Resumen del contenido incluido en la página 1
RX-495RDS/395/395RDS
Natural Sound Stereo Receiver
Récepteur stéréo “Son Naturel”
Natural Sound Stereoreceiver
Natural Sound Stereoreceiver
Sintonizzatore stereo a suono naturale
Receptor estéreo de Sonido Natural
Natural Sound Stereo Ontvanger
OWNER’S MANUAL
MODE D’EMPLOI
BEDIENUNGSANLEITUNG
BRUKSANVISNING
MANUALE DI ISTRUZIONI
MANUAL DE INSTRUCCIONES
GEBRUIKSAANWIJZING
Resumen del contenido incluido en la página 2
l SUPPLIED ACCESSORIES After unpacking, check that the following parts are included. l ACCESSOIRES FOURNIS Après le déballage, vérifier que les pièces suivantes sont incluses. l MITGELIEFERTE ZUBEHÖRTEILE Nach dem Auspacken überprüfen, ob die folgenden Teile vorhanden sind. l MEDFÖLJANDE TILLBEHÖR Kontrollera efter det apparaten packats upp att följande delar finns med. l ACCESSORI IN DOTAZIONE Verificare che tutte le parti seguenti siano contenute nell’imballaggio dell’apparecchio. l ACCESORIOS
Resumen del contenido incluido en la página 3
English Thank you for selecting this YAMAHA stereo receiver. FEATURES l l RX-495RDS Preset Station Shifting Capability (Preset 70W + 70W (8Ω) RMS Output Editing) Power, 0.04% THD, 20–20,000 Hz l IF Count Direct PLL Synthesizer Tuning RX-395, RX-395RDS System 45W + 45W (8Ω) RMS Output l SLEEP Timer Power, 0.04% THD, 20–20,000 Hz l Remote Control Capability l High Dynamic Power, Low Impedance Drive Capability l RX-495RDS and RX-395RDS only Multi-Functions for RDS Broadcast l Continuously Variable
Resumen del contenido incluido en la página 4
CAUTION : READ THIS BEFORE OPERATING YOUR UNIT. 1. To assure the finest performance, please read this manual For U.K. customers carefully. Keep it in a safe place for future reference. If the socket outlets in the home are not suitable for the plug supplied with this appliance, it should be cut off and an 2. Install this unit in a cool, dry, clean place – away from appropriate 3 pin plug fitted. For details, refer to the windows, heat sources, sources of excessive vibration, instructions descri
Resumen del contenido incluido en la página 5
English CONTROLS AND THEIR FUNCTIONS REMOTE CONTROL TRANSMITTER The remote control transmitter provided with this unit is designed to control all the most commonly used functions of the unit. If the CD player and tape deck connected to this unit are YAMAHA components designed for remote control compatibility, then this remote control transmitter will also control various functions of each component. For Control of This Unit 1 Tuner keys 5 Controls tuner. +: Selects higher preset station number.
Resumen del contenido incluido en la página 6
FRONT PANEL RX-495RDS 13245 6789 0 A NATURAL SOUND STEREO RECEIVER TUNER CD PURE DIRECT POWER MONITOR TAPE 2 TAPE 1 AUX PHONO PRESET STEREO AM MHz FM 0 20 l00 MEMORY ENTER TAPE MONITOR 12 AUTO TUNING SLEEP COPY PRESET STATIONS A/B/C/D/E 1 2 3 4 VOLUME RDS MODE/FREQ PTY SEEK EON TUNING MODE FM/AM DOWN TUNING UP EDIT MEMORY l6 l8 l4 20 l2 57 6 8 24 l0 MODE START AUTO/MAN'L MONO MAN'L/AUTO FM 28 8 34 6 40 4 BASS TREBLE BALANCE LOUDNESS 0 0 0 FLAT 50 3 PHONES SPEAKERS l l l l l l l -30dB A B 2 2
Resumen del contenido incluido en la página 7
English 1 POWER switch C SPEAKERS switches Press this switch to switch the power on. Press it again to Set the switch A or B (or both A and B) for the speaker system switch the power off. (connected to this unit) you will use to the ON position. Set the * Standby mode switch for the speaker system you will not use to the OFF While the power is on, pressing the POWER key on the position. remote control transmitter switches the unit to the standby mode. (In this mode, the power indicator is half
Resumen del contenido incluido en la página 8
DISPLAY PANEL RX-495RDS, RX-395RDS 1324 AUTO STEREO MHz 0 20 l00 MEMO PS PTY RT CT PTY HOLD EON NEWS INFO AFFAIRS SPORT SLEEP 56 78 9 0 A RX-395RDS RX-495RDS TAPE MON TAPE MON 1 2 RX-395 13 4 PRESET STEREO FM MHz 0 20 40 60 l00 AUTO TUNING SLEEP MEMORY TAPE MONITOR 50 A 2 8
Resumen del contenido incluido en la página 9
English 1 Multi-information display 7 PTY HOLD indicator Displays various information, for example station frequency, RX-495RDS and RX-395RDS only preset station number and name of selected program source. Lights up while the search is performed in the PTY SEEK mode. 2 AUTO (AUTO TUNING) indicator This indicator lights up when this unit is in the automatic tuning 8 EON indicator mode. RX-495RDS and RX-395RDS only Lights up when an RDS station that employs the EON data 3 STEREO indicator servic
Resumen del contenido incluido en la página 10
CONNECTIONS Before attempting to make any connections to or from this unit, be sure to first switch OFF the power to this unit and to any other components to which connections are being made. CONNECTIONS WITH OTHER COMPONENTS When making connections between this unit and other components, be sure all connections are made correctly, that is to say L (left) to L, R (right) to R, “+” to “+” and “–” to “–”. Also, refer to the owner’s manual for each component to be connected to this unit. If you ha
Resumen del contenido incluido en la página 11
English RX-395, RX-395RDS Turntable Tape deck Speakers A Right Left (Europe model) GND FM 75Ω ANT UNBAL. SPEAKERS AC OUTLETS MAINS GND AM ANT A 3 5 4 6 or or TAPE REC PB OUT B l00W MAX. TOTAL PHONO CD 1 AUX TAPE A OR B : 8ΩMIN./SPEAKER A B : l6ΩMIN./SPEAKER SWITCHED To AC outlet Right Left Compact disc player Video cassette player, Speakers B LD player, etc. : Refer to “ABOUT THE ACCESSORY TERMINALS” on page 12. 11 OUTPUT GND OUTPUT LINE OUT LINE IN AUDIO OUT
Resumen del contenido incluido en la página 12
CONNECTING SPEAKERS Notes l Connect the SPEAKERS terminals to your speakers with wire One or two speaker systems can be connected to this unit. of the proper gauge, cut as short as possible. If the If you connect only one speaker system, connect it to either connections are faulty, no sound will be heard from the the SPEAKERS A or B terminals. l speakers. Make sure that the polarity of the speaker wires is Use speakers with the specified impedance shown on the correct, that is, + and – marking
Resumen del contenido incluido en la página 13
English ANTENNA CONNECTIONS l Each antenna should be connected to the designated terminals correctly, referring to the following diagram. l Both AM and FM indoor antennas are included with this unit. In general, these antennas will probably provide sufficient signal strength. Nevertheless, a properly installed outdoor antenna will give clearer reception than an indoor one. If you experience poor reception quality, an outdoor antenna may result in improvement. Outdoor FM antenna Indoor FM Outdo
Resumen del contenido incluido en la página 14
BASIC OPERATIONS 1, 6 2 3 7 4 TO PLAY A SOURCE 1 4 Select the speakers to be used. SPEAKERS A B ON ON OFF OFF * If you use two speaker systems, press both the A and Set to the “ ” position. ∞ B switches. 5 Play the source. (For detailed information on the 2 Turn the power on. POWER tuning operation, refer to page 17.) 6 3 Select the desired input source by using the input selector buttons. RX-495RDS Adjust to the desired output level. TUNER CD MONITOR 7 If desired, adjust the BASS, TREBLE, BAL
Resumen del contenido incluido en la página 15
English TO RECORD A SOURCE TO TAPE 1, 4 2 RX-495RDS RX-395, RX-395RDS 1 Select the source to be recorded. 1 Select the source to be recorded. TUNER CD TUNER CD MONITOR TAPE TAPE 2 TAPE 1 AUX PHONO MONITOR AUX PHONO COPY * To dub from tape to tape, refer to the “Notes” shown * When you select AUX, TUNER, CD or PHONO, make below. sure that TAPE MONITOR is not also selected. * When you select AUX, TUNER, CD or PHONO, make sure that neither TAPE 1 nor TAPE 2 is also selected. 2 Play the source and t
Resumen del contenido incluido en la página 16
Selecting the SPEAKER system Using the PURE DIRECT switch RX-495RDS only Because one or two speaker systems can be connected to this You can enjoy the purest possible sound from your audio unit, the SPEAKERS switches allow you to select speaker sources by pressing this switch inward. By doing so, the audio system A or B, or both at once. signal bypasses the BASS, TREBLE, BALANCE and LOUDNESS controls, eliminating any alterations to the audio SPEAKERS signal. A B ON ON PURE DIRECT OFF OFF Adjus
Resumen del contenido incluido en la página 17
English TUNING OPERATIONS Normally, if station signals are strong and there is no interference, quick automatic-search tuning (AUTOMATIC TUNING) is possible. However, if signals of the station you want to select are weak, you must tune to it manually (MANUAL TUNING). 2 1 3 AUTOMATIC TUNING MANUAL TUNING 1 Select the reception band (FM or AM) confirming it on 1 Select the reception band (FM or AM) confirming it on the display. the display. FM/AM FM/AM FM or AM FM or AM 2 2 TUNING MODE TUNING MO
Resumen del contenido incluido en la página 18
PRESET TUNING MANUAL PRESET TUNING This unit can store station frequencies (selected by tuning operation) by using the PRESET STATIONS buttons. With this function, you can recall any desired station by only pressing the corresponding PRESET STATIONS button. Up to 40 stations (8 stations x 5 groups) can be stored. 2 4 3 To store stations 1 Tune to a desired station. 4 Select a preset station number where you want to (Refer to the previous page for tuning procedure.) program the station before “
Resumen del contenido incluido en la página 19
English 1 2 To recall a preset station Notes 1 Select the group of preset stations. l A new setting can be programmed in place of the former one. l For presets, the setting of the reception mode (stereo or A/B/C/D/E monaural) is stored along with the station frequency. Memory back-up The memory back-up circuit prevents the programmed data from being lost even if the POWER switch is set off or the power plug is disconnected from the AC outlet or the power is cut due to temporary power failure. I
Resumen del contenido incluido en la página 20
AUTOMATIC PRESET TUNING You can also make use of an automatic preset tuning function for FM stations only. By this function, this unit performs automatic tuning and stores FM stations with strong signals sequentially. Up to 40 stations are stored automatically in the same way as in the manual preset tuning method on page 18. * RX-495RDS and RX-395RDS only Only RDS stations can be stored by this function. 1 2 To store stations When the automatic preset tuning is finished FM/AM The display shows
