACKS TO A CHANNEL AT THE SAME TIME. Using more than one connector at a time for the input/output pair can unbalance balanced lines, cause phase cancellation, short a conductor to ground, or cause damage to other equipment connected to the equalizer. Maintenance and service Other than keeping the unit clean and occasionally checking the connectors and cables to the unit for integrity, there is no maintenance nec
Resumen del contenido incluido en la página 11
SR Series EQ’s DOD WARRANTY 9 1. The warranty registration card must be mailed within ten days after purchase date to validate this warranty. 2. DOD warrants this product, when used solely within the U.S., to be free from defects in material and workmanship under normal use and service. 3. DOD Electronics liability under this warranty is limited to repairing or replac- ing defective materials that show evidence of defect, provided the product is returned through the original dealer, where all pa
Resumen del contenido incluido en la página 12
SR Series EQ’s 10 SR 430QX SR 431QX SR 830QX SR 831QX SR 231QX
Resumen del contenido incluido en la página 13
DECLARATION OF CONFORMITY Manufacturer’s Name: DOD Electronics Corporation Manufacturer’s Address: 8760 S. Sandy Parkway Sandy, Utah 84070, USA declares that the products: Product Name: SR Series Equalizers Product Options: All conform to the following product specifications: Safety: EN 60065 (1993) IEC65 (1985) with Amendments 1,2,3 EMC: EN 55013 (1990) EN 55020 (1991) Supplementary Information: The products herewith comply with the requirements of the Low Voltage Directive 73/23/EEC a
Resumen del contenido incluido en la página 14
VISIT DOD ELECTRONICS ON THE WORLD WIDE WEB AT HTTP://WWW.DOD.COM DOD ELECTRONICS CORPORATION 8760 SOUTH SANDY PARKWAY SANDY,UTAH 84070 TELEPHONE 801-566-8800 FAX 801-566-7005 INTERNATIONAL DISTRIBUTION 8760 SOUTH SANDY PARKWAY SANDY,UTAH 84070 TELEPHONE 801-568-7638 FAX 801-568-7642 DOD IS A REGISTERED TRADEMARK OF HARMAN MUSIC GROUP INC. © 1998 DOD ELECTRONICS CORPORATION DOD 18-2160-C
