Manual de instrucciones de PYLE Audio PT-2001X

Resumen del contenido incluido en la página 1

Please complete warranty card, detach and return
Thank you for purchasing this PYLE
product. To activate your
warranty registration card
warranty, please mail this card
within 10 days.
PYLE PRO AMPLIFIERS
Name
Address
City, State ZIP
Model No. Serial # (if available)
Date of Purchase
Purchased at:
Music Products Store Sound Contractor/Installer Mail Order
Catalog Merchandiser Other
PT-1201X Amplifier
PT-1601X Amplifier
PT-2001X Amplifier
Limited Warranty
All

Resumen del contenido incluido en la página 2

FEATURES AND CONTROLS Channel 1 and Channel 2 Power LED Display TABLE OF CONTENTS Your New Pyle Pro PT series PA Indicate the output signal level for each channel. FRONT PANEL, PT-1601X/2001X 1 Features and Controls, PT-1201X/1601X and PT-2001X/4001X Amplifier gives you the power and 3 Installation Guidelines versatility you need in a professional 3 Input Connections 3 Connecting a CD, DVD or tape player or tuner sound system. 3 Connecting an equalizer or signal processor The amplifier's wide f

Resumen del contenido incluido en la página 3

REAR PANEL, PT-1201X INSTALLATION GUIDELINES Connecting the GND (GROUND) screw terminal Connecting a mixer or preamplifier may cause excessive noise or hum in the amplifier output. To prevent this, connect one end of a low-capacitance shield wire to the amplifier's ground screw (on the rear panel). Then connect the other end of this wire to the ground terminal on the mixer or preamplifier enclosure. CD PLAYER, DVD , TAPE PLAYER OR TUNER use RCA jacks Stereo/Mono Switch Input Jacks Lets you selec

Resumen del contenido incluido en la página 4

STEREO OPERATION Bridged Mode Operation MONO OPERATION This amplifier can operate in a mono bridged output mode, if SWITCH IN “STEREO” POSITION SWITCH IN “MONO” POSITION your speakers can handle the following power output levels: As shown in the diagram below, connect the speaker's positive (+) to the amplifier's red speakers left (1/2) terminals and negative (-) to red speakers right (1/2) terminals. CH 2 CH 1 use XLR/6.35 mm CH 2 CH 1 EQ OR MIXER The speaker right (+) on the amplifier is used

Resumen del contenido incluido en la página 5

Connecting to standard AC power Using the Channel 1 and Channel 2 Output Level controls Amplifier Specifications PT-1201X PT-1601X PT-2001X PT-4001X After making all other connections, set the POWER switch Rotate output level gain clockwise to increase, or counter- to OFF position. Then connect the power cord to a standard Input Impedance, balanced (unbalanced) 20 k-Ohms (10 k-Ohms) 20 k-Ohms (10 k-Ohms) 20 k-Ohms (10 k-Ohms) 20 k-Ohms (10 k-Ohms) clockwise to decrease the output power. To get t