Manual de instrucciones de Extron electronic sRGB 580XI

Resumen del contenido incluido en la página 1

L R
L R
Setup Guide — RGB 580xi
This guide provides basic instructions for an experienced
installer to set up and operate the Extron RGB 580xi.
Installation
Refer to the RGB 580xi User’s Manual for details.
Installation and service must be performed by authorized personnel only.
C
Step 1 — Powering down
Turn off or disconnect all equipment from power sources.
Step 2 — Mounting
Mount the interface as desired.
6
10
1 5
Step 3 — Video input
Connect an RGBHV, RGBS, RGsB, or RsGsBs analog video in

Resumen del contenido incluido en la página 2

CONTROL E A B C D Setup Guide — RGB 580xi Step 7 — Contact closure For contact closure, connect an optional contact closure device to the front panel 5-pin, captive screw connector. Making contact closure between pins A and B transmits a channel signal through the rear panel RS-232 port. The RGB 580xi SI/CCSI AAP models provide one-button contact closure operation. Wire the male connector as shown below on the left. The Extron VGA and control cable assembly comes with the male control c

Resumen del contenido incluido en la página 3

RS-232 Tx Rx 3 — SOG (sync on green) On — The interface outputs sync on green. Off — The interface outputs separate horizontal and vertical sync (on the H and V connectors) for RGBHV. 4 — V-Sync Width (vertical sync pulse width) — For some digital display devices, if no picture appears, the picture cuts in and out, or the picture is scrambled, try adjusting the output vertical sync pulse width or switching from ADSP to DDSP. On — The vertical sync p

Resumen del contenido incluido en la página 4

Setup Guide — RGB 580xi • At the minimum level setting (the counter clockwise limit of this contr ol), the interface outputs video at 0.5 volts p-p. • Unity level is 0.7 volts p-p, the same as the input signal. Set the contr ol to approximately one-half turn between the minimum and maximum level settings to output unity level video. • At the maximum level setting (the clockwise limit of this contr ol), the interface outputs video at 1.4