Resumen del contenido incluido en la página 1
OWNER’S
MANUAL
RM7200SYSTEM
RM3300SATELLITES
RM3600CENTER CHANNEL
RM7600SYSTEM
RM4300SATELLITES
RM4600CENTER CHANNEL
Resumen del contenido incluido en la página 2
GETTING STARTED Make certain your system contains all its parts: The complete RM7200 comes in ONE carton, containing the following items: Four (4) magnetically shielded micro-satellite speakers with integrated wall mount brackets One (1) magnetically shielded micro-center channel speaker with integrated wall mount bracket One (1) RM7200 8" Powered Subwoofer The complete RM7600 comes in TWO cartons. Carton 1 contains the following items: Four (4) magnetically shielded satellite speakers wit
Resumen del contenido incluido en la página 3
CONNECTING THE SPEAKERS TO YOUR SYSTEM (General Directions) We recommend using two-conductor 16 gauge or thicker speaker wire. Strip 1/2 inch (12.7mm) of insulation from each of the two conductors to expose the bare metal and twist each of the individual conductors into single unfrayed strands. Note that one of the terminals on the rear of each speaker is red (+) and the other is black (–). Make certain that you connect the wire from the red (+) terminal of your amplifier or receiver to the red
Resumen del contenido incluido en la página 4
RM7600 HOOKUP OPTIONS OPTION 1—SPEAKER WIRE HOOKUP, OUR FAVORITE HOOKUP METHOD (Figure 8): Using Speaker Wire, connect the left and right front speaker outputs of your receiver or amplifier to the “speaker level” (wire) inputs of the powered subwoofer. Then, connect the left and right front satellite speakers with speaker wire from the “speaker level” outputs of the powered subwoofer. Connect the Center Channel Speaker directly to the center channel output from your receiver. Connect the Re
Resumen del contenido incluido en la página 5
RM7200 POWERED SUBWOOFER ADJUSTMENTS (Figure 13) The RM7200 Powered Subwoofer offers a range of setting options. We recommend the following settings as starting points, but the settings that are best for you depend upon your speaker placement, electronics and personal taste. After you’ve become familiar with what the settings do, experiment with alternate options to find the method that works best for your system setup. You’ll find an informative article on “Subwoofer Positioning and Adjustment
Resumen del contenido incluido en la página 6
RM7600 POWERED SUBWOOFER ADJUSTMENTS (Figure 14) The RM7600 Powered Subwoofer offers a wide range of setting options. We recommend the following settings as starting points, but the settings that are best for you depend upon your speaker placement, electronics and personal taste. After you’ve become familiar with what the settings do, experiment with alternate options to find the method that works best for your system setup. Outside the US: These adjustments are specific to the Polk Audio PSW
Resumen del contenido incluido en la página 7
RM7600 +3dB BASS BOOST In most cases, this switch should be set to “0.” If you have hooked up the subwoofers from a subwoofer output or pre-out jacks and cannot get enough bass output even with the subwoofer level control turned all the way up, switch to the +3dB position. In typical systems where the 3dB boost is not needed, this switch can be useful for providing a quick boost for bass-shy program material. Most people prefer more bass output for movies than music so you can use this switch as
Resumen del contenido incluido en la página 8
Figure 1 OR Most popular placement, above the TV screen. RM7000 Series Center Channel Speakers can also be wall mounted. RM7000 Series Loudspeakers are magnetically shielded for safe placement near TV or video monitors. If you notice video distortion or discoloration, immediately move the speakers away from the video source and call Polk Audio Customer Service 800.377.7655 (US & Can) or polkcs@polkaudio.com. Esta es la ubicación más popular, sobre el televisor. Los altavoces de canal central d
Resumen del contenido incluido en la página 9
Figure 3a Figure 3b Placement options for rear/surround speakers. Opciones de ubicación de los altavoces surround o de atrás. Options de disposition des enceintes arrière- ambiophoniques. Platzierungsoptionen für hintere Lautsprecher bzw. Surround-Lautsprecher. Figure 4 Figure 5 NOT OK SUB TV 6" (15cm) AMPLIFIER AMPLIFICADOR AMPLIFICATEUR VERSTÄRKER Allow at least 6" (15cm) between sub driver and wall or obstruction. NEVER LAY THE SUBWOOFER ON ITS AMPLIFER END. Deje por lo menos 15 cm (6 plg.
Resumen del contenido incluido en la página 10
Figure 6 Using push tab connectors. Uso de conectores de plástico. Utilisation des bornes à languettes de plastique. Verwendung der Kunststoffanschlüsse. Figure 7 Using binding post connectors. Loosen hex nut. Insert speaker wire Tighten hex nut. Do not insert insulated section through hole. of speaker wire. Desentornille la tuerca Asegure la tuerca hexagonal. hexa-gonal. Insterte el cable conector del No inserte la sección aislada del Serrer l’écrou. altoparlante a traves del orificio. cable c
Resumen del contenido incluido en la página 11
Figure 9 Figure 10 CENTER CHANNEL FRONT AMP-IN PRE-AMP OR PROCESSOR FRONT PRE-OUT Use template to mark mounting location. Use la plantilla para marcar la ubicación de montaje. Y-CABLES Utilisez le gabarit pour marquer l’endroit de l’installation. Verwenden Sie die Schablone zur Markierung der Befestigungsstelle. Figure 12 SUBWOOFER Line Level Hookup method using pre-amp outs. Método de conexión usando cables con conectores RCA para salidas de preamplificador. Branchement aux sorties niveau de li
Resumen del contenido incluido en la página 12
Figure 13 Figure 14 ® the speaker specialists Rear of RM7200 Powered Subwoofer showing controls. Rear of PSW650 Subwoofer used with RM7600, showing controls. Parte de atrás del subwoofer de potencia RM7200. Se ven los controles. Parte de atrás del subwoofer PSW650 usado con el RM7600. Se ven los controles. Arrière et contrôles du subwoofer amplifié RM7200. Arrière et contrôles du subwoofer PSW650 utilisé avec le RM7600. Rückseite des Subwoofers (mit RM7200) mit Steuerungen. Rückseite des PSW65
Resumen del contenido incluido en la página 13
Figure 15a Figure 15b Figure 16 Recommended Variable Recommended Variable Crossover Crossover Setting for wall Setting for satellites on stands. mounted satellites. Ajuste recomendado del crossover Ajuste recomendado del crossover variable para satélites montados variable para satélites montados sobre pedestales. en la pared. Réglage recommandé du Réglage recommandé du sépara- séparateur de fréquences teur de fréquences lorsque les lorsque les satellites sont satellites sont installés au mur.
Resumen del contenido incluido en la página 14
14 Contact Polk Audio Customer Service 1-800-377-7655 (Outside US: 410-764-5266), polkcs@polkaudio.com SPECIFICATIONS RM3300 Satellite RM3600 Center RM7200 Subwoofer RM7200 System RM4300 Satellite RM4600 Center PSW650 Subwoofer RM7600 System (with PSW650 subwoofer. Specifications will vary depending on subwoofer model supplied.) Overall Freq Response 90Hz-23kHz 80Hz-23kHz 26Hz-200Hz 26Hz-23kHz 65Hz-26kHz 55Hz-26kHz 25 - 180Hz 25Hz-26kHz -3dB Limits 125Hz-20kHz 115Hz-20kHz 32Hz-180Hz 32Hz-20k
Resumen del contenido incluido en la página 15
POLK AUDIO LIMITED WARRANTY Warranty for Satellites and charge, except as set forth below. All replaced parts and Products Center Channel Loudspeakers become the property of Polk Audio. Products replaced or repaired Polk Audio, Inc. warrants to the original purchaser only that this Polk under this warranty will be returned to you, within a reasonable time, Audio Loudspeaker Product (the “Product”) will be free from defects freight prepaid. in materials and workmanship for a period of five (5) ye
Resumen del contenido incluido en la página 16
Polk Audio 5601 Metro Drive Baltimore, Maryland 21215 800-377-7655 RM7208-1
