Manual de instrucciones de RBH Sound TWO-WAY INDOOR/OUTDOOR A-5AW

Resumen del contenido incluido en la página 1

MC-6AW / A-5AW
Two-way Indoor/Outdoor Speakers
Installation and Operation Manual

Resumen del contenido incluido en la página 2

Introduction Congratulations on your purchase of RBH Sound MC-6AW or A-5AW indoor/outdoor speakers! These speakers are the result of many years of research and development dedicated to producing high quality products for home audio and audio/video systems. This manual contains features, setup recommendations and specifications for the RBH Sound MC-6AW and A-5AW indoor/outdoor speakers. It is recommended you thoroughly read through the material contained in this manual before connecting your

Resumen del contenido incluido en la página 3

Features The cabinet of the MC-6AW and A-5AW is constructed of dense acoustically inert impact resistant polypropylene resin, sealed to provide protection from the natural elements of the weather. The rounded back allows for easy placement into a corner. All hardware parts are made from brass, aluminum or stainless steel and the binding posts are plastic to avoid rusting or corrosion. For high frequencies, the MC-6AW uses a 1-inch high performance aluminum dome tweeter and the A-5AW feature

Resumen del contenido incluido en la página 4

Speaker Placement Installation The bracket has the ability to be mounted a variety of different ways. It may be mounted with either nails or screws, horizontally or vertically. There is a hole in the center of the bracket to allow speaker wire through so it may be properly attached to the speaker. The cabinet back has a female M6x1.0mm thread for an optional swivel bracket mount. If working properly, insert the knob covers to complete the installation. Mounting and Connections For the followi

Resumen del contenido incluido en la página 5

Installation (continued) 5. Use the bracket knobs to attach the speaker to the bracket, being careful to not tighten the knobs until the desired location is attained; this will allow the speaker to be angled slightly so the rear binding posts are accessible. 6. Connect one wire to the black terminal and one to the red terminal, paying close attention to the markings on the wire for proper polarity. Each speaker must be connected to the amplifier in the same way. NOTE: Before proceeding, if

Resumen del contenido incluido en la página 6

Troubleshooting Situation: Probable Cause: Solution: No sound from speakers. Speaker wire not connected. Make sure wire is connected at both the speaker and the Speaker selector on amplifier amplifier observing proper is not on. polarity. Activate proper selector on amplifier. No sound from one Balance control on receiver Place balance control speaker. or pre-amp is not centered. in the center. Speaker wire not securely Check all connections at connected. amplifier and speaker

Resumen del contenido incluido en la página 7

Warranty Your RBH Sound MC-6AW or A-5AW indoor/outdoor speaker is covered by a limited warranty against defects in materials and workmanship for a period of 5 (five) years from the original date of purchase. This warranty is provided by the authorized RBH Sound dealer where the speakers were purchased. Warranty repair will be performed only when your purchase receipt is presented as proof of ownership and date of purchase. Defective parts will be repaired or replaced without charge by your

Resumen del contenido incluido en la página 8

TM Redefining The Way You Experience Sound. 382 Marshall Way, Layton, Utah • USA • 84041 Toll Free: (800) 543-2205 • Fax: (801) 543-3300 www.rbhsound.com It is RBH Sound policy to continuously incorporate improvements into products; all specifications are subject to change without notice. Copyright © 2008-2009 RBH Sound. All Rights Reserved.