Manual de instrucciones de Cisco Systems Cisco Mimo 4-Element Antenna AIRANT2566P4WR

Resumen del contenido incluido en la página 1

Cisco Aironet 2.4-GHz/5-GHz MIMO 4-Element
Patch Antenna (AIR-ANT2566P4W-R)
This document outlines the specifications for the Cisco Aironet 2.4-GHz/5-GHz MIMO 4-Element Patch
Antenna (AIR-ANT2566P4W-R) and provides instructions for mounting it. The antenna operates in both
the 2.4-GHz and 5-GHz frequency ranges and is designed for indoor and outdoor use.
The following information is provided in this document.
• Technical Specifications, page 2
� System Requirements, page 4
� Safety Precaut

Resumen del contenido incluido en la página 2

Technical Specifications Technical Specifications Table 1 AIR-ANT2566P4W-R 2.4-GHz/5-GHz MIMO 4-Element Patch Antenna Specifications Antenna type 4-element dual-band MIMO Operating frequency 2400 to 2484 MHz range 5150–5850 MHz VSWR 2:1 or less Gain 6 dBi in both bands Polarization Linear, vertical Azimuth Plane 3-dB 2.4 GHz band: 105° Beamwidth 5 GHz band: 125° Elevation Plane 3-dB 2.4 GHz band: 70° Beamwidth 5 GHz band: 60° Length 6.3 in. (16 cm) Width 11 in. (27.9 cm) Depth 1.2 in. (3.05

Resumen del contenido incluido en la página 3

Technical Specifications Table 1 AIR-ANT2566P4W-R 2.4-GHz/5-GHz MIMO 4-Element Patch Antenna Specifications Azimuth and Elevation Radiation Patterns Azimuth and Elevation Radiation Patterns Left Antenna - 2.4 GHz Band Left Antenna - 5 GHz Band Azimuth and Elevation Radiation Patterns Azimuth and Elevation Radiation Patterns Left Center Antenna - 2.4 GHz Band Left Center Antenna - 5 GHz Band Cisco Aironet 2.4-GHz/5-GHz MIMO 4-Element Patch Antenna (AIR-ANT2566P4W-R) 78-20578-01 3

Resumen del contenido incluido en la página 4

System Requirements Table 1 AIR-ANT2566P4W-R 2.4-GHz/5-GHz MIMO 4-Element Patch Antenna Specifications Azimuth and Elevation Radiation Patterns Azimuth and Elevation Radiation Patterns Right Antenna - 2.4 GHz Band Right Antenna - 5 GHz Band Azimuth and Elevation Radiation Patterns Azimuth and Elevation Radiation Patterns Right Center Antenna - 2.4 GHz Band Right Center Antenna -5 GHz Band System Requirements This antenna is designed for indoor and outdoor use with any Cisco Aironet access p

Resumen del contenido incluido en la página 5

Safety Precautions Safety Precautions Translated versions of the following safety warnings are provided in the Safety Warnings for Cisco Aironet Antennas, which is available at http://www.cisco.com. Warning Installation of this antenna near power lines is dangerous. For your safety, follow the installation directions. Each year hundreds of people are killed or injured when attempting to install an antenna. In many of these cases, the victim was aware of the danger of electrocution but did

Resumen del contenido incluido en la página 6

Installing the Antenna � Keep the antenna away from metal obstructions such as heating and air-conditioning ducts, large ceiling trusses, building superstructures, and major power cabling runs. If necessary, use a rigid conduit to lower the antenna away from these obstructions. � The density of the materials used in a building’s construction determines the number of walls the signal can pass through and still maintain adequate signal strength. Consider the following before choosing the l

Resumen del contenido incluido en la página 7

Installing the Antenna � A drill � A #29 (0.136-in. (s.45 mm)) drill bit (for drywall installation, other surfaces may require a different size). � A pencil � A small mallet or hammer Mounting on a Vertical Surface Follow these steps to mount your antenna on a vertical surface. This procedure describes mounting the antenna on a drywall surface. If you are mounting the antenna on any other type of surface, your procedure may vary slightly. Step 1 Determine the location where you will mount

Resumen del contenido incluido en la página 8

Installing the Antenna Suggested Cable Cisco recommends a high-quality, low-loss cable for use with the antenna. Note Coaxial cable loses efficiency as the frequency increases, resulting in signal loss. The cable should be kept as short as possible, because cable length also determines the amount of signal loss (the longer the run, the greater the loss). Obtaining Documentation and Submitting a Service Request For information on obtaining documentation, submitting a service request, and g