Manual de instrucciones de SECO-LARM USA NVD Bullet Cameras EV-1626-NKGQ

Resumen del contenido incluido en la página 1

NVD Bullet Cameras
Installation Manual

3 Cameras in 1:

EV-1626-NKGQ (NTSC)
2.8~12mm
EV-1626-PKGQ (PAL)
EV-1626-NWGQ (NTSC)
6~50mm
EV-1626-PWGQ (PAL)

1
/ ” Sony Super HAD CCD OSD with service monitor port
3
12VDC/24VAC 600 TV lines

NVD Bullet Cameras have an ultra-low lux rating of 0.000006 allowing the
camera to see in almost total darkness.

Note: Products with model numbers that end with “Q” or that have a round green “Q” sticker are RoHS compliant.

Resumen del contenido incluido en la página 2

NVD Bullet Cameras Specifications: EV-1626-NKGQ (NTSC) EV-1626-NWGQ (NTSC) EV-1626-PKGQ (PAL EV-1626-PWGQ (PAL) Type IR LED Bullet Camera 1 CCD / ” SONY Super HAD CCD 3 Resolution 600 TV lines NTSC: 768x494 pixels Pickup Elements PAL: 752x582 pixels Video Output / Service Monitor Port Composite video 1.0Vp-p into 75Ω + test connection Video Output Format NTSC Lens (DC Auto Iris) 2.8~12mm 6~50mm Minimum Illumination 0.000006-lux (LEDs on) 0.05-lux (LEDs off) S/N Ratio

Resumen del contenido incluido en la página 3

NVD Bullet Cameras Overview: Connect service A. Camera monitor port connector B. Adjustable sunshield to service monitor port C. Mounting plate D. Camera base C F E. Hex screws F. M ounting screws D G. Focus H. Zoom E B I. Service cover J. Female BNC OSD joystick connector (video out) I, M Important: H K. DC jack J Do not cut DC jack (K) or A G female BNC connector (J) as L. DC plug with warranty will be voided. terminal block M. Service monitor p

Resumen del contenido incluido en la página 4

NVD Bullet Cameras Troubleshooting Check that the camera is powered up. Check that the power supply’s polarity is correct. The screen is blank. Check that the monitor is powered up. Check that the video cable connecting the camera to the monitor is connected properly. Clean the lens using a soft, clean cloth. The screen image is dim. Check that the light source is adequate. Adjust the monitor’s contrast knob. The screen image has poor contrast. Change the position of the c