Resumen del contenido incluido en la página 1
M2080 English 08/04/00 7:51 AM Page 1
R
Installation and
Operations Manual
TUNE
POWER AM/FM FF/EJ
Auto Stop Cassette
STEREO
VOL BAL TONE
FM 88 92 96 100 106 108 MHz
AM 5 6 7 10 14 16 x100 KHz
TAPE
MIN MAX L R L H
M2080 AM/FM Stereo Receiver and
Auto Stop Cassette Deck
© Copyright 1996
Magnadyne Corporation
Resumen del contenido incluido en la página 2
M2080 English 08/04/00 7:51 AM Page 2 Introduction Congratulations on your purchase of the Magnadyne M2080. Please read all of the information in this booklet before This unit is a precision AM/FM/MPX receiver, and high using this unit to insure that you fully understand the fidelity stereo cassette player. This innovative system has capabilities of this unit. been designed for in-dash installation, and can be installed in all automotive, motorcycle and marine applications. ONE (1) YEAR LIMIT
Resumen del contenido incluido en la página 3
M2080 English 08/04/00 7:51 AM Page 3 Controls and Operation 1 2 345 TUNE POWER AM/FM FF/EJ Auto Stop Cassette STEREO VOL BAL TONE FM 88 92 96 100 106 108 MHz AM 5 6 7 10 14 16 x100 KHz TAPE MIN MAX L R L H 69 7 8 1. Radio Tuning Knob 4. Fast Forward/Eject Button 7. Balance Control Knob 2. Power On/Off Button 5. Tape Cartridge Door 8. Tone Control Knob 3. AM/FM Band Button 6. Volume Control Knob 9
Resumen del contenido incluido en la página 4
M2080 English 08/04/00 7:51 AM Page 4 Controls and Operation 1. Radio Tuning Knob 7. Balance Control Knob Rotate the radio tuning knob in either direction to select the Rotate the balance control from left to right to achieve the correct desired AM or FM station. speaker balance. This control will balance two speakers from left to right. You will feel a “click” at the center point in the controls 2. Power On/Off Button rotation, this is the controls mechanical center. Press the Power button
Resumen del contenido incluido en la página 5
BAL TONE FM 88 92 96 100 106 108 MHz 10 14 16 x100 KHz MIN MAX L RL M2080 English 08/04/00 7:51 AM Page 5 Controls and Operation Radio Operation Antenna Trimmer Adjustment 1. To turn on the unit, push in the power button. The trimmer is factory adjusted. However, it may require 2. Select either AM or FM radio by using the AM/FM band button. readjustment depending on the type of antenna which is 3. Use the radio tuning knob to select t
Resumen del contenido incluido en la página 6
M2080 English 08/04/00 7:51 AM Page 6 Installation Dashboard Sheet Rear Support Strap Metal Screw Nut Washer Figure 1 Mounting Sleeve 6
Resumen del contenido incluido en la página 7
M2080 English 08/04/00 7:52 AM Page 7 Installation 1 2 Release the Remove the rear support end caps. strap 3 4 Insert the keys on the right and Slide the keys up left side. at an angle. Slowly pull the keys out approximately 5 6 3/8”. This presses the two stoppers Slide the unit from the down and releases the unit. metal housing. Stopper 7 TUNE POWER AM/FM EJECT Auto Stop Cassette VOL BAL TONE STEREO FM 88 92 96 100 106 108 MHz AM
Resumen del contenido incluido en la página 8
M2080 English 08/04/00 7:52 AM Page 8 Installation Space Requirements: Step 4: To mount your new Magnadyne unit, you will need a rectangle hole Securely attach the rear support strap provided to the rear of the 1 in the mounting location 183mm (width) x 53mm (height), (7 ⁄8” x unit with the fasteners provided. Bend the strap to allow the unit to 1 2 ⁄8”) and a full 7” of unobstructed space behind the mounting slide into it’s mounting sleeve. Reach up behind the unit and grab location. the str
Resumen del contenido incluido en la página 9
- + - + M2080 English 08/04/00 7:52 AM Page 9 Electrical Connections Two Speaker Wiring Left Speaker Green Wire 9-Pin Plug From Radio Chasis Ground Black Wire 3A Red Wire Gray Wire Connect to Ignition 12V Right Speaker This unit if for use only with a 12 volt DC power source with a Two Speaker System negative ground. To obtain the best sound system, make sure that the corresponding If your vehicle is equipped with an antenna, connect the lead from terminals of each speak
Resumen del contenido incluido en la página 10
M2080 English 08/04/00 7:52 AM Page 10 Cautions and Maintenance The tape head should be cleaned regularly, especially when the Fuse Replacement playback sound begins to deteriorate. Insert a special head cleaning Replace the fuse with only the specified size indicated below. cassette into the tape mechanism and allow it to run for a few minutes. Fuse for main power wire (Red wire) 3.0 Amp If you are playing pre-recorded tape, your tape head should be cleaned every 10-15 hours of playing time.
Resumen del contenido incluido en la página 11
M2080 English 08/04/00 7:52 AM Page 11 Specifications Tape Section Play System . . . . . . . . . . . . . 4-Track, 2 Channel Stereo Tape Speed . . . . . . . . . . . . . 4.75cm/sec. (1 7/8 ips.) +3. -1% Wow and Flutter . . . . . . . . . 0.3% WRMS Maximum S/N Ratio . . . . . . . . . . . . . . . More than 40dB Frequency Response . . . . . 60-10kHz FM Receiver Tuning Range . . . . . . . . . . . 88-108mHz I.F. . . . . . . . . . . . . . . . . . . . . 10.7mHz Sensitivity . . . . . . . . . . . . . . .
Resumen del contenido incluido en la página 12
M2080 English 08/04/00 7:52 AM Page 12
